STLINK-V3SET STMICROELECTRONICS | Alldatasheet

Document overview

  • Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
  • PDF pages: 4

Technical content

Features

  • Stand-alone probe with modular extensions
  • Self-powered through a USB connector (Micro-B)
  • USB 2.0 high-speed compatible interface
  • Direct firmware update support (DFU)
  • JTAG / serial wire debugging (SWD) specific features: – 3 V to 3.6 V application voltage support and 5 V tolerant inputs – Flat cables STDC14 to MIPI10 / STDC14 / MIPI20 (connectors with 1.27 mm pitch) – JTAG communication support – SWD and serial wire viewer (SWV) communication support
  • SWIM specific features (only available with adapter board MB1440): – 1.65 V to 5.5 V application voltage support – SWIM header (2.54 mm pitch) – SWIM low-speed and high-speed modes support
  • Virtual COM port (VCP) specific features: – 3 V to 3.6 V application voltage support on the UART interface and 5 V tolerant inputs – VCP frequency up to 15 MHz – Available on STDC14 debug connector (not available on MIPI10)
  • Multi-path bridge USB to SPI/UART/I 2C/CAN/GPIOs specific features: – 3 V to 3.6 V application voltage support and 5 V tolerant inputs – Signals available on adapter board only (MB1440)
  • Drag-and-drop Flash programming
  • Two color LEDs: communication, power Picture is not contractual.

Description

The STLINK-V3SET is a modular stand-alone debugging and programming probe for the STM8 and STM32 microcontrollers. It is composed of a main module and a complementary adapter board. The SWIM and JTAG/SWD interfaces are used to communicate with any STM8 or STM32 microcontroller located on an application board. The STLINK-V3SET also provides a Virtual COM port interface allowing the host PC to communicate with the target microcontroller through one UART, and bridge interfaces (SPI, I 2C, CAN, GPIOs) allowing for instance the programming of the target through bootloader. The modular architecture of STLINK-V3SET enables to extend its main features through additional modules such as the adapter board.

General information STLINK-V3SET 2/4 DB3692 Rev 1 General information The STLINK-V3SET embeds an STM32 32-bit microcontroller based on the Arm®(a) Cortex®-M processor. System requirements

  • Windows® OS (7, 8 and 10), Linux® 64-bit, or macOS®(b)
  • USB Type-A to Micro-B cable Development toolchains
  • Keil® MDK-ARM(c)
  • IAR™ EWARM (c)
  • GCC-based IDEs

Ordering information

To order the STLINK-V3SET, refer to Table 1. a. Arm is a registered trademark of Arm Limited (o r its subsidiaries) in the US and or elsewhere. c. On Windows ® only. Table 1. Ordering information

Revision history

Table 2. Document revision history 6-Sep-2018 1 Initial release.