CA5260 overview
CA5260 is a component documented by Renesas Technology Corp. The PDF description identifies it as "3MHz, BiMOS Microprocessor Operational Amplifiers with MOSFET Input/CMOS Output." This guide condenses the most useful engineering information from the available PDF so that designers and sourcing teams can identify the checks that still need confirmation in the original document.
Datasheet snapshot
- Manufacturer: Renesas Technology Corp
- Part number: CA5260
- Category: Amplifier
- Datasheet length: 7 Pages
Key features noted in the PDF
- MOSFET Input Stage provides 2pA (Typ) at 5V Operation
- Ideal for Single Supply Applications
- Common Mode Input Voltage Range Includes Negative Supply Rail; Input Terminals Can be Swung 0.5V Below Negative Supply Rail
- CMOS Output Stage Permits Signal Swing to Either (or Both) Suppl y Rails
- CA5260A, CA5260 Have Full Military Temperature Range Guaran teed Specifications for V+ = 5V
- CA5260A, CA5260 are Guaranteed to Operate Down to 4.5V fo r AOL
- Fully Guaranteed to Operate from -55°C to +125°C at V+ = 5V, V- = GND
Applications listed in the PDF
- Ground Referenced Single Supply Amplifiers
- Fast Sample-Hold Amplifiers
- Long Duration Timers/Monostables
- Ideal Interface with Dig ital CMOS
- High Input Impedance Wi deband Amplifiers
- Voltage Followers (e.g., Follower for Single Supply D/A Con verter)
Specifications and operating details
The following points were extracted from the PDF text. Check the associated conditions, notes and limits in the complete document before using a value in a design.
- CA5260, CA5260A FN1929 Rev 8.00 August 3, 2010 Thermal Resistance (Typical, Note 5) JA (°C/W) CAUTION: Do not operate at or near the maximum ratings listed for extended periods of time.
- PARAMETER SYMBOL TEST CONDITIONS TYPICAL VALUES UNITSCA5260 CA5260A Input Resistance RI 1.5 1.5 T Input Capacitance CI f = 1MHz 4.3 4.3 pF Unity Gain Crossover Frequency fT 3 3 MHz Slew Rate SR VOUT = 2.5VP-P 5 5 V/µs Transient Response C.
- For V+ = 4.5V and V- = GND; VOUT = 0.5V to 3.2V at RL = 10k Electrical Specifications TA = -55°C to +125°C, V+ = 5V, V- = 0V PARAMETER SYMBOL TEST CONDITIONS CA5260 CA5260A UNITS MIN (Note 8) TYP MAX (Note 8) MIN (Note 8) TYP MAX (Note 8.
- For V+ = 4.5V and V- = GND; VOUT = 0.5V to 3.2V at RL = 10k 8.
- Parameters with MIN and/or MAX limits are 100% tested at +25°C, unless otherwise specified.
- Electrical Specifications TA = +25°C, V+ = 5V, V- = 0V (Continued) PARAMETER SYMBOL TEST CONDITIONS CA5260 CA5260A UNITSMIN TYP MAX MIN TYP MAX Electrical Specifications Each Amplifier at TA = +25°C, V+ = 15V, V- = 0V, Unless Otherwise Spe.
- Mold flash, protrusion and gate burrs shall not exceed 0.15mm (0.006 inch) per side.
Topics covered by the datasheet
The document includes sections related to:
- Features
- Applications
- Ordering Information
Engineering review checklist
- Confirm repetitive reverse voltage, average forward current, surge current and leakage at the intended temperature.
- Check forward-voltage loss and reverse-recovery behavior at the actual current and switching frequency.
- Review package thermal resistance, copper area, polarity marking and transient derating before layout release.
Always confirm values against the latest manufacturer-controlled datasheet, especially when qualifying a substitute or releasing a production BOM.
View the complete PDF and model record
Open the CA5260 datasheet and model details to review the complete PDF, document pages and available product information.
Source attribution
Adapted from the PDF associated with this DigiCamel model page.
Source model URL: https://www.digicamel.com/product.php?slug=ca5260-renesas-technology-corp