S33201M AUK | Alldatasheet

Document overview

  • Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
  • PDF pages: 6

Technical content

Features

  • Low Voltage, Single Supply Operation (+1.8 V and Ground to +12 V and Ground)
  • Input Voltage Range Includes both Supply Rails
  • Output Voltage Swings within 50 mV of both Rails
  • No Phase Reversal on the Output for Over-driven Input Signals
  • High Output Current (I SC = 30 mA, Typ)
  • Low Supply Current (ICC = 0.9 mA, Typ)
  • 600Ω Output Drive Capability
  • Typical Gain Bandwidth Product = 2.2 MHz

Applications

  • Low cost general purpose applications • Cellular phones
  • A / D b u f f e r • D S P i n t e r f a c e
  • Smart card readers • Portable test instruments
  • Keyless entry • Telephone systems
  • Audio applications • Digital still cameras
  • H a r d d i s k d r i v e s • M P 3 p l a y e r s

Ordering Information

Type NO. Marking Package Code S33201M 332 SOT-25 SSeemmiiccoonndduuccttoorr

Outline Dimensions unit : mm Internal Block 2.60~3.00 0.95 Typ. 1.50~1.70 0.95 Typ. 2.80~3.00 0.45 Max. 1.00~1.20 0.19 Max. 0.10 Max. 0.40 Min. 3 4 Circuit Schematic

Characteristic Symbol Rating Unit Supply Voltage (VCC to VEE) V CC +13 V Input Differential Voltage Range V IDR Note1 V Common Mode Input Voltage Range (Note2) V CM VCC + 0.5V to VEE - 0.5V V Power Dissipation P D 0.5 W Operating Ambient Temperature Range T OPR -40 to 85 °C Storage Temperature T STG -55 to 150 °C Notes ; 1. The differential input voltage of each amplifier is limited by two internal parallel back-to-back diodes. for additional differential input voltage range, use current limiting resistors in series with the input Pins. 2. The input common mode voltage range is limited by internal diodes connected from the inputs to both supply rails. Therefore, the voltage on either input must not exceed either supply rail by more than 500mV. Electrical Characteristics (Ta=25 )℃ VCC (V) Characteristic 2.0 3.3 5.0 Unit VOH (Min) 1.9 3.15 4.85 V Output Voltage Swing (Note) VOL (Max) 0.10 0.15 0.15 V Supply Current I CC 1.125 1.125 1.125 mA Note : (RL = 10 ㏀)

Electrical Characteristics

(VCC = +5.0V, VEE = GND, Ta=25℃, unless otherwise noted.) Characteristic Symbol Test Condition Min. Typ. Max. Unit Input Offset Voltage V IOS VCM 0V to 0.5V, VCM 1.0V to 5.0V - - 6 ㎷ Input Offset Voltage Temperature Coefficient ∆VIO/∆T R S=50Ω - 2 - ㎶/℃ Input Bias Current I IB VCM=0V to 0.5V VCM=1.0V to 5.0V - 300 500 ㎁ Input Offset Current I IO VCM=0V to 0.5V VCM=1.0V to 5.0V - 5 50 ㎁ Common Mode Input Voltage Range VICR - V EE - V CC V S33201M

Electrical Characteristics (cont.) (VCC = +5.0V, VEE = GND, Ta = 25℃, unless otherwise noted.) Characteristic Symbol Test Condition Min. Typ. Max. Unit RL=10 ㏀ 50 300 - ㎸/V Large Signal Voltage Gain (VCC=+5V, VEE=-5V) AVOL RL=600Ω 25 250 - ㎸/V RL=10 ㏀ 4.85 4.95 - V VOH RL=600Ω 4.75 4.85 - V V Output Voltage Swing ID=±0.2V) VOL RL=600Ω - 0.15 0.25 V Common Mode Rejection CMR (V IN = 0V to 5.0V) 60 90 - dB Power Supply Rejection Ratio PSRR VCC/VEE = 5.0V/GND to 3.0V/GND 60 90 - dB Source Current I SO - 20 30 - ㎃ Output Short Circuit Current Sink Current I SI - 10 20 - ㎃ Supply Current I CC - - 0.9 1.5 ㎃ Slew Rate SR (VS=±2.5V, VO=-2.0V to 2.0V, Gain Bandwidth Product GBW - - 2.2 - ㎒ S33201M

Electrical Characteristic Curves Fig. 2 IIB vs VCC Fig. 1 ICC vs VCC Ω V Ω Fig. 4 VOL vs VCC Fig. 3 VOH vs VCC Ω Fig. 6 CMR vs f Fig. 5 VOP-P vs f

Fig. 8 GV vs f Fig. 7 ISC vs VOUT Ω The AUK Corp. products are intended for the use as components in general electronic equipment (Office and co mmunication equipment, m easuring equipment, home appliance, etc.). Please make sure that you consult with us before you use these AUK Corp. products in equipments which require high quality and / or reliability, and in equipments which could have major impact to th e welfare of human life(atomi c energy control, airplane, spaceship, transportation, co mbustion control, all types of safety device, etc.). AUK Corp. cannot accept liability to any damage which may occur in case these AUK Corp. products were used in the mentioned equi pments without prior consultation with AUK Corp.. Specifications mentioned in this publication are subject to change without notice.