KVP5 EDI | Alldatasheet

Document overview

  • Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
  • PDF pages: 2

Technical content

MATCHED SILICON RECTIFIER ELEMENTS RATED CURRENT TO 1.0 AMPERES PRV 5,000 TO 50,000 VOLTS FAST RECOVERY (RVP SERIES) ALL APPLICABLE MIL-STD-750 TESTS HIGH THERMAL CONDUCTIVITY ENCAPSULATION Max. Reverse Recovery Time , Trr (Fig.4) 300 nanosec Max. DC Reverse Current @ PRV and 25 oC, IR 250 Amps Storage Temperature Range, TSTG A Ambient Operating Temperature Range,TA Max. DC Reverse Current @ PRV and 100 oC, IR Amps8 A -55 to +150oC oC -55 to +150oC oC RVP SERIES FAST RECOVERY

ELECTRICAL CHARACTERISTICS

(at TA=25 C Unless Otherwise Specified) FRM Max.One-Half Cycle Surge Current, IFM (Surge )@ 60HzFRM Max. DC Reverse Current @ PRV and 25 oC, IR 100 Max.One-Half Cycle Surge Current, IFM Amps Storage Temperature Range, TSTG A Ambient Operating Temperature Range,TA (at TA=25 C Unless Otherwise Specified) Max. DC Reverse Current @ PRV and 100 oC, IR Amps10 A -55 to +150oC oC -55 to +150oC oC KVP SERIES STANDARD RECOVERY (Surge )@ 60Hz KILOVOLT RECTIFIER ASSEMBLIES EDI Type No. Peak Reverse Voltage PRV ( Volt s) Avg . Fwd .Cu rre nt IO at 25 oC (Am ps) o VF Dim ensi on L Inches Fig .3 STANDARD RECOVERY KVP5 5,000 1.00 8 2.5 KVP6 6,000 1.00 9 2.5 KVP7 7,000 1.00 10 3.0 KVP8 8,00 0 1.00 11 3.0 KVP9 9,000 1.00 14 3.0 KV P10 10,000 1.00 15 3.5 KV P15 15,000 1.00 21 5.0 KV P20 20,000 .75 26 5.5 KV P25 25,000 .75 32 6.0 KVP30 30,000 .75 39 6.0 KV P35 35,000 .75 46 6.5 KV P40 40,000 .75 53 6.5 KV P50 50,000 .75 65 7.0 ND RECOVERY (FIG.4)200 NANOSECO RVP5 5,000 .90 10 2.5 RVP6 6,000 .90 11 2.5 RVP7 7,000 .90 12 3.0 RV P8 8,000 .90 13 3.0 RV P9 9,000 .90 16 3.0 RV P10 10,000 .90 17 3.5 RV P15 15,000 .90 25 5.0 RV P20 20,000 .70 30 5.5 RV P25 25,000 .70 36 6.0 RVP30 30,000 .70 43 6.0 RVP35 35,000 .70 50 6.5 RVP40 40,000 .70 58 6.5 RVP50 50,000 .70 72 7.0 Forward Current Repetitive Peak,I Forward Current Repetitive Peak,I C Inch es Fig .3 Dim ensi on 3 8/ 3 8/ 14/ 1 4/ EDI reserves the right to change these specifications at any time without notice. Max. Fwd Voltage Drop at 25 C and 1A. (Volts)

FIG.1 OUTPUT CURRENT vs AMBIENT TEMPERATURE FIG.2 FIG.3 21 GRAY OAKS AVENUE * YONKERS. NEW YORK 10710 914-965-4400 * FAX 914-965-5531 * 1-800-678-0828 ELECTRONIC DEVICES, INC. DESIGNERS AND MANUFACTURERS OF SOLID STATE DEVICES SINCE 1951. AMBIENT TEMPERATURE ( O % RATED FWD CURRENT It is recommended that a proper heat sink be used on the terminals of this device between the body and the soldering point to prevent damage form excess heat. Ee-mail:sales@edidiodes.com Wwebsite: http://www.edidiodes.com* R R1, 2 NON-INDUCTIVE RESISTORS PULSE GENERATOR - HEWLETT PACKARD 214A OR EQUIV. IKC REP.RATE, 10 SEC. PULSE WIDTH ADJUST PULSE AMPLITUDE FOR PEAK IR TEST CIRCUIT FIG.4 TYPICAL REVERSE RECOVERY WAVEFORM PULSE GENERATOR D.U.T. SCOPER2

1 OHM

50 OHM

1.0A 0.5A TRR ZERO REFERENCE 0.25A 8 MAX.L 16-32 THREAD X / DEEP4 (2) MTG. INSERTS CASE STYLE A KVP RVP NON-REPETITIVE SURGE CURRENT RATINGS 100 1 2 3 4 5 6 7 9 10 20 30 40 50 608 CYCLES(60 Hz) 0.1SEC 1.0SEC % MAXIMUM SURGE (ALL DIMENSIONS IN INCHES) C