WP710A10SET KINGBRIGHT | Alldatasheet

Document overview

  • Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
  • PDF pages: 6

Technical content

Features

 Low power consumption.  Popular T-1 diameter package.  General purpose leads.  Reliable and rugged.  Long life - solid state reliability.  Available on tape and reel.  RoHS compliant.

Description

The Super Bright Orange device is made with AlGaInP (on GaAs substrate) light emitting diode chip. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25(0.01") unless otherwise noted. 3. Lead spacing is measured where the leads emerge from the package. 4. The specifications, characteristics and technical data described in the datasheet are subject to change without prior notice.

SPEC NO: DSAL0541 REV NO: V.4A DATE: JAN/17/2015 PAGE: 2 OF 6 APPROVED: WYNEC CHECKED: Allen Liu DRAWN: Q.M.Chen ERP: 1101029217 Selection Guide Notes: 1.θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 of the optical peak value. 2.Luminous intensity/ luminous Flux: +/-15%. *Luminous intensity value is traceable to the CIE127-2007 compliant national standards. Absolute Maximum Ratings at TA=25°C Electrical / Optical Characteristics at TA=25°C Notes: 1.Wavelength: +/-1nm. 2.Forward Voltage: +/-0.1V. 3.Wavelength value is traceable to the CIE127-2007 compliant national standards. 4.Excess driving current and/or operating temperature higher than recommended conditions may result in severe light degradation or premature failure. Notes: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. 2. 2mm below package base. 3. 5mm below package base. Part No. Dice Lens Type Iv (mcd) [2] @ 20mA Viewing Angle [1] Min. Typ. 2 θ1/2 Super Bright Orange (AlGaInP) Orange Transparent 900 1700 34° *350 *800 WP710A10SET Symbol Parameter Device Typ. Max. Units Test Conditions λpeak Peak Wavelength Super Bright Orange 610 nm I F=20mA λD [1] Dominant Wavelength Super Bright Orange 601 nm I F=20mA Δλ1/2 Spectral Line Half-width Super Bright Orange 29 nm I F=20mA C Capacitance Super Bright Orange 30 pF V F=0V;f=1MHz VF [2] Forward Voltage Super Bright Orange 2 2.5 V I F=20mA IR Reverse Current Super Bright Orange 10 uA V R = 5V Parameter Super Bright Orange Units Power dissipation 75 mW DC Forward Current 30 mA Peak Forward Current [1] 195 mA Reverse Voltage 5 V Operating/Storage Temperature -40°C To +85°C Lead Solder Temperature [2] 260°C For 3 Seconds Lead Solder Temperature [3] 260°C For 5 Seconds

SPEC NO: DSAL0541 REV NO: V.4A DATE: JAN/17/2015 PAGE: 3 OF 6 APPROVED: WYNEC CHECKED: Allen Liu DRAWN: Q.M.Chen ERP: 1101029217 Super Bright Orange WP710A10SET

SPEC NO: DSAL0541 REV NO: V.4A DATE: JAN/17/2015 PAGE: 4 OF 6 APPROVED: WYNEC CHECKED: Allen Liu DRAWN: Q.M.Chen ERP: 1101029217 PACKING & LABEL SPECIFICATIONS WP710A10SET Terms and conditions for the usage of this document 1. The information included in this docum ent reflects representative usage scenarios and is intended for technical reference only. 2. The part number, type, and specifications mentioned in this document are subject to future change and improvement without notice. Before production usage customer should refer to the latest datasheet for the updated specifications. 3. When using the products referenced in this document, please make sure the product is being operated within the environmental and electrical limits specified in the datasheet. If customer usage exceeds the specified limits, Kingbright will not be responsible for any subsequent issues. 4. The information in this document applies to typical usage in consumer electronics applicati ons. If customer's application ha s special reliability requirements or have life-threatening liabilitie s, such as automotive or m edical usage, please consult with Kingbright representative for further assistance. 5. The contents and information of this document may not be reproduced or re-transmitted without permission by Kingbright. 6. All design applications should refer to Kingbright application notes available at http://www.KingbrightUSA.com/ApplicationNotes

SPEC NO: DSAL0541 REV NO: V.4A DATE: JAN/17/2015 PAGE: 5 OF 6 APPROVED: WYNEC CHECKED: Allen Liu DRAWN: Q.M.Chen ERP: 1101029217

SPEC NO: DSAL0541 REV NO: V.4A DATE: JAN/17/2015 PAGE: 6 OF 6 APPROVED: WYNEC CHECKED: Allen Liu DRAWN: Q.M.Chen ERP: 1101029217