CDT2000 overview
CDT2000 is a component documented by TOKYO KEISO CO.,LTD. The PDF description identifies it as "Multi-Digital Flowmeter OCT. 2013K." This guide condenses the most useful engineering information from the available PDF so that designers and sourcing teams can identify the checks that still need confirmation in the original document.
Datasheet snapshot
- Manufacturer: TOKYO KEISO CO.,LTD.
- Part number: CDT2000
- Category: IC
- Datasheet length: 4 Pages
Key features noted in the PDF
- Measuring Fluid : Water, Cold water, Hot water
- Max. Pressure : 2MPa
- Max. Allowable Differential Pressure :700kPa (Bias pressure) Not applicable for vacuum service
- Temperature and Relative Humidity Fluid temperature : -10 to 70 oC (Use the lining or plastics pipe within its allowable temperature) Ambient Temp. : -10 to 50 oC < 85%RH Storage.
- Process pipe size : 20mm(3/4") to 450mm(18")
- Adaptation pipe : Carbon steel pipe for piping (JIS G 3452) [1MPa class] Carbon steel pipe for pressure piping (JIS G 3454 Sch40) [2MPa class]
- Note : If pipe other than above is required, special calibration may be necessary. Consult with factory about details. less than 30%)
Specifications and operating details
The following points were extracted from the PDF text. Check the associated conditions, notes and limits in the complete document before using a value in a design.
- Applicable sizes range from 15mm to 450mm dia.
- CDT2000 is most suitable for the measurement of cold / hot water for the air conditioning of buildings and collective housings. ❏ Easy installation simply by welding 20mm(3/4") socket at measur- ing points of existing pipes. ❏ Indicator pa.
- 3) The inside diameter of in 2MPa specification is based on the carbon steel tube for STPG (JIS G3454 Sch40) for pressure piping, and full scale range of 20 to 32mm in 2MPa is shown in gray area.
- SET Aoff MODE 100 W INSTALLATION 1) Keep the upstream and downstream straight runs as required.
- 2) To install the flowmeters, Drill a hole of 35mm diameter into the pipe having more than or equal to 40mm diameter.
- Use the three-way socket for the pipe having less than or equal to 32 mm diameter.
- 2.) Note) Use [/] in the code to indicate of option (PVC lining etc.) Connection size of PVC lining is shown in gray (32 to 150mm). (Inform of L and D size in the following figure.) [ E.g.1 ] For combined selection of Connection size 80mm.
Topics covered by the datasheet
The document includes sections related to:
- FEATURES
- ORDERING INFORMATION
Engineering review checklist
- Verify contact current, voltage, contact resistance, insulation and mating-cycle ratings.
- Check the exact keying, pitch, orientation, mating part and mechanical drawing before footprint approval.
- Review assembly force, retention, cable strain relief and environmental exposure for the application.
Always confirm values against the latest manufacturer-controlled datasheet, especially when qualifying a substitute or releasing a production BOM.
View the complete PDF and model record
Open the CDT2000 datasheet and model details to review the complete PDF, document pages and available product information.
Source attribution
Adapted from the PDF associated with this DigiCamel model page.
Source model URL: https://www.digicamel.com/product.php?slug=cdt2000-tokyo-keiso-co-ltd