FP6600Q overview
FP6600Q is a component documented by Fitipower Integrated Te. The PDF description identifies it as "USB Dedicated Charging Port Controller for Fast Charging Protocol and QC 2.0/3.0." This guide condenses the most useful engineering information from the available PDF so that designers and sourcing teams can identify the checks that still need confirmation in the original document.
Datasheet snapshot
- Manufacturer: Fitipower Integrated Te...
- Part number: FP6600Q
- Category: Interface
- Datasheet length: 8 Pages
Key features noted in the PDF
- Support HiSilicon Fast Charging Protocol (FCP) for Output Voltage and Current Communication
- Support Qualcomm Quick ChargeTM 2.0/3.0
- Class A : 3.6V up to 12V Output Voltage
- Class B : 3.6V up to 20V Output Voltage
- Automatic Selection FCP and QC 2.0/3.0 Protocols
- Supports USB DCP Shorting D+ Line to D- Line per USB Battery Charging Specification, Revision 1.2
- Meets Chinese Telecommunication Industrial Standard YD/T 1591-2009
Applications listed in the PDF
- Wall-Adapter, Smart Phones, Tablets, Notebooks
- Mobile / Tablet Power Bank
- Car Charger
- USB Power Output Ports FP6600Q□ Package Type SO: SOP-8
- Power Dissipation @TA=25℃, (PD)
- Package Thermal Resistance, (θJA) (Note 2)
Specifications and operating details
The following points were extracted from the PDF text. Check the associated conditions, notes and limits in the complete document before using a value in a design.
- Note 2：θJA is measured at 25°C ambient with the component mounted on a high effective thermal conductivity test board of JEDEC-51-7.
- Recommended Operating Conditions Note 3：Over operating free-air temperature range (unless otherwise noted) 5 FP6600Q-Preliminary 0.1-AUG-2016 (VDD=5V, TA=25℃ and the recommended supply voltage range, unless otherwise specified.) Parameter.
- Quick Charge 2.0/3.0 Interface Power up D+/D- is supply 2.7V to Apple Device and then supply D+ short to D - into BC1.2.
- Set the output voltage level 5V.
- If D+ continuous above 0.325V and keep 1.25 seconds FP660 0Q can automatic choose into QC 2.0/3.0 or FCP operation mode.
- Each step D+ from 1V to 3V Pulse -width during 200us cause current sink 2uA by FBO.
- The maximum output sink current is 70uA for output voltage reach to 12V.
Topics covered by the datasheet
The document includes sections related to:
- Features
- Applications
- Electrical Characteristics
- Application Information
Engineering review checklist
- Check resistance value, tolerance, temperature coefficient and long-term stability over the operating range.
- Derate continuous power for ambient temperature and verify pulse or surge capability separately.
- Match the land pattern, termination finish and current-sense routing to the exact package option.
Always confirm values against the latest manufacturer-controlled datasheet, especially when qualifying a substitute or releasing a production BOM.
View the complete PDF and model record
Open the FP6600Q datasheet and model details to review the complete PDF, document pages and available product information.
Source attribution
Adapted from the PDF associated with this DigiCamel model page.
Source model URL: https://www.digicamel.com/product.php?slug=fp6600q-fitipower-integrated-te