DATASHEET SEARCH SITE | WWW.ALLDATASHEET.COM
Document overview
- Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
- PDF pages: 6
Technical content
RFeIC® is a registered trademark of RFaxis, Inc. All rights reserved. This product document and the RFX8055 are subject to change without notice. 1 Skyworks Solutions, Inc. • Phone [781] 376-3000 • Fax [781] 376-3100 • sales@skyworksinc.com • www.skyworksinc.com Rev 3.2 May ‘15 RFX8055 Production Data Sheet CMOS 5GHz WLAN 802.11a/n/ac RFeIC WITH PA, LNA, AND SPDT
Description
RFX8055 is a highly integrated, single-chip, single-die RFeIC (RF Front-end Integrated Circuit) which incorporates key RF functiona lity needed for IEEE 802.11a/n/ac WLAN systems operatin g in the 5.1-5.95GHz range. The RFX8055 architecture integrates a high-efficiency high-linearity power amplifier (PA), a low noise amplifier (LNA) with bypass, the associated matching network, LO rejection, and har monic filters all in a CMOS single- chip device. RFX8055 has simple and low-voltage CMOS control logic, and requires minimal external components. A directional coupler based power detect circuit is also integrated for accurate monitoring of output power from the PA. RFX8055 is assembled in an ultra-com pact low-profile 2.3x2.3x0.4 mm 16- lead QFN package. With support to direct battery operation, the RFX8055 is ideal RF front-end solution for implementing 5GHz WLAN in smartphones and other mobile platforms.
Applications
802.11a/n/ac Smartphones Tablets/MIDs Consumer Electronics Notebook/Netbook/Ultrabooks Mobile/Portable Devices Access Points / Gateways Other 5GHz ISM Platforms
FEATURES
5GHz WLAN Single Chip, Single-Die RF Front-End IC High Transmit Signal Linearity Meeting Standards for 802.11ac OFDM /MCS9 Modulation Separate TX, RX Transceiver Ports, Single Antenna Port 5GHz Power Amplifier with Low-Pass Harmonic Filter Low Noise Amplifier with Bypass Mode Transmit/Receive Switch Circuitry Integrated Power Detector for Transmit Power Monitor and Control Low Voltage (1.2V) CMOS Control Logic Low-Current Mode in TX for Battery Current Savings ESD Protection Circuitry on all Pins DC Decoupled RF Ports Internal RF Decoupling on All VDD Bias Pins Low Noise Figure for the Receive Chain High Power Capability for Received Signals in Bypass Mode Low DC Power Consumption On-chip Matching Circuit with 50Ω Input/Output Minimal External Components Required Market Proven Bulk CMOS Technology 2.3mm x 2.3mm x 0.4mm Small Outline 16L RoHS and REACH Compliant
RFeIC® is a registered trademark of RFaxis, Inc. All rights reserved. This product document and the RFX8055 are subject to change without notice. 2 Skyworks Solutions, Inc. • Phone [781] 376-3000 • Fax [781] 376-3100 • sales@skyworksinc.com • www.skyworksinc.com Rev 3.2 May ‘15 RFX8055 Production Data Sheet PIN-OUT DIAGRAM: (Top “See-Through” View) PIN ASSIGNMENTS: Pin Number Pin Name Description 10, 11, 15 NC Internally Not Connected
2 RX RF Output Port from LNA or Bypass – DC Shorted to GND
4 VDD DC Supply Voltage
5 DET Analog Voltage Proportional to the PA Power Output
6 PA_EN CMOS Input to Control TX Enable
8 TX RF Input Port from the Tr ansceiver – DC Shorted to GND
9 VMODE CMOS Input to Control High-Linearity/Low-Current Mode
13 ANT Antenna Port (RF Signal from the PA or RF Signal Applied to the LNA) –
16 LNA_EN CMOS Input to Control RX Enable
1, 3, 7, 12, 14 GND Ground – Must Be Conn ected to GND in the Application Circuit
RFeIC® is a registered trademark of RFaxis, Inc. All rights reserved. This product document and the RFX8055 are subject to change without notice. 3 Skyworks Solutions, Inc. • Phone [781] 376-3000 • Fax [781] 376-3100 • sales@skyworksinc.com • www.skyworksinc.com Rev 3.2 May ‘15 RFX8055 Production Data Sheet ABSOLUTE MAXIMUM RATINGS: Parameters Units Min Max Conditions DC VDD Voltage Supply V -0.3 4.0 At VDD Pin DC Control Pin Voltage V -0.3 3.6 All Control Pins DC Voltage at Det Pin V -0.3 3.6 Exte rnal voltage applied to Detector Pin DC VDD Current Consumption mA 400 Through VDD Pin when TX is “ON” TX RF Input Power dBm +7 CW and all modulation types in accordance with 802.11a/n/ac standard ANT RF Input Power dBm +10 Junction Temperature oC 150 Storage Ambient Temperature oC -40 +150 Appropriate care required according to JEDEC Standards Operating Ambient Temperature oC -20 +85 Moisture Sensitivity MSL1 Note: Sustained operation at or above the Absolute Maximum Ratings for any one or combinations of the above parameters may result in permanent damage to the device and is not recommended. All Maximum RF Input Power Ratings assume 50-Ohm terminal impedance. NOMINAL OPERATING CONDITIONS: Parameters Units Min Typ Max Conditions DC VDD Voltage Supply (Note 1) V 3.0 3.3 3.6 All VDD Pins Control Voltage “High” (Note 2) V 1.2 * * 3.6V or VDD Whichever is Lower Control Voltage “Low” V 0 0.4 DC Control Pin Current Consumption μA 1 DC Shutdown Current μA 3 PA Turn On/Off Time μsec 0.4 LNA Turn On/Off Time μsec 0.4 jc (Note 3) oC/W 27 ja oC/W 64 Note 1: For normal operation of the RFX8055, VDD must be continuously applied to VDD supply pin. Note 2: If control voltage can exceed 1.8V, a 1KΩ – 10KΩ series resistor is recommended for the application circuit on each control line. Note 3: Thermal measurements were performed on an RFaxis test EVB under typical use conditions. Please contact RFaxis for details regarding the test conditions and the configuration of the thermal vias on the EVB. Refer to “PCB Land Pattern” for recommended thermal vias.
