OP11

OP11 Quad Matched 741-Type Operational Amplifiers Data Sheet (Rev. B)

Document overview

• Manufacturer or author: Analog Devices, Inc.
• PDF pages: 12

Technical content

Rev. B | Page 2 of 12 TABLE OF CONTENTS

REVISION HISTORY

6/07—Rev. A to Rev. B 4/02—Rev. 0 to Rev. A

Rev. B | Page 3 of 12 SPECIFICATIONS

ELECTRICAL CHARACTERISTICS

VS = ±15 V , TA = 25°C, unless otherwise noted. Table 1. Parameter Symbol Conditions Min Typ Max Unit Input Offset Voltage VOS RS ≤ 10 kΩ 0.3 0.5 mV Input Offset Current IOS 5.5 20 nA Input Bias Current IB 180 300 nA Input Resistance Differential Mode1 RIN 0.17 0.29 MΩ Input Voltage Range IVR ±12 ±13 V Common-Mode Rejection Ratio CMRR VCM = ±12 V, RS ≤ 10 kΩ 100 120 dB Power Supply Rejection Ratio PSRR VS = ±5 V to ±15 V, RS ≤ 10 kΩ 4 32 μV/V Output Voltage Swing VO RL = 2 kΩ ±11 ±13 V Large Signal Voltage Gain AVO RL ≤ 2 kΩ, VO = ±10 V 100 650 V/mV Power Consumption2 Pd VO = 0 V 105 180 mW Input Noise Voltage en p-p 0.1 Hz to 10 Hz 0.7 μV p-p Input Noise Voltage Density en fO = 10 Hz 18 nV/√Hz fO = 100 Hz 14 nV/√Hz fO = 1 kHz 12 nV/√Hz Input Noise Current In p-p 0.1 Hz to 10 Hz 17 pA p-p Input Noise Current Density In fO = 10 Hz 1.8 pA/√Hz fO = 100 Hz 1.5 pA/√Hz fO = 1 kHz 1.2 pA/√Hz Channel Separation CS 100 130 dB Slew Rate3 SR 0.7 1.0 V/μs Large Signal Bandwidth3 VO = 20 V p-p 11 16 kHz Closed-Loop Bandwidth4 BW AVCL = 1 2.4 3.0 MHz Rise Time3 tf AV = 1, VIN = 50 mV 110 145 ns Overshoot3 OS 15 25 % 1 Guaranteed by input bias current. 2 Total dissipation for all four amplifiers in package. 3 Sample tested. 4 Guaranteed by rise time.

Rev. B | Page 4 of 12 VS = ±15 V , 0°C ≤ TA ≤ 70°C, unless otherwise noted. Table 2. Parameter Symbol Conditions Min Typ Max Unit Input Offset Voltage VOS RS ≤ 10 kΩ 0.4 0.8 mV Average Input Offset Voltage Drift1 TCVOS RS ≤ 10 kΩ 2.0 10 μV/°C Input Offset Current IOS 14 30 nA Average Input Offset Current Drift1 TCIOS 0.1 0.3 nA/°C Input Bias Current IB 200 350 nA Input Voltage Range IVR ±12 ±13 V Common-Mode Rejection Ratio CMRR VCM = ±12 V, RS ≤ 10 kΩ 100 120 dB Power Supply Rejection Ratio PSRR VS = ±5 V to ±15 V, RS ≤ 10 kΩ 4 32 μV/V Large Signal Voltage Gain AVO RL ≥ 2 kΩ, VO = ±10 V 50 250 V/mV Output Voltage Swing VO RL ≥ 2 kΩ ±11 ±13 V Power Consumption2 Pd VO = 0 V 115 200 mW 1 Guaranteed but not tested. 2 Total dissipation for all four amplifiers in package. MATCHING CHARACTERISTICS VS = ±15 V , TA = 25°C, RS ≤ 100 Ω, unless otherwise noted. Table 3. Parameter Symbol Conditions Min Typ Max Unit Input Offset Voltage Match ΔVOS 0.5 0.75 mV Common-Mode Rejection ΔCMRR VCM = ±12 V 1 20 μV/V Ratio Match VCM = ±12 V 94 120 dB VS = ±15 V , 0°C ≤ TA ≤ 70°C, RS ≤ 100 Ω, unless otherwise noted. Table 4. Parameter Symbol Conditions Min Typ Max Unit Input Offset Voltage Match ΔVOS 0.6 1.0 mV Common-Mode Rejection ΔCMRR VCM = ±12 V 3.2 20 μV/V Ratio Match VCM = ±12 V 94 110 dB

Table 6. Thermal Resistance

Figure 3. Input Offset Voltage vs. Temperature Figure 4. Input Offset Current vs. Temperature Figure 5. Input Bias Current vs. Temperature Figure 6. Open-Loop Gain vs. Temperature Figure 7. Open-Loop Gain and Phase vs. Frequency

0.6 NORMALIZED VALUE REFERRED TO 25°C

Figure 8. Normalized Slew Rate and Bandwidth vs. Temperature

Figure 15. Transient Response Figure 16. Voltage Follower Pulse Response Figure 17. Maximum Output Swing vs. Frequency Figure 18. Output Voltage Swing vs. Load Resistance Figure 19. Quiescent Current vs. Total Supply Voltage

100 POWER CONSUMPTION (mW)

Figure 20. Power Consumption vs. Temperature

REFERENCE ONLY AND ARE NOT APPROPRIATE FOR USE IN DESIGN. CORNER LEADS MAY BE CONFIGURED AS WHOLE OR HALF LEADS. Figure 21. 14-Lead Plastic Dual In-Line Package [PDIP]

Rev. B | Page 10 of 12 NOTES

Rev. B | Page 11 of 12 NOTES

Rev. B | Page 12 of 12 NOTES ©2007 Analog Devices, Inc. All rights reserved. Trademarks and registered trademarks are the property of their respective owners. C02784-0-6/07(B)