S5M1119

S5M1119 SECOS | Alldatasheet

Document overview

• Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
• PDF pages: 3

Technical content

Features

• 1.3V Max. Dropout Voltage At Full Load Current * Output Current Limiting * Good Noise Rejection * Fast Transient Response * Built-in Thermal Shutdown * Communication

Applications

• CDROM. * PC Peripheral 01-Jun-2002 Rev. A Page 1 of 3 http://www.SeCoSGmbH.com/ Any changing of specification will not be informed individual R o H S C o m p l i a n t P r o d u c t Typical Circuit GND VOUT VIN EN Name Function Ground Pin Descriptions The output pin of regulator. A min. of 10uF capacitor must be connected from this pin to ground to insure stability. The input pin of regulator. Typically a large storage capacitor is connected from this pin to does not sag below the min. dropout voltage during the load transient response. in order for the device to regulate properly. This input pin of regulator. TTL/CMOS compatiable input Logic high= disable output, Logic low or open=output enable. (internal pull-down resistor~100K) OUT1.3V higher than V input voltage ground to insure that the This pin must always be Pin# REF. Min. Max. REF. Millimeter A 4.40 4.60 G 3.00 REF. B 4.05 4.25 H 1.50 REF. C 1.50 1.70 I 0.40 0.52 D 1.30 1.50 J 1.40 1.60 E 2.40 2.60 K 0.35 0.41 F 0.80 - L 5 ° TYP. Millimeter Dimensions

Electrical Characteristics

S5M1119-1.5 S5M1119-1.8 S5M1119-2.5 S5M1119-3.3 S5M1119-5.0 S5M1119-9.0 S5M1119-12 S5M1119-1.5 S5M1119-1.8 S5M1119-2.5 S5M1119-3.3 S5M1119-5.0 S5M1119-9.0 S5M1119-12 S5M1119-XXX S5M1119-XXX S5M1119-XXX10_ 0.6 2.0 300 100 V _ 60 C o 0.5A,TJ=25 1,2 0.5A, 0.5A, 0.5A, 0.5A, 0.5 A, 0.5 A, C o TJ=25 1,2 C o TJ=25 1,2 C o TJ=25 1,2 C o TJ=25 1,2 C o TJ=25 1,2 C o TJ =25 1,2 IO=0.5 A, VOUT=0.1% VOUT VIN=VOUT+3V F=120Hz,COUT=25uF,Tantalum,IO=0.5AdB70 S5M1119-XXX Dropout Voltage (VIN-VOUT) Current Limit Min. Load Current Enable Input Voltage Thermal Regulation Ripple Rejection Temperature Stability 0.8 0 125 C o mA A TJ Line Regulation %__ 0.2 CIO=10mA,TJ=25 ,VOUT+1.5V<VIN<1 V Load Regulation mV VIN=3.0V,0mA<IO< 100 120 VIN=3.3V,0mA<IO< VIN=4.0V,0mA<IO< VIN=5.0V,0mA<IO< VIN=8.0V,0mA<IO< VIN=12.0V,0mA<IO< VIN=15.0V,0mA<IO< 1.1 1.4 C o Parameter Max.Typ. ConditionMin. Unit Output Voltage V VIN1.470 1.500 1.530 IO=10mA,TJ=25 ,3.0V 1 V 1.764 1.800 1.836 C o VINIO=10mA,TJ=25 ,3.3V 1 V C o VINIO=10mA,TJ=25 ,4.0V 1 V2.450 2.500 2.550 C o VINIO=10mA,TJ=25 ,4.8V 1 V3.235 3.300 3.365 4.900 5.000 5.100 C o VINIO=10mA,TJ=25 ,6.5V 1 V C o VINIO=10mA,TJ=25 ,10.5V 18V8.820 9.000 9.180 C o VINIO=10mA,TJ=25 ,13.5V 18V11.760 12.000 12.240 o _ (VIN-VOUT)=5V C o VEN V Logic Low (ON) Logic High (OFF) _Enable Input Current 10 IEN uA VEN=2.0V VEN=0.8V TA=25 C,30ms o pulse0.008 0.04 %W (Under operating conditions) qJA Thermal Resistance Junction-to-Ambient (No heat sink;No air folw) qJC Thermal Resistance Junction-to-Case Control Circuitry/Power Transistor IO=10mA% C/W o C/W _0.5 DC Supply Voltage Power Dissipation Storage Temperature Range Operating Juction Temperature Range Parameter Symbol Ratings Unit VVIN -0.3 to 18 0~+150 -65~+150 Absolute Maximum Ratings PD TST TOP C o C o Internally Limited Elektronische Bauelemente http://www.SeCoSGmbH.com/ Any changing of specification will not be informed individual 01-Jun-2002 Rev. A Page 2 of 3 Note 1: See thermal regulations for charges in output voltage due to heating effects. Line and load regulation are measured at a constant juction temperature by low duty cycle pulse testing. Load regulation is measured at the output lead =1/8" from the package. 2: Line and load regulations are guaranteed up to the max. power dissipation of 5W. Power dissipation is determined by the input/ output differential and the output current. Guaranteed max. power dissipation will not be available over the full input/output range. 3: Quiescent current is defined as the min. output current required to maintain regulation. At 12V input/output differential the device is guaranteed to regulate if the output current is greater than 10mA. S5M1119 0.5A Positive Low Dropout Fixed-Mode Regulator With EN Function ≤ ≤ ≤ ≤ ≤ ≤ ≤ ≤ ≤ ≤ ≤ ≤ ≤ ≤ ≤ ≤

01-Jun-2002 Rev. A Page 3 of 3 h tp://www.SeCoSGmbH.com/ Any changing of specification will not be informed individual Elektronische Bauelemente S5M1119 0.5A Positive Low Dropout Fixed-Mode Regulator With EN Function Characteristics Curve I load=500mA