ANT-418-PW-QW overview
ANT-418-PW-QW is a component documented by Linx Technologies. The PDF description identifies it as "Designed for permanent attachment 1/26/15." This guide condenses the most useful engineering information from the available PDF so that designers and sourcing teams can identify the checks that still need confirmation in the original document.
Datasheet snapshot
- Manufacturer: Linx Technologies
- Part number: ANT-418-PW-QW
- Category: IC
- Datasheet length: 2 Pages
Key features noted in the PDF
- Outstanding performance
- Omni-directional pattern
- Wide bandwidth
- Flexible main shaft
- Rugged & weatherized
- Integral 8.5" (216 mm) RG-174 coax cable or 1.32 mm coax (U.FL)
- Use with plastic* or metal enclosures * Requires proximity ground plane Electrical Specifications Center Frequency: 418MHz Bandwidth: 380–450MHz Wavelength: ¼-wave VSWR: ≤ 1.9 typ.
Specifications and operating details
The following points were extracted from the PDF text. Check the associated conditions, notes and limits in the complete document before using a value in a design.
- Range: –40°C to +90°C Electrical specifications and plots measured on 10.16 cm x 10.16 cm (4.00" x 4.00") reference ground plane ANT-418-PW-QW-xxx Data Sheet by ANT-418-PW-QW (with straight cut RG-174 coax) ANT-418-PW-QW-UFL (U.FL/MHF comp.
- How to Read a VSWR Graph VSWR is usually displayed graphically versus frequency.
- The lowest point on the graph is the antenna’s operational center frequency.
- In most cases, this will be different than the designed center frequency due to fabrication tolerances.
- When used in conjunction with a ground plane smaller than that used to tune the antenna, the center frequency typically will shift higher in frequency and the bandwidth will decrease.
- VSWR Reflected Power 3:1 2:1 1:1 25% 11% 418MHz 518MHz318MHz 1.158
Topics covered by the datasheet
The document includes sections related to:
- Features
- Ordering Information
Engineering review checklist
- Verify contact current, voltage, contact resistance, insulation and mating-cycle ratings.
- Check the exact keying, pitch, orientation, mating part and mechanical drawing before footprint approval.
- Review assembly force, retention, cable strain relief and environmental exposure for the application.
Always confirm values against the latest manufacturer-controlled datasheet, especially when qualifying a substitute or releasing a production BOM.
View the complete PDF and model record
Open the ANT-418-PW-QW datasheet and model details to review the complete PDF, document pages and available product information.
Source attribution
Adapted from the PDF associated with this DigiCamel model page.
Source model URL: https://www.digicamel.com/product.php?slug=ant-418-pw-qw-linx-technologies