PE4321

PE4321 PASTERNACK | Alldatasheet

Document overview

• Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
• PDF pages: 1

Technical content

-5706 ASSEMBLY PROCEDURES 1. SLIDE CLAMP NUT (1), WASHER (2) & GASKET (3) OVER CABLE. STRIP CABLE AS SHOWN. DO NOT NICK BRAID WHILE CUTTING JACKET. TAPER END OF BRAID TO PERMIT ASSEMBLY OF BRAID CLAMP (4). SLIDE BRAID CLAMP (4) OVER BRAID & SEAT AGAINST CABLE. =| _ .300 123 PASTERNACK ENTERPRISES, INC. P.O BOX 16759, IRVINE, CA 92623 2. FORM BRAID OVER CLAMP NUT (4). TRIM BRAID BACK TO SHOULDER. CUT PHONE (949) 261-1920 FAX (949) 261-7451 DIELECTRIC & CENTER CONDUCTOR TO DIMENSION SHOWN. DO NOT NICK CENTER CONDUCTOR. SOLDER CONTACT TO CENTER CONDUCTOR. REMOVE EXCESS SOLDER. ‘EMAS ADDRESS: caleceieentoraaciocom DO NOT OVER HEAT DIELECTRIC. INSERT CABLE ASSEMBLY INTO BODY & TIGHTEN. PASTERNACK ENTERPRISES COANIAL FIBER OPTICS a3 rua [~ .200 DWG TITLE DES. BNC FEMALE, CLAMP ATTACHMENT FOR 1 4 PE4321 RG174, RG188 & RG316 ilies face «| FSCM NO. 2010 [ cone om [onewm] [or] 050 NOTE: INSERT PTFE BEFORE CONTACT. - , WITH LARGE OPEN END SLIDING |notes: OVER CENTER CONDUCTOR & 1, UNLESS OTHERWISE SPECIFIED ALL DIMENSIONS ARE NOMINAL. DIELECTRIC. 2. ALL SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE AT ANY TIME.