BMG250 overview
BMG250 is a component documented by Bosch Sensortec GmbH. The PDF description identifies it as "Low noise, low power triaxial gyroscope." This guide condenses the most useful engineering information from the available PDF so that designers and sourcing teams can identify the checks that still need confirmation in the original document.
Datasheet snapshot
- Manufacturer: Bosch Sensortec GmbH
- Part number: BMG250
- Category: Sensor
- Datasheet length: 74 Pages
Specifications and operating details
The following points were extracted from the PDF text. Check the associated conditions, notes and limits in the complete document before using a value in a design.
- The BMG250 offers a wide VDD voltage range from 1.71V to 3.6V and a VDDIO range from 1.2V to 3.6V, allowing the BMG250 to be powered at 1.8V for both VDD and VDDIO.
- The timestamps have a resolution of up to 39 µs.
- 1.4s of data capture at an output data rate of 100Hz in FIFO mode with data header.
- The voltage levels at the digital input pins must not fall below GNDIO-0.3V or go above VDDIO+0.3V to prevent excessive current flowing into the respective input pin.
- Table 1: Electrical parameter specification OPERATING CONDITIONS BMG250 Parameter Symbol Condition Min Typ Max Unit Supply Voltage Internal Domains VDD 1.71 3.0 3.6 V Supply Voltage I/O Domain VDDIO 1.2 2.4 3.6 V Voltage Input Low Level VI.
- Output Noise nG,nD @10 Hz 0.007 °/s/√ Hz nG,rms Filter setting 74.6Hz, ODR 200 Hz 0.07 °/s rms Bias stability BSG 10 °/h Output Data Rate (set of x,y,z rate) ODRG 25 3200 Hz Output Data Rate (set of x,y,z rate) ODROIS Fixed setting 6400 Hz.
- H. -50 +150 °C None-volatile memory (NVM) Data Retention T = 85°C, after 15 cycles 10 y Mechanical Shock Duration 200 µs, half sine 10,000 g Duration 1.0 ms, half sine 2,000 g Free fall onto hard surfaces 1.8 m ESD HBM, at any Pin 2 kV CDM.
Topics covered by the datasheet
The document includes sections related to:
- DATASHEET SEARCH SITE
Engineering review checklist
- Confirm the exact ordering code, package, pinout or terminal arrangement and document revision.
- Compare recommended operating conditions with absolute maximum ratings and retain adequate design margin.
- Validate electrical, thermal, mechanical and environmental behavior in the final application.
Always confirm values against the latest manufacturer-controlled datasheet, especially when qualifying a substitute or releasing a production BOM.
View the complete PDF and model record
Open the BMG250 datasheet and model details to review the complete PDF, document pages and available product information.
Source attribution
Adapted from the PDF associated with this DigiCamel model page.
Source model URL: https://www.digicamel.com/product.php?slug=bmg250-bosch-sensortec-gmbh