PCB1B-WKEY EMERSON-NETWORKPOWER | Alldatasheet
Document overview
- Manufacturer or author: Provided By alldatasheet.com(free datasheet download site)
- PDF pages: 1
Technical content
2.125" [53.98] 2.4" [60.96] Unprotected Pair 2 Unprotected Pair 1 Protected Pair 2 Protected Pair 1 Keying Pin Even TerminalsOdd Terminals Field Side Electronics Side 1.0” [25.40] { } NOTE: DO NOT daisy chain grounds. NOT intended for shield termination. Install ground in accordance with all applicable codes. PCB1B-WKEY Installation Instructions Terminal Assignments Feature ■ Accommodates 26 to 10 AWG Wires Edco PCB1B-WKEY Card Edge Terminal Connector Edco’s PCB1B-WKEY base was designed to accommodate up to 10 AWG wire. In addition, it offers flat/phillips terminal screws. The Edco PCB1B-WKEY can be mounted using two #6 size screws. The Edco PCB1B-WKEY is the standard socket for all of Emerson Network Power’s plug-in style surge suppressor modules including the Edco PC642, PHC, SLCP, PC2TEL, 5W8-30 and others. General Technical Specifications Dimensions (in / mm) 0.0775˝ H x 1.0˝ W x 2.4˝ L [2 x 25.4 x 61 mm] Emerson Network Power Contact information Surge Protection
100 Emerson Parkway
Binghamton, NY 13905 T: (607) 721-8840 T: (800) 288-6169 F: (607) 722-8713 E: SurgeTech@Emerson.com IO-50115 5/14 Rev. 2 Printed in USA www.EmersonNetworkPower.com/Surge While every precaution has been taken to ensure accuracy and completeness herein, Emerson Network Power Surge Protection assumes no responsibility, and disclaims all liability, for damages resulting from use of this information or for any errors or omissions. Specifications are subject to change without notice. Emerson Network Power, the Emerson Network Power logo and Edco are trademarks and service marks of Emerson Electric Co. ©2014 Emerson Electric Co. Seulement le personnel qualifié doit installer ou maintenir ce systéme. Des précautions de sécurité en électricité doivent être suivis lors de l’installation ou de la maintenance de cet equipement. Pour eviter tout risque de choc électrique, débranchez et verouiller toutes les sources d’alimentation de cet equipement avant de. Only qualified personnel should install or service this system. Electrical safety pre-cautions must be followed when installing or servicing this equipment. To prevent risk of electrical shock, turn off and lock out all power sources to the unit before making electrical connections or servicing. V DANGER!