DA16200MOD overview

DA16200MOD is a component documented by Renesas Technology Corp. The PDF description identifies it as "Ultra Low Power Wi-Fi Module 04-Jan-2023." This guide condenses the most useful engineering information from the available PDF so that designers and sourcing teams can identify the checks that still need confirmation in the original document.

Datasheet snapshot

  • Manufacturer: Renesas Technology Corp
  • Part number: DA16200MOD
  • Category: IC
  • Datasheet length: 62 Pages

Key features noted in the PDF

  • SPI compatible serial bus interface ○ Configurable SPI I/O modes: – Single I/O mode – Dual I/O mode – Quad I/O mode ○ JEDEC Standard: JESD216B ○ 24-bit and 32-bit addressing ○ Sup.
  • Compliance to the AMBA AHB bus specification, Rev 3.0 [6]
  • Direct code execution: directly addressable access without additional driver software
  • Supports single and incrementing burst transfer (SINGLE, INCR, INCR4, INCR8, INCR16)
  • Supports byte, half-word, and word transaction
  • AMBA slave interface is optional to access configuration and status registers
  • Simple timer is used to check the completion time of flash operation

Specifications and operating details

The following points were extracted from the PDF text. Check the associated conditions, notes and limits in the complete document before using a value in a design.

  • This module series included DA16200-00000A32, 40 MHz crystal oscillator, 32.768 KHz RTC clock, RF Lumped RF filter, 4 M-byte flash memory and chip antenna or u.FL connector.
  • Key Features ■ Module variants □ DA16200MOD-AAC4WA32 (chip Antenna) □ DA16200MOD-AAE4WA32 (u.FL cont.) ■ Highly integrated ultra-low power Wi-Fi® system module □ Sleep current: 3.5 uA, VBAT=3.3 V ■ Best RF Performance □ Tx Power: +19 dBm.
  • Figure 3: Software Block Diagram VBAT_3V3 VDD_DIO1 VDD_DIO2 RTC Control 40MHz Crystal 2.4GHzRF filter & Matching External Antenna type (u.FL connector) DA16200MOD-AAE Chip Antenna type DA16200MOD-AAC 32.768KHz Crystal UART For debugging 4c.
  • 32.4 kΩ Pull-down Resistor RPD VPAD=VIL, DIO=Min.
  • VSS 0.4 V Output High Voltage VOH DVDD=Min.
  • 19.4 kΩ Pull-down Resistor RPD VPAD=VIL, DIO=Min.
  • 16.0 Note 1 DVDD= 3.3 V, VDD_DIO1, VDD_DIO2 Logic Level There are several control pins in RTC block, see Section 7.3 RTC for detail.

Topics covered by the datasheet

The document includes sections related to:

  • Datasheet sections
  • Applications
  • Revision History

Engineering review checklist

  • Confirm supply rails, clock limits, memory size, peripheral mapping and I/O voltage compatibility.
  • Check package pinout, boot configuration, programming interface and silicon-revision errata.
  • Budget decoupling, thermal margin, startup timing and firmware recovery behavior before release.

Always confirm values against the latest manufacturer-controlled datasheet, especially when qualifying a substitute or releasing a production BOM.

View the complete PDF and model record

Open the DA16200MOD datasheet and model details to review the complete PDF, document pages and available product information.

Source attribution

Adapted from the PDF associated with this DigiCamel model page.

Source model URL: https://www.digicamel.com/product.php?slug=da16200mod-renesas-technology-corp

DA16200MOD Renesas Technology Corp IC DA16200MOD datasheet DA16200MOD specifications DA16200MOD applications