UM1083 STMICROELECTRONICS | Alldatasheet
Document overview
- Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
- PDF pages: 7
Technical content
Datasheet sections
- 1 Getting started
- 1.1 System requirements
- 1.2 Downloading and installing the DfuSe program
- 1.3 Connecting the STEVAL-IME003V1 board
- 2 Using DFU with STEVAL-IME003V1
- 3 Revision history
August 2011 Doc ID 018990 Rev 1 1/7 UM1083 User manual How to upgrade the waveforms on the STEVAL-IME003V1 demonstration board Introduction This user manual describes the procedure required to upgrade the waveforms contained in the Flash memory of the STEVAL-IME003V1 demonstration board based on the STHV748 ultrasound pulser. In addition, detailed information on using the DfuSe application to upgrade the waveforms is provided, including screenshots of the GUI.
1 Getting started
1.1 System requirements
properties" dialog box under the "System" label in the "General" tab.
1.2 Downloading and inst alling the DfuSe program
the DfuSe, "DFuse Demonstration" appears within the start menu.
1.3 Connecting the STEVAL-IME003V1 board
instructions contained in UM0412. Figure 1. STEVAL-IME003V1 board layout top view the USB cable is plugged in.
2 Using DFU with STEVAL-IME003V1
- Open "DfuSe Demonstration" from the start menu and the dialog box in Figure 2 will
appears in the drop-down list, see box 1.
- In order to load an upgrade for the STEVAL-IME003V1, select as Target the SPI Flash
- Once the file has been selected, verify that the vendor ID and product ID (see box 4 in
Figure 2) are 0483 and DF11, respectively.
- Check the "Verify after download" check box, and then press the "Upgrade" button (see
box 3). When the new window appears, click "Y es" to continue.
- Check that the "Verify Successful!" message appears in the dialog box, as in Figure 4.
- It is now possible to disconnect the board from the USB port.
Figure 2. DfuSe GUI
3 Revision history
Table 1. Document revision history 12-Aug-2011 1 Initial release.