P2011N-DA

P2011N-DA NKK | Alldatasheet

Document overview

• Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
• PDF pages: 5

Technical content

NKK Switches • email: sales@nkkswitches.com • Phone (480) 991-0942 • Fax (480) 998-1435 • www.nkkswitches.com 03-07 Internationally Approved Rockers/Paddles Series P Distinctive Characteristics International certifications from UL, CSA, VDE, SEMKO, and SEV. Contacts of special silver alloy resist arcing and guarantee stable electrical contact and long life. Stainless steel frame resists corrosion and increases environmental safety. High insulating barriers increase isolation of circuits in double pole devices and provide added protection to contact points. Case/base of heat resistant resin meets UL94V-0 flammability standard. Prominent external insulating barriers increase insulation resistance and dielectric strength. Clinching of the frame to the case well above the base and terminals provides 4,000V dielectric strength. Epoxy sealed terminals prevent entry of flux, solvents, and other contaminants. Actual Size

NKK Switches • email: sales@nkkswitches.com • Phone (480) 991-0942 • Fax (480) 998-1435 • www.nkkswitches.com 03-07 Internationally Approved Rockers/Paddles Series P General Specifications Electrical Capacity Resistive Load: 10A @ 125V AC or 6A @ 250V AC Motor Load: 400W @ 125V AC Lamp Load: 2A @ 125V AC for On-Off-On circuit & 3A @ 125V AC for other circuits Other Ratings Contact Resistance: 10 milliohms maximum Insulation Resistance: 1,000 megohms minimum @ 500V DC Dielectric Strength: 2,000V AC minimum between contacts for 1 minute minimum; 4,000V AC minimum between contacts & case for 1 minute minimum Mechanical Life: 50,000 operations minimum Electrical Life: 25,000 operations minimum Angle of Throw: 25° Materials & Finishes Frame: Stainless steel Case/Base: Diallyl phthalate resin (UL94V-0) Movable Contacts: Silver alloy with silver plating Stationary Contacts: Pure silver with silver plating Terminals: Copper with silver plating Environmental Data Operating Temp Range: –10°C through +85°C (+14°F through +185°F) Humidity: 90 ~ 95% humidity for 96 hours @ 40°C (104°F) Vibration: 10 ~ 55Hz with peak-to-peak amplitude of 1.5mm traversing the frequency range & returning in 1 minute; 3 right angled directions for 2 hours Shock: 50G (490m/s2) acceleration (tested in 6 right angled directions, with 5 shocks in each direction) Installation Soldering Time & Temp: Wave Soldering (Straight PC): See Profile A in Supplement section. Manual Soldering: See Profile A in Supplement section. Standards & Certifications Flammability Standards: UL94V-0 rated case/base UL Recognized: All models recognized at 10A @ 125V AC & 6A @ 250V AC; UL File No. WOYR2.E44145. C-UL Recognized: All models recognized at 10A @ 125V AC & 6A @ 250V AC; C-UL File No. WOYR8.E44145. CSA Certified: Single pole models certified at 10A @ 125V AC & 6A @ 250V AC; CSA File No. 023535-0-000. VDE Approved: All models approved at 10A @ 125V AC & 6A @ 250V AC; VDE License No. 119174. Marking on switch is standard. SEMKO Approved: P2011Y, P2012Y, P2013Y, P2021Y, P2022Y models approved at 10A @ 125V AC & 6A @ 125/250V AC; Reference No. 9915205/01-02. Marking on switch is standard. SEV Approved: All models with quick connect terminals approved at 10A @ 125V AC & 6A @ 250V AC; (P2013 only for micro-switch off); Authorization No. 02.0466. Marking on switch is standard. VD E R

NKK Switches • email: sales@nkkswitches.com • Phone (480) 991-0942 • Fax (480) 998-1435 • www.nkkswitches.com 03-07 Internationally Approved Rockers/Paddles Series P TERMINALS No Code Solder Lug P Straight PC Z .187” (4.75mm) Quick Connect TYPICAL SWITCH ORDERING EXAMPLE CP20 DPDT ON-NONE-ON Circuit POLES & CIRCUITS

11 SPST ON NONE OFF

12 SPDT ON NONE ON

13 SPDT ON OFF ON

21 DPST ON NONE OFF

22 DPDT ON NONE ON

23 DPDT ON OFF ON

D .365” (9.27mm) Wide Rocker E .365” (9.27mm) Wide Paddle For Y Frame J .595” (15.11mm) Wide Rocker H .595” (15.11mm) Wide Paddle DESCRIPTION FOR TYPICAL ORDERING EXAMPLE P2022Y-JC Frame for Large Caps Solder Lug Terminals CAP COLORS A Black B White C Red E Yellow F Green G Blue H Gray PADDLE/ROCKER FRAMES N Frame for Small Caps Y Frame for Large Caps Y J .595” (15.11mm) Wide Red Rocker IMPORTANT: VDE, SEMKO & SEV are marked on approved models. Switches are supplied without UL, C-UL & CSA marking unless specified. Specific models & ratings noted on General Specifications page.