RFeIC® is a registered trademark of RFaxis, Inc. All rights reserved. This product document and the RFX8055 are subject to change without notice. 4 Skyworks Solutions, Inc. • Phone [781] 376-3000 • Fax [781] 376-3100 • sales@skyworksinc.com • www.skyworksinc.com Rev 3.2 May ‘15 RFX8055 Production Data Sheet TRANSMIT PATH CHARACTERISTICS HIGH LINEARITY MODE (VDD=3.3V; T=+25 oC) Parameters Units Min Typ Max Conditions Operating Frequency Band GHz 5.1 5.95 Linear Output Power 1 dBm +16.5 For DEVM<1.8%, 802.11ac, MCS9/VHT80 Linear Output Power 2 dBm +17 For DEVM<2.5%, 802.11n, MCS7/HT40 Linear Output Power 3 dBm +17.5 For DEVM<3%, 802.11a, 64QAM/54Mbps Linear Output Power 4 dBm +20.5 For MCS0/6Mbps, 802.11a Mask Compliance with 1.5dB Margin Small-Signal Power Gain dB 27 TX Quiescent Current mA 150 No RF Applied TX Linear Current mA 230 P OUT = +18dBm Power Detector Voltage Output mV 200-1400 P OUT = +8 to +20dBm, 10kΩ Load Second Harmonic dBm/MHz -30 P OUT=+20dBm, 802.11a, MCS0, 6Mbps Third Harmonic dBm/MHz -25 P OUT=+20dBm, 802.11a, MCS0, 6Mbps Input Return Loss dB -10 At TX Pin Output Return Loss dB -10 At ANT Pin TRANSMIT PATH CHARACTERISTICS LOW CURRENT MODE (VDD=3.3V; T=+25 oC) Parameters Units Min Typ Max Conditions Operating Frequency Band GHz 5.1 5.95 Linear Output Power 1 dBm +14.5 For DEVM<1.8%, 802.11ac, MCS9/VHT80 Linear Output Power 2 dBm +15 For DEVM<2.5%, 802.11n, MCS7/HT40 Linear Output Power 3 dBm +16 For DEVM<3%, 802.11a, 64QAM/54Mbps Linear Output Power 4 dBm +20 For MCS0/6Mbps, 802.11a Mask Compliance with 1.5dB Margin Small-Signal Power Gain dB 26 TX Quiescent Current mA 110 No RF Applied TX Linear Current mA 205 P OUT = +18dBm
RFeIC® is a registered trademark of RFaxis, Inc. All rights reserved. This product document and the RFX8055 are subject to change without notice. 5 Skyworks Solutions, Inc. • Phone [781] 376-3000 • Fax [781] 376-3100 • sales@skyworksinc.com • www.skyworksinc.com Rev 3.2 May ‘15 RFX8055 Production Data Sheet RECEIVE PATH CHARACTERISTICS (VDD=3.3V; T=+25 oC) Parameters Units Min Typ Max Conditions Operating Frequency Band GHz 5.1 5.95 All RF Pins are Loaded by 50- Ohm Gain dB 13 Receive Mode, LNA On Noise Figure dB 2.9 Receive Mode, LNA On DC Quiescent Current mA 13 No RF Applied, Through VDD Pin Receive IIP3 dBm +5 Minimum value over PVT IIP3=0dBm LNA Bypass Mode Insertion Loss dB 6 LNA Bypass Mode Current μA 3 LNA Off, No RF applied, through VDD Pin Input Return Loss dB -9 At ANT Pin Output Return Loss dB -9 At RX Pin RF Port Impedance Ohm 50 CONTROL LOGIC TRUTH TABLE Note: “1” denotes high voltage state (> 1.2V) “0” denotes low voltage state (<0.4V) at Control Pins “X” denotes the don’t care state 1KΩ – 10KΩ series resistor may be required for each control line PA_EN LNA_EN VMODE Mode Of Operation 0 0 X Shutdown/LNA Bypass Mode 1 0 0 High Linearity Transmit Mode 0 1 X Receive Mode, LNA On 1 0 1 Low Current Transmit Mode 1 1 X Low Current Transmit Mode All Others Unsupported (No Damage)
RFeIC® is a registered trademark of RFaxis, Inc. All rights reserved. This product document and the RFX8055 are subject to change without notice. 6 Skyworks Solutions, Inc. • Phone [781] 376-3000 • Fax [781] 376-3100 • sales@skyworksinc.com • www.skyworksinc.com Rev 3.2 May ‘15 RFX8055 Production Data Sheet PACKAGE DIMENSIONS (All Dimensions in mm): PCB LAND PATTERN PACKAGE MARKING (With Recommended Thermal Vias) First Line: Part Number Second Line: Lot Number Pin 1 Mark