CLX2 overview
CLX2 is a component documented by Radiometrix Ltd. The PDF description identifies it as "19200 baud modem transceiver." This guide condenses the most useful engineering information from the available PDF so that designers and sourcing teams can identify the checks that still need confirmation in the original document.
Datasheet snapshot
- Manufacturer: Radiometrix Ltd
- Part number: CLX2
- Category: Logic IC
- Datasheet length: 6 Pages
Specifications and operating details
The following points were extracted from the PDF text. Check the associated conditions, notes and limits in the complete document before using a value in a design.
- At the transmit end this is used to allow for the transmitter start up time (about 4ms), while on receive it buffers arriving packets to the constant output data rate.
- VDD must be a clean 3.3V DC regulated supply 3.
- If pulled low in receive, the unit goes into hot standby (<2mA) In standby the unit does not receive, but will go into transmit if valid data is presented to TXD.
- TXD / RXD are inverted RS232 at 3V CMOS leve ls.
- A 2.2k resistance is present from RF pin 1a to ground for ESD protection Radiometrix Ltd CLX2 Data Sheet page 4 Condensed specifications Frequency 433.92MHz Frequency stability ±10kHz Channel width 400kHz Number of channels 1 Supply Volt.
- Optimum total length is 16cm (1/4 wave @ 433MHz).
- This antenna is very efficient given it’s small size (20mm x 4mm dia.).
Topics covered by the datasheet
The document includes sections related to:
- DATASHEET SEARCH SITE
- Features
- Applications
Engineering review checklist
- Confirm supply rails, clock limits, memory size, peripheral mapping and I/O voltage compatibility.
- Check package pinout, boot configuration, programming interface and silicon-revision errata.
- Budget decoupling, thermal margin, startup timing and firmware recovery behavior before release.
Always confirm values against the latest manufacturer-controlled datasheet, especially when qualifying a substitute or releasing a production BOM.
View the complete PDF and model record
Open the CLX2 datasheet and model details to review the complete PDF, document pages and available product information.
Source attribution
Adapted from the PDF associated with this DigiCamel model page.
Source model URL: https://www.digicamel.com/product.php?slug=clx2-radiometrix-ltd