DATASHEET SEARCH SITE | WWW.ALLDATASHEET.COM

Document overview

  • Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
  • PDF pages: 3

Technical content

Universal AC input/ Full Range Built-in Active PFC function, PF 0.95 Typical High Efficiency (Up to 84%) Output Protections: OVP/SCP/OTP PLC-025S062D PLC-025S070D PLC-025S105D PLC-025S140D PLC-025S175D 25Watts Single Output LED Driver PLC-025 D SeriesQualtek Electronics Corporation P P C Page 1 of 3 Output Characteristics Input Characteristics Protection Environmental Characteristics Characteristics Model Rated Current See Note Voltage Range Ripple and Noise (max) Note 1 Voltage Accuracy Line Regulation Load Regulation Rise Time Hold-up Time (Typ.) Voltage Range Frequency Range Power Factor (Typical) Efficiency (Typical) AC Current (max) Inrush Current (max) Leakage Current Over Temperature (OTP) Over Voltage (OVP) Note 2 Short Circuit (SCP) Operating Temperature Operating Relative Humidity Storage Temperature Vibration Waterproof Rating Safety Standards Withstand Voltage Isolation Resistance EMC Emission EMC Immunity Life Time MTBF (MIL-HDBK-217F) Dimension (LxWxH) Note Features: 0.35A (1) 24~72V ±10% Vo ±5% Vo ±1% Vo ±5% Vo 20mS Max @ Rated Load 8.5mS Min (110VAC input, full load), 10mS Min (220VAC input, full load) 0.70A (3) 12~36V 1.05A (3) 8~24V 1.40A (3) 6~18V 1.75A (3) 5~14V 90VAC~305VAC 47Hz-63Hz >0.95 >0.90 84% 0.35A @ 100-277VAC Input Full Load 65A @ 230VAC, 25°C 0.5mA max @ 277VAC >0.95 >0.90 83% >0.95 >0.90 82% >0.95 >0.90 81% >0.95 >0.90 81% 110°C (Temperature of internal components); shut down, auto recover after the temperature decreases 1.2~1.7Vo Long-term mode, auto recovery -35°C~50°C 5% RH to 95% RH -40°C~85°C, 5% to 100% RH non-condensing 10 to 300Hz sweep at constant acceleration of 1.0G(Breadth: 3.5mm) for 1 Hour for each of the perpendicular axes X, Y, Z IP65 UL8750, Compliance to UL1012 UL935, IEC61347 L/N-GND: 4kV, L-N: 2kV I/P-O/P: >100M Ohms / 500VDC / 25°C / 70% RH Compliance to EN55022(CISPR22) Class B, EN61000-3-2 Class A, EN61000-3-3 Compliance to EN61000-3-2, 3 EN61000-4-2, 3, 4, 5, 6, 8, 11, EN61547 More than 78,000Hrs (25°C, 80% Load) More than 488,000Hrs (25°C, 80% Load) 80x78x27mm 1. Ripple & Noise: Measured by 20 MHz bandwidth oscilloscope and the output paralleled with a 0.1 uF ceramic capacitor and a 10 uF electrolytic capacitor. 2. Latch Mode: The power supply shall return to normal operation only after the power is turned on again (1) Non-Class 2 output (USR & CNR) (2) Class 2 output (USR); Non-Class 2 output (CNR) (3) Class 2 output (USR & CNR) Lightning Protection PLC-025S208D 2.08A (3) 4~12V >0.95 >0.90 80% 0.62A (2) 13~40V >0.95 >0.90 83% PLC-025S035D Waterproof (IP65) PLC-025S045D 0.45A (2) 19~56V >0.95 >0.90 84% Constant Current Design

3 Year Warranty

Class 2 Power Unit (See Note) Dimming Control

25Watts Single Output LED Driver PLC-025 D SeriesQualtek Electronics Corporation P P C ISO-9001 Com pany www. qualteku sa.com Page 2 of 3 DIMMING CONTROL V 1-10V INPUT (PURPLE) GND(GREEN) 1-10VdcPLC-025SXXXD 10V OUTPUT (YELLOW) GND(GREEN) 20K PLC-025SXXXD 1-10V INPUT(PURPLE) The dimmer control may be operated from either a potentiometer or from an input signal of 1 – 10 Vdc. Two recommended implementations are provided below. Implementation 1: DC Input Implementation 2: Potentiometer Control Io/Ir Vs Vdim 20% 40% 60% 80% 100% 0 1 2 3 4 5 6 7 8 9 10 11 Vdim(V) Io/Ir Notes: 1. Io is actual output current and Ir is rated current. 2. If the dimming function is not used, please short 10 V output pin (yellow) and 1-10 V input pin(purple). The output current is about 92% Ir when the 1-10V input pin is /f_loating. 3. For the driver to operate properly, the load voltage must be maintained above the minimum voltage threshold (approx. 33% of the max. output voltage for any given model). 4. The dimming voltage can be tuned down to less than 1V, and the output current will be decreased to about 10% Ir; but the connected LEDs may /f_licker. Keeping dimming voltage greater than 1V is strongly recommended. 5. Do not connect the GND of dimming to the output; otherwise, the LED driver will not work normally.

25Watts Single Output LED Driver PLC-025 D SeriesQualtek Electronics Corporation P P C ISO-9001 Com pany www. qualteku sa.com Page 3 of 3 MECHANICAL SPECIFICATIONS UNIT: mm Derating Curve 100 90 120 150 180 210 240 270 300 330 Input Voltage(V) Load(%) Ambient Temperature vs.Load 100 -35 -20 -5 10 25 40 55 70 Ambient Temperature(℃) Load（%） Yellow Purple Green Rev. B