PMK320E ASTRODYNE | Alldatasheet
Document overview
- PDF pages: 4
Technical content
320 Watt Enclosed Switching Power Supply with PFC PMK320E series
WWW.ASTRODYNETDI.COM ASTRODYNE USA: 1-800-823-8082 ASTRODYNE PACIFIC: 886-2-26983458 3.86”W x 8.03”L x 1.57”H
320 Watts Output Power
4242VDC Input to Output Isolation Active Power Factor Correction Model Number Output Voltage Output Amps (max) Ripple & Noise max. Efficiency SINGLE OUTPUT PMK320S-5E 5 VDC 60 100mV pk-pk 71% PMK320S-12E 12 VDC 26.7 120mV pk-pk 77% PMK320S-15E 15 VDC 21.4 150mV pk-pk 79% PMK320S-24E 24 VDC 13.4 150mV pk-pk 79% PMK320S-36E 36 VDC 8.9 150mV pk-pk 81% PMK320S-48E 48 VDC 6.7 150mV pk-pk 81% All specifications are typical at nominal input, full load, and 25°C unless other- wise noted
WWW.ASTRODYNETDI.COM ASTRODYNE USA: 1-800-823-8082 ASTRODYNE PACIFIC: 886-2-26983458 INPUT SPECIFICATIONS Input Voltage Range 90-264 VAC; Nom: 100-240VAC Frequency Range 47-63 Hz Power Factor Correction 0.95, min. Nom I/P, FL IInrush Current (115/230 I/P) 30A / 60A Cold Start, FL* Input Current (LL/HL) 5.4 Amps max. / 1.8 Amps max. Leakage Current <3.5mA, 240Vin, 50Hz OUTPUT SPECIFICATIONS Voltage and Current See Selection Chart Line Regulation (LL-HL) ±1%, max. (±1.5% 5 Vout) Load Regulation 10%-FL ±1~1.5%, max. Preset Accuracy (Note 3) ±1%, typ (±2% 5 Vout) Ripple/Noise (Notes 1, & 4) See Selection Chart Over Voltage Protection 130% max. Auto Recovery * Over Current Protection 160% max. Auto Recovery * Short Circuit Protection Auto Recover after fault condition is removed * Turn On Delay Time <4S Rise Time <25mS, typ (Nom I/P, FL) Hold Up Time 20mS, typ (Nom I/P, FL) Over-Shoot/Under Shoot <10% of Nominal Output Remote Sense Compensates for up to 0.5V drop Remote Shutdown Open Collector, Logic “1” = ON “0” = Off. No Termination necessary to maintain constant “On” operation GENERAL SPECIFICATIONS Isolation (Note 2) I/P-O/P: 4242VDC I/P-Ground: 2121VDC O/P-Ground: 707VDC Insulation Resistance ≥20MΩ Efficiency (FL. Nom I/P) See Selection Chart Safety UL/cUL: UL60950-1 2nd ed./ C22.2 60950-1 2nd ed. UL-EU: EN60950-1 2nd ed. CE: EN60601-1-2 CB: IEC60950-1 2nd ed. ENVIRONMENTAL SPECIFICATIONS Oper. Temperature -20 to +70°C (See Derate Curve) Storage Temperature -25 to +85°C * Relative Humidity 10% to +90%, * Storage: 5-95% EMS Harmonics Class D, 61000-3-2 Fluctuations 61000-3-3 ESD 61000-4-2 RS 61000-4-3 EFT 61000-4-4 Surge 61000-4-5 CS 61000-4-6 MS 61000-4-8 DIPS 61000-4-11 EMI EN55022 Class B MTBF Mil Std 217F, 25°C 65,000 Hrs, min. Vibration 4G Peak, 50-500Hz, 3 Axes Drop Test 70 CM PHYSICAL SPECIFICATIONS Size 8.03”(L) x 3.86”(W) x 1.57”(H) Construction Enclosed Weight 1.75 lb, (794g) NOTES 1. All measurements should be made directly at the terminals of the power supply 2. Isolation for up to 1 minute duration. 3. Preset Accuracy measured at nominal load, 120VAC input. 4. O/P Noise measured directly at the pins/terminals at nominal load, 0.1uF ceramic bypass and 47uF electrolytic, pk-pk @ 20MHz bandwidth. These are stress ratings. Exposure of the devices to any of these conditions may adversely affect long term reliability. Proper operation under conditions other than the standard operating conditions is neither warranteed nor implied.
WWW.ASTRODYNETDI.COM ASTRODYNE USA: 1-800-823-8082 ASTRODYNE PACIFIC: 886-2-26983458 3.86 178 7.01 203.9 8.03 FG ACL 110 4.33 1.57 1.50 23.9 .94 .83 ACN 151.1 5.95 50.8 2.00 23.6 .93 12.7 .50 +Vo(5V) COM COM COM +Vo+Vo-S +SS/D GND UNITS:mm (in) WEIGHT: PMMK320-A193 PROPRIETARY AND CONFIDENTIAL THE INFORMATION CONTAINED IN THIS DRAWING IS THE SOLE PROPERTY OF <INSERT COMPANY NAME HERE>. ANY REPRODUCTION IN PART OR AS A WHOLE WITHOUT THE WRITTEN PERMISSION OF <INSERT COMPANY NAME HERE> IS PROHIBITED. COMMENTS: SHEET 1 OF 1 Q.A. MFG APPR. ENG APPR. CHECKED DRAWN DATENAMEDIMENSIONS ARE IN INCHES TOLERANCES: FRACTIONAL ANGULAR: MACH BEND TWO PLACE DECIMAL THREE PLACE DECIMAL NEXT ASSY USED ON APPLICATION DO NOT SCALE DRAWING FINISH MATERIAL REV. A DWG. NO.SIZE SCALE:1:1 MECHANICAL DIMENSIONS M3 hole size Input connector: 3P/ 8.25mm pitch terminal block Output connector: 6P/ 8.25mm pitch terminal block
WWW.ASTRODYNETDI.COM ASTRODYNE USA: 1-800-823-8082 ASTRODYNE PACIFIC: 886-2-26983458 OUTPUT DERATING CURVE AAASSSTTTRRROOODDDYYYNNNEEE PPPAAACCCIIIFFFIIICCC CCCOOORRRPPP EEELLLEEECCCTTTRRRIIICCCAAALLL SSSPPPEEECCCIIIFFFIIICCCAAATTTIIIOOONNN 7. Derating Curve 20% 40% 60% 80% 100% 120% Load(%) Ambient (℃) Input voltage (VAC) 60Hz Ta=25℃ 1. 5V 2. 12、15、24、36、48V 4214