RC1XXX-MPC1 RADIOCRAFTS | Alldatasheet

Document overview

  • Manufacturer or author: PME
  • PDF pages: 3

Technical content

Features

 2 pulse inputs with programmable pull-up.  Tamper input  Install input  OTA (Over The Air configuration)  Encryption  Configurable TX intervals  Embedded Wireless M-Bus protocol supporting EN EN13757-4:2013 mode T (868 MHz, -MBUS3) and mode N (169 MHz, -MBUS4)  12.7 x 25.4 x 3.3 mm compact module for SMD mounting  Ultra low power modes for extended battery lifetime  Completely Shielded module for SMD mounting  No external components Quick module overview The MPC1 protocol is running in same module as RC1180-MBUS3 for 868 MHz and RC1701HP-MBUS4 for 169 MHz. For hardware and RF performance details please see RC1701HP-MBUS4/RC1180-MBUS3 data sheet. Module Frequency band Max output Power RC1180-MPC1 868 MHz +10 dBm RC1701HP-MPC1 169 MHz +27 dBm RC1701-MPC1 169 MHz +14 dBm MPC1 Embedded Protocol The MPC1 protocol is described in details in the MPC1 User Manual.

Embedded Wireless Solutions RC1xxx-MPC1 2015 Radiocrafts AS RC1xxx-MPC1 Shortform Datasheet (rev. 1.0) Page 2 of 3 Pin Assignment Pin 31-42 is not available for RC1180-MPC1. Pin Description Pin no Pin name Description

1 GND System ground

2 CTS UART Clear to Send / RXTX control (RS485)

3 RTS UART Request to Send

4 CONFIG Configuration Enable. Active low.

5 TXD UART TX Data

6 RXD UART RX Data

7 GND System ground

8 GND System ground

9 RF RF I/O connection to antenna

10 GND System ground

11 VDD Not Connected, Internal Regulator Output

12 Reset RESET_N. Active Low 13 VCC Supply voltage input. Internally regulated.

14 GND System ground

17 INSTALL Pull to ground to start installation message transmission

18 TAMPER Tamper input

27 PULSE1 Interrupt pulse counter

28 PULSE2 Interrupt pulse counter

29 STATUS LED1 LED output for status

30 STATUS LED0 LED output for status

41 VCC_PA Supply voltage for high power variant (RC1701HP-MPC1). 15-16 I/O For future use and test status pin, Do not connect 19-26 I/O For future use and test status pin, Do not connect 31-40 I/O For future use and test status pin, Do not connect

42 I/O For future use and test status pin, Do not connect

Embedded Wireless Solutions RC1xxx-MPC1 2015 Radiocrafts AS RC1xxx-MPC1 Shortform Datasheet (rev. 1.0) Page 3 of 3 Mechanical Drawing Mechanical Dimensions The module size is 12.7 x 25.4 x 3.3 mm © 2015 Radiocrafts AS. All rights reserved. Radiocrafts AS, Sandakerveien 64, NO-0484 OSLO, NORWAY E-mail: sales@radiocrafts.com Web site: www.radiocrafts.com Phone: (+47) 4000 5195 Fax: (+47) 22 71 29 15