P1500NEL LITTELFUSE | Alldatasheet

Document overview

  • Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
  • PDF pages: 2

Technical content

Telecom Design Guide • © 2006 Littelfuse 3 - 87 www.littelfuse.com SIDACtor Devices CATV Line Amplifiers/Power Inserters 3 kA SIDACtor® Device This SIDACtor device is a 3000 A solid state protection device offered in a non-isolated TO-263 (D2) package. It protects equipment located in the severe surge environment of CATV (Community Antenna TV) systems and antenna locations. * “L” in part number indicates RoHS compliance. For non-RoHS compliant device, delete “L” from part number. For surge ratings, see table below. ** IT is a free air rating; heat sink IT rating is 25 A. General Notes:

  • All measurements are made at an ambient temperature of 25 °C. I PP applies to -40 °C through +85 °C temperature range.
  • I PP is a repetitive surge rating and is guaranteed for the life of the product.
  • Listed SIDACtor devices are bi-directional. All electrical parameters and surge ratings apply to forward and reverse polarities.
  • V DRM is measured at IDRM.
  • V S is measured at 100 V/µs.
  • Special voltage (V S and VDRM) and holding current (IH) requirements are available upon request. * Current waveform in µs ** Voltage waveform in µs Electrical Parameters Part Number * VDRM Volts VS Volts VT Volts IDRM µAmps IS mAmps IT Amps ** IH mAmps P1500NEL 140 180 4 5 800 2.2/25 50 P1900NEL 140 220 4 5 800 2.2/25 50 P2300NEL 180 260 4 5 800 2.2/25 50 Surge Ratings in Amps Series IPP ITSM 50 / 60 Hz di/dt 8x20 * 1.2x50 ** Amps Amps Amps/µs E 3000 400 500

www.littelfuse.com 3 - 88 © 2006 Littelfuse • Telecom Design Guide CATV Line Amplifiers/Power Inserters 3 kA SIDACtor® Device * RθJC rating assumes the use of a heat sink and on state mode for extended time at 25 A, with average power dissipation of 29.125 W. Note: Off-state capacitance (CO) is measured at 1 MHz with a 2 V bias. Thermal Conditions Package Symbol Parameter Value Unit TO-263 D2PAK TJ Operating Junction Temperature Range -40 to +150 °C TS Storage Temperature Range -65 to +150 °C TC Maximum Case Temperature 100 °C RθJC * Thermal Resistance: Junction to Case 1.7 °C/W RθJA Thermal Resistance: Junction to Ambient 56 °C/W Capacitance Values Part Number pF MIN MAX P1500NEL 260 650 P1900NEL 260 650 P2300NEL 350 600 Pin2 Pin2 Pin1 Pin3 IH IT IS IDRM VDRMVT +V-V VS V-I Characteristics 100 tr td Peak Value Half Value t – Time (µs) IPP – Peak Pulse Current – %I PP tr = rise time to peak value td = decay time to half value Waveform = t r x td tr x td Pulse Waveform -40 -20 0 20 40 60 80 100 120 140 160 Junction Temperature (TJ) – ˚C Percent of VS Change – % 25 ˚C Normalized VS Change versus Junction Temperature 0.4 -40 -20 0 20 40 60 80 100 120 140 160 0.6 0.8 1.0 1.2 1.4 1.6 1.8 2.0 Case Temperature (TC) – ˚C Ratio of IH IH (TC = 25 ˚C) 25 ˚C Normalized DC Holding Current versus Case Temperature