FACESEALS overview
FACESEALS is a component documented by France Joint. The PDF description identifies it as "FLOATING SEALS." This guide condenses the most useful engineering information from the available PDF so that designers and sourcing teams can identify the checks that still need confirmation in the original document.
Datasheet snapshot
- Manufacturer: France Joint
- Part number: FACESEALS
- Category: IC
- Datasheet length: 20 Pages
Specifications and operating details
The following points were extracted from the PDF text. Check the associated conditions, notes and limits in the complete document before using a value in a design.
- The mating surface material of the friction ring is lapped to a width of approximately 2.5 mm.
- Resistance to chemicals Aliphatic hydrocarbons Mineral and vegetable oils and greases Fire-resistant fluids (HFA, HFB and HFC) Diluted acids, saline solutions and bases for operation at an average temperature Water and steam up to +150°C A.
- Chemical resistance Aliphatic hydrocarbons (propane, butane, petroleum, diesel fuel) Mineral oils and greases Fire-resistant fluids (HFA, HFB and HFC) Diluted acids, low-temperature alkaline and saline solutions Water (up to +100°C max) Co.
- The table below sets out the thermal resistance of seals according to their materials.
- VMQ NBR HNBR FKM Temperature (°C) -100 -50 0 50 100 150 200 250 300 350 /f_luids with our materials Operating temperature Under particular conditions with special materials Only applicable data with compatible Floating seals can be used at.
- Peripherical speed (m/s) Possible grease lubrication Installation dimension I to be adpated Example : for a diameter ØDa = 245,00 mm with a speed of 400 r.p.m, the peripheral speed is 5,13 m/s and installation dimension I is to be adapted.
- For standard applications using the BECA 830 profiles, a value of 3 mm (+/-0.5) must be taken into consideration for the installation dimension We recommend increasing the assembly dimension to prevent a load on the seal surfaces that is t.
Topics covered by the datasheet
The document includes sections related to:
- Contents
Engineering review checklist
- Verify forward current and voltage, optical bin, wavelength or color coordinates and viewing geometry.
- Derate light output and lifetime for junction temperature and the actual PCB thermal path.
- Confirm polarity, footprint, reflow profile and moisture-sensitivity handling before production.
Always confirm values against the latest manufacturer-controlled datasheet, especially when qualifying a substitute or releasing a production BOM.
View the complete PDF and model record
Open the FACESEALS datasheet and model details to review the complete PDF, document pages and available product information.
Source attribution
Adapted from the PDF associated with this DigiCamel model page.
Source model URL: https://www.digicamel.com/product.php?slug=faceseals-france-joint