VN1015 ZFSWITCHES | Alldatasheet
Document overview
- Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
- PDF pages: 2
Technical content
www.cherryswitches.com Page 1 of 2, Last update 2016-01-12, Specifications subject to change without notice. Digital Vane Sensor VN1015 Sensors Magnetically activated digital vane sensor in a rugged, overmolded plastic housing with three pins or 3-wire flying leads
Description
The VN1015 sensors employ a Hall Effect digital vane sensor and a permanent magnet in two small towers, separated by a 3.4 mm (0.135”) air gap. The output switches when a ferrous target passes between the towers. Typical targets are linear or rotary vanes using a square saw tooth or an open slot in a solid disk or band. Features Typical Applications
- Mechanically interchangeable with typical slotted optical switches
- Robust, high speed sensing in dirty/dusty environm ents
- No mechanical contacts to wear out
- Open collector (sinking or NPN) output can be used with bipolar or CMOS logic circuits with suitable pull-up resistor
- RoHS compliant
- Door/gate position control
- Exercise equipment
- Printers Environmental Specifications Operating Temperature (VN101501, VN101503) -40 °C to 85 °C ( -40 °F to 185 °F) Operating Temperature (VN101502, VN101504) -40 °C to 150 °C ( -40 °F to 302 °F) Storage Temperature (VN101501, VN101503) -40 °C to 85 °C ( -40 °F to 185 °F) Storage Temperature (VN101502, VN101504) -40 °C to 150 °C ( -40 °F to 302 °F) Electrical Specifications Supply Voltage 3.8 to 24 VDC Maximum Input Voltage 30 VDC Maximum Reverse Voltage 30 VDC Supply Current 4.1 mA typ., 7.5 mA max. Output (Sink) Current 25 mA max. Recommended Pull -Up Resistor See Chart Mechanical Specifications Housing Material Over -molded plastic Sensor Orientation Sensitive; see drawing Recommended Vane Parameters Low carbon material at least 1 .016 mm (0.04") thick, should penetrate to a depth < 3.05 mm (0.12") from bottom of sensor slot Part Number Termination VN101501 pins VN101502* pins VN101503 24 AWG x 150 mm leads VN101504* 24 AWG x 150 mm leads *Not commonly stocked; please contact the factory or your distributor
w.cherryswitches.com Page 2 of 2, Last update 2016-01-12, Specifications subject to change without notice. Note: An external pull-up resistor is required, the value of which is dependent on the supply voltage. The resistor should be c onnected between the output and Vcc. Refer to the wiring diagram for lead colors or pin numbering as applicable. Recommended External Pull-Up Resistor Volts DC 5 9 12 15 24 Ohms 1k 1.8k 2.4k 3k 3k Op en Collector Sinking Block Diagram Dimensions mm (inches)