NKK Switches • email: sales@nkkswitches.com • Phone (480) 991-0942 • Fax (480) 998-1435 • www.nkkswitches.com 03-07 Internationally Approved Rockers/Paddles Series P (7.6) .299 (1.17) .046 Thk = (1.0) .039 Epoxy Seal (4.8) .189 ROCKER/PADDLE FRAMES Rocker Position Connected Terminals Throw & Schematics Pole Model Down Center Up Down Center Up Note: Terminal numbers are on the switch. SP P2011 ON NONE OFF 1-1b OPEN OPEN SPST SP P2012 P2013 ON ON NONE OFF ON ON 1-1b OPEN 1-1a SPDT DP P2021 ON NONE OFF 1-1b 2-2b OPEN OPEN DPST DP P2022 P2023 ON ON NONE OFF ON ON 1-1b 2-2b OPEN 1-1a 2-2a DPDT POLES & CIRCUITS N Frame for Small Actuator Frame for Large Actuator 1 (COM) 1 (COM) 1b1a 1 2(COM) 1b 2b 1b 2b 2(COM) 1a 2a Y TERMINALS Solder Lug Z P No Code .187” (4.75mm) Quick Connect Straight PC SPST SPDT DPST DPDT Using AT4148 & AT4149 (28.5) 1.122 (34.9) 1.374 (16.0) .630 (3.5) Dia Typ .138(10.1) .398 (17.8) .701 (34.9) 1.374 (3.5) Dia Typ .138 (12.8) .504 (34.9) 1.374 (41.3) 1.626 (3.2) Dia Typ .126 (6.0) .236 (13.5) .531 (12.8) .504 (34.9) 1.374 (41.3) 1.626 (3.2) Dia Typ .126 Using AT4148 & AT4149 (1.8) Dia Typ .071 (7.62) Typ .3001 (1.8) Dia Typ .071 (7.62) Typ .3001 (10.16) .400 (1.8) Dia Typ .071 (7.62) Typ .30012 1b2b (10.16) .400 (1.8) Dia Typ .071 (7.62) Typ .3001 1a2a 1b2b Maximum Panel Thickness: .126” (3.2mm) Maximum Panel Thickness: .126” (3.2mm) (6.35) .250 (1.3) Dia .051 (4.75) .187 (9.0) .354 Thk = (0.8) .031 ROCKER/PADDLE FRAMES TERMINALS DPST Epoxy Seal (4.5) .177(2.6) .102 (1.25) .049 (2.0) .079 Thk = (1.0) .039

NKK Switches • email: sales@nkkswitches.com • Phone (480) 991-0942 • Fax (480) 998-1435 • www.nkkswitches.com 03-07 Internationally Approved Rockers/Paddles Series P TYPICAL SWITCH DIMENSIONS P2012N-DC P2011 & P2021 models do not have terminals 1a & 2a. Y Frame N Frame P2022Y-JC P2011 & P2021 models do not have terminals 1a & 2a. ROCKER/PADDLE CAPS D AT4148 .365” (9.27mm) Wide Rocker AT4149 .365” (9.27mm) Wide PaddleE For N Frame For Y Frame J AT4156 .595” (15.11mm) Wide Rocker AT4157 .595” (15.11mm) Wide PaddleH A Black Cap Colors Available: B White C Red E Yellow F Green G Blue H Gray Material: Polyamide Finish: Matte (20.5) .807 (3.2) Dia Typ .126 (2.6) .102 (11.0) .433 25° (12.3) .484 (0.6) .049 x .079 (1.0) Typ .039 (0.8) .031 (7.62) .300 (0.5) .020 (5.0) .197 (3.5) .138 (9.65) .380 (22.0) .866 (12.8) .504 (34.9) 1.374 (41.3) 1.626 (13.5) .531 (9.27) .365 (15.11) .595 (12.8) .504 (34.9) 1.374 (41.3) 1.626 (3.2) Dia Typ .126 25° (14.5) .571 (0.6) .024 (1.25) x (2.0) Typ .049 x .079 (1.0) Typ .039 (0.8) .031 (7.62) .300 (0.5) .020 (3.5) .138 (5.0) .197 (21.7) .854 (10.1) .398 2a 1a 1b2b (20.0) .787 (10.16) .400 (20.5) .807 (2.6) Typ .102 (6.15) .242(7.9) .311 (8.8) .346 (3.5) .138 (13.49) .531 (16.87) .664(9.27) .365 (9.27) .365 (18.8) .740 (2.13) .084 (3.96) .156 (8.43) R .332 (3.5) .138(16.8) .661 (15.11) .595 (11.0) .433 (26.78) 1.054 (23.01) .906 (10.11) .398 (6.6) .260 (3.5) .138 (14.33) .564 (15.11) .595 (29.82) 1.174 (26.8) 1.055 (2.36) .093 (4.75) .187 (13.5) R .531 (7.3) .287 (3.5) .138