SF10-005G

SF10-005G FRONTIER | Alldatasheet

Document overview

• Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
• PDF pages: 2

Technical content

SF10-005GTHRU SF10-06G Page: 1 Frontier Electronics Corp. 667 E. COCHRAN STREET, SIMI VALLEY, CA 93065 TEL: (805) 522-9998 FAX: (805) 522-9989 E-mail: frontiersales@frontierusa.com Web: http://www.frontierusa.com 1A GLASS PASSIVATED SUPER FAST RECOVERY RECTIFIER SF10-005GTHRU SF10-06G F E A T U R E S z LOW FORWARD VOLTAGE z H I G H S U R G E C A P A B I L I T Y z SUPER FAST SWITCHING SPEED z GOOD FOR SWITCHING MODE CIRCUIT z GLASS PASSIVATED CHIP JUNCTION M E C H A N I C A L D A T A z CASE: MOLDED PLASTIC, DO41, DIMENSIONS IN INCHES AND (MILLIMETERS) z EPOXY: UL 94V-0 FLAME RETARDANT PLASTIC CASE z LEADS: AXIAL LEADS, SOLDERABLE PER MIL-STD-202, METHOD 208 z MOUNTING POSITION: ANY z W E I G H T : 0 . 3 4 G R A M S MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS RATINGS AT 25 °C AMBIENT TEMPERATURE UNLESS OTHERWISE SPECIFIED SINGLE PHASE, HALF WAVE, 60 HZ, RESISTIVE OR INDUCTIVE LOAD. FOR CAPACITIVE LOAD, DERATE CURRENT BY 20% RATINGS SYMBOL SF10 -005G SF10 -01G SF10 -015G SF10 -02G SF10 -03G SF10 -04G SF10 -05G SF10 -06G UNITS MAXIMUM RECURRENT PEAK REVERSE VOLTAGE V RRM 50 100 150 200 300 400 500 600 V MAXIMUM RMS VOLTAGE V RMS 35 70 105 140 210 280 350 420 V MAXIMUM DC BLOCKING VOLTAGE V DC 50 100 150 200 300 400 500 600 V MAXIMUM AVERAGE FORWARD RECTIFIED CURRENT 0.375”(9.5mm) LEAD LENGTH AT TA=55°C IO 1.0 A PEAK FORWARD SURGE CURRENT, 8.3ms SINGLE HALF SINE-WAVE SUPERIMPOSED ON RATED LOAD IFSM 30 A TYPICAL JUNCTION CAPACITANCE (NOTE 1) C J 15 10 PF TYPICAL THERMAL RESISTANCE (NOTE 2) Rθjc 50 ℃/W STORAGE TEMPERATURE RANGE T STG - 55 TO + 150 ℃ OPERATING TEMPERATURE RANGE T OP - 55 TO + 150 ℃ ELECTRICAL CHARACTERISTICS (AT TA =25°C UNLESS OTHERWISE NOTED) CHARACTERISTICS SYMBOL SF10 -005G SF10 -01G SF10 -015G SF10 -02G SF10 -03G SF10 -04G SF10 -05G SF10 -06G UNITS MAXIMUM FORWARD VOLTAGE AT IO D C V F 0.95 1.25 1.85 V MAXIMUM REVERSE CURRENT AT 25℃ IR 10 μA MAXIMUM REVERSE CURRENT AT 100℃ IR 100 μA MAXIMUM REVERSE RECOVERY TIME (NOTE 3) T RR 35 nS NOTE : 1. MEASURED AT 1 MHZ AND APPLIED REVERSE VOLTAGE 0F 4.0 VOLTS 2. BOTH LEADS ATTACHED TO HEAT SINK 20x20x1t(mm) COPPER PLATE AT LEAD LENGTH 5mm 3. REVERSE RECOVERY TEST CONDITIONS: IF=0.5A, IR=1.0A, IRR=0.25A .205(5.2) .166(4.2) 1.0(25.4) MIN .034(0.9) .028(0.7) 1.0(25.4) MIN .107(2.7) .080(2.0)

SF10-005GTHRU SF10-06G Page: 2 RATINGS AND CHARACTERISTIC CURVE SF10-005G THRU SF10-06G FIG. 5-MAXIMUM NON-REPETITIVE FORWARD SURGE CURRENT 1 5 10 20 50 100 NUMBER OF CYCLES AT 60 Hz PEAK FORWARD SURGE CURRENT (A) 8.3 ms Single Half Sine Wave (JEDEC Method) FIG. 6-TYPICAL JUNCTION CAPACITANCE .1 .2 . 4 1 . 0 2 4 10 20 40 100 REVERSE VOLTAGE (V) 200 100

1 JUNCTION CAPACITANCE (pF)

SF10-005G~10-02G SF10-03G~10-06G TJ=25oC AVERAGE FORWARD CURRENT (A) 2.0 1.0 25 50 75 100 125 150 175 AMBIENT TEMPERATURE (oC) FIG. 2-TYPICAL FORWARD CURRENT DERATING CURVE Single Phase Half Wave 60 Hz Resistive or Inductive Load +0.5A -0.25A Trr 1cm SET TIME BASE FOR 10/20 ns/cm FIG. 3-TYPICAL REVERSE CHARACTERISTICS 0 2 0 40 60 80 100 120 140 PERCENT OF RATED PEAK REVERSE VOLTAGE (%) TJ=25oC INSTANTANEOUS REVERSE CURRENT (uA) 1000 100 1.0 0.1 FIG. 4-TYPICAL INSTANTANEOUS F ORWARD CHARACTERISTICS INSTANTANEOUS FORWARD VOLTAGE (V) SF10-005G~10-02G SF10-06G 1.0 .01 .001 INSTANTANEOUS FORWARD CURRENT (A) SF10-03G~10-04G FIG. 1-TEST CIRCUIT DIAGRAM AND REVERSE RECOVERY TIME CHARACTERISTIC P U L S E GENERATOR ( NOTE 2 ) (+) 25 V dc (approx) (-) D.U.T. NON INDUCTIVE OSCILLOSCOPE ( NOTE 1 ) 50Ω NO INDUCTIVE 100Ω NO INDUCTIVE (-) (+) NOTE: 1. RISE TIME=7ns MAX. INPUT IMPEDANCE=1 MOhms 22PF 2. RISE TIME =10ns MAX. SOURCE IMPEDANCE=50 OHMS