1060 overview
1060 is a component documented by Microchip Technology. The PDF description identifies it as "Six-channel QTouch® Touch Sensor IC." This guide condenses the most useful engineering information from the available PDF so that designers and sourcing teams can identify the checks that still need confirmation in the original document.
Datasheet snapshot
- Manufacturer: Microchip Technology
- Part number: 1060
- Category: Sensor
- Datasheet length: 35 Pages
Specifications and operating details
The following points were extracted from the PDF text. Check the associated conditions, notes and limits in the complete document before using a value in a design.
- Discrete detection outputs Moisture Tolerance: Increased moisture tolerance based on hardware design and firmware tuning Signal Processing: Self-calibration auto drift compensation noise filtering Adjacent Key Suppression® (A.
- 7AT42QT1060 [DATASHEET] 9505H–AT42–04/2015 A 1 in any bit position in this mask sets the corresponding pin to operate in PWM mode when its user output buffer is active and configured as an output.
- The QT1060 operation is based on a fixed cycle time of approximately 16 ms.
- For example, if LP mode = 1, there is an acquisition every cycle (16 ms).
- If LP mode = 3, there is an acquisition every 3 cycles (48 ms), and so on.
- LP settings above mode 32 (512 ms) result in slower thermal drift compensation and should be avoided in applications where fast thermal transients occur.
- This soft reset triggers the internal watchdog timer on a ~16 ms interval. After ~16 ms the device resets and wakes again. After a further 30 ms initialization period the device begins responding to its I2C slave address. After anoth.
Topics covered by the datasheet
The document includes sections related to:
- Features
- Revision History
Engineering review checklist
- Verify capacitance tolerance, rated voltage, temperature range and any DC-bias derating.
- Check ESR, ripple-current capability, lifetime and polarity requirements under worst-case conditions.
- Confirm package dimensions, land pattern and reflow or mounting limits for the selected ordering code.
Always confirm values against the latest manufacturer-controlled datasheet, especially when qualifying a substitute or releasing a production BOM.
View the complete PDF and model record
Open the 1060 datasheet and model details to review the complete PDF, document pages and available product information.
Source attribution
Adapted from the PDF associated with this DigiCamel model page.
Source model URL: https://www.digicamel.com/product.php?slug=1060-microchip-technology