F5104 overview
F5104 is a component documented by Integrated Technology F. The PDF description identifies it as "SAW Bandpass Filter 2004-11-01." This guide condenses the most useful engineering information from the available PDF so that designers and sourcing teams can identify the checks that still need confirmation in the original document.
Datasheet snapshot
- Manufacturer: Integrated Technology F...
- Part number: F5104
- Category: IC
- Datasheet length: 7 Pages
Specifications and operating details
The following points were extracted from the PDF text. Check the associated conditions, notes and limits in the complete document before using a value in a design.
- F5104 Specifications Fc = 510.0MHz Terminating source impedance : 50 Ω Terminating load impedance : 50 Ω Minimum Typical Maximum Center Frequency ( Fc ) MHz - 510.0 - Insertion Loss (Fc +/- 2.0 MHz) dB - 3.0 4.0 Amplitude Ripple (Fc +/- 2..
- 2) Electrical margin has been built into the design to accoun t for the variations due to temperature drift and manufacturing tolerances 3) All attenuation measurements are measured relative to insertion loss Rev.
- F5104 Matching Schematic ( Actual matching values may vary due to PCB layout and parasitics ) Input 50Ω Output 50Ω Marking Configuration ITF1) 51042) 1) Manufacturer name 2) Marking Number * Ink or Laser Marking available Rev.
- 000 000 MHz Input / Output Smith Charts CH1 S11 1 U FS CENTER 510 .
- Leader part and vacant position specification END START Tape Running Direction Vacant 150mm min.
- Component contained Vacant 150mm min.
- Top cover tape adhesion 1) pull off angle : 0~15° 2) speed : 300mm/min 3) force : 20~70g Rev.
Topics covered by the datasheet
The document includes sections related to:
- Features
Engineering review checklist
- Confirm the exact ordering code, package, pinout or terminal arrangement and document revision.
- Compare recommended operating conditions with absolute maximum ratings and retain adequate design margin.
- Validate electrical, thermal, mechanical and environmental behavior in the final application.
Always confirm values against the latest manufacturer-controlled datasheet, especially when qualifying a substitute or releasing a production BOM.
View the complete PDF and model record
Open the F5104 datasheet and model details to review the complete PDF, document pages and available product information.
Source attribution
Adapted from the PDF associated with this DigiCamel model page.
Source model URL: https://www.digicamel.com/product.php?slug=f5104-integrated-technology-f