SP480 ASTRODYNE | Alldatasheet
Document overview
- PDF pages: 4
Technical content
480W Single Output with PFC Function SP480 series WWW.ASTRODYNETDI.COM ASTRODYNE USA: 1-800-823-8082 ASTRODYNE PACIFIC: 886-2-26983458 Universal AC input Protections:Short circuit/Over load/Over voltage/Over temperature Built-in active PFC function, PF >0.95 Forced air cooling by built-in DC Fan High power density 5.18w/cubic inch Low profile:43mm thickness Built in remote ON-OFF control Built-in remote sense function Active AC surge current limiting Model Number Output Volts Output Amps OVP Min Load DC Volt Adjust OCP Efficiency SINGLE OUTPUT SP480-5 5 Volts(DC) 85 Amps 5.75 ~ 6.75Volt(DC) 0~85Amps 4.5~5.5Volt(DC) 87~103Amps 79% SP480-15 15 Volts(DC) 32 Amps 18 ~ 21Volt(DC) 0~35Amps 13.5~18Volt(DC) 36.75~47.25Amps 85% SP480-48 48 Volts(DC) 10 Amps 57.6~ 67.2Volt(DC) 0~11Amps 41~56Volt(DC) 11.55~14.85Amps 89%
480W Single Output with PFC Function SP480 series WWW.ASTRODYNETDI.COM ASTRODYNE USA: 1-800-823-8082 ASTRODYNE PACIFIC: 886-2-26983458 INPUT SPECIFICATIONS Input Voltage Range (Note 5) 90 ~ 264VAC 120~370 Volts(DC) Frequency Range 47-63 Hz Inrush Current, typ: (cold start) 20Amps/115VAC; 40Amps 230VAC Input Current 6.5Amps @ 115VAC
3.5 Amps @ 230VAC
Leakage current < 2mAmps / 240VAC Min Load See Selection Chart Power Factor @ FL PF > 0.95 / 230VAC > 0.98 / 115VAC OUTPUT SPECIFICATIONS Voltage and Current (Note3) See Selection Chart Line Regulation ±0.5%: 3.3;5Volts(DC) ±0.3%: 12;15Volts(DC) ±0.2%: 24;48Volts(DC) Load Regulation ±1.0%: 3;5Volts(DC) ±0.5%: 12~48Volts(DC) Voltage Tolerance (Note 2) ±2.0%: 3.3;5Volts(DC) ±1.5%: 12;15Volts(DC) ±1.0%: 24;48Volts(DC) Ripple/Noise (Note 1) 80mVpk-pk: 3.3;5Volts(DC) 120mVpk-pk: 12Volts(DC) 150mVpk-pk: 15;24Volts(DC) 240mVpk-pk: 48Volts(DC) Hold Up Time @ FL 18mS /230VAC 18mS /115VAC Setup, Rise Time @ FL 1000mS, 80mS /230VAC 2500mS, 80mS /115VAC Over Voltage Protection See Selection Chart Shut down o/p volt,re power Over Current Protection See Selection Chart Constant current limiting,auto recover Over Temperature (Note 3) 80°C TSW1: detect on heatsink of power transistor 90°C TSW2: detect on heatsink of power diode Shut down o/p voltage, auto recover DC Volt Adjust See Selection Chart Peak Load: 10min (Note 4 ) 10% max GENERAL SPECIFICATIONS Safety UL60950-1, TUV EN60950-1 Approved Insulation Resistance ≥ 100MΩ / 500Volts(DC) EMI Compliance to EN55022B (CISPR22B) Harmonic Current Compliance to EN61000-3-2,-3 Remote Control RC+/RC-: 4~10Volts(DC) Power off 0 ~ 0.8Volts(DC) Power on Efficiency See Selection Chart Isolation 3000VAC Input - Output 1500VAC Input - Ground Short Output - Ground EMS Compliance to ENV50204,EN61000-6-2(EN50082-2) light Industry Level, Criteria A ENVIRONMENTAL SPECIFICATIONS Oper. Temperature -20°C to +60°C (See Derate Curve) Storage Temperature -40°C to +85°C, 10~95% RH Relative Humidity 20~90% RH non cond Temperature Coefficient ±0.03% / °C (0-50°C) MTBF 120.5KHrs min,MIL-HDBK-217F(25°C) Vibration 10~500Hz, 2G10min./1cycle, period for 60min. each along X, Y, Z axes PHYSICAL SPECIFICATIONS Size 278x127 x 43mm (10.94”x5 ”x1.69”) Weight 59.97 oz (1700g) NOTE 1. Ripple & noise are measured at 20MHz of bandwidth by using a 12” twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. 2. Tolerance : includes set up tolerance, line regulation and load regula- tion. 3. TSW1: Detect on heatsink of power transistor. TSW2: Detect on heatsink of output diode. 4. 33% Duty cycle maximum within every 30 minute. Average output power should not exceed the rated POWER. 5. Derating may be needed under low input voltages. Please check the derating curve for more details. All specifications are typical at nominal input, full load, and 25°C unless other- wise noted
480W Single Output with PFC Function SP480 series WWW.ASTRODYNETDI.COM ASTRODYNE USA: 1-800-823-8082 ASTRODYNE PACIFIC: 886-2-26983458
480W Single Output with PFC Function SP480 series WWW.ASTRODYNETDI.COM ASTRODYNE USA: 1-800-823-8082 ASTRODYNE PACIFIC: 886-2-26983458