MRF5S19130HR3 FREESCALE | Alldatasheet

Document overview

  • Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
  • PDF pages: 12

Technical content

  • Typical 2-Carrier N-CDMA Performance for V DD = 28 Volts, IDQ = 1200 mA, Pout = 26 Watts Avg., Full Frequency Band, IS-95 CDMA (Pilot, Sync, Paging, Traffic Codes 8 Through 13) Channel Bandwidth = Power Gain — 13 dB Drain Efficiency — 25% IM3 @ 2.5 MHz Offset — -37 dBc @ 1.2288 MHz Bandwidth ACPR @ 885 kHz Offset — -51 dB @ 30 kHz Bandwidth
  • Capable of Handling 10:1 VSWR, @ 28 Vdc, f1 = 1960 MHz,

110 Watts CW Output Power

  • Characterized with Series Equivalent Large-Signal Impedance Parameters
  • Internally Matched, Controlled Q, for Ease of Use
  • Qualified Up to a Maximum of 32 V Operation
  • Integrated ESD Protection
  • Lower Thermal Resistance Package
  • Low Gold Plating Thickness on Leads, 40 µ″ Nominal.
  • Available in Tape and Reel. R3 Suffix = 250 Units per 56 mm, 13 inch Reel.

Table 1. Maximum Ratings Table 2. Thermal Characteristics

  1. MTTF calculator available at http://www.freescale.com/rf . Select Tools/Software/Application Software/Calculators to access

the MTTF calculators by product. Select Documentation/Application Notes - AN1955. packaging MOS devices should be observed.  Freescale Semiconductor, Inc., 2004. All rights reserved.

Table 3. ESD Protection Characteristics Table 4. Electrical Characteristics (TC = 25°C unless otherwise noted) @ 0.01% Probability on CCDF.

  1. Part is internally matched both on input and output.

Figure 1. MRF5S19130HR3(SR3) Test Circuit Schematic Table 5. MRF5S19130HR3(SR3) Test Circuit Component Designations and Values

Figure 2. MRF5S19130HR3(SR3) Test Circuit Component Layout no impact on form, fit or function of the current product.

Figure 3. 2-Carrier N-CDMA Broadband Performance

1.2288 MHz Channel Bandwidth

Figure 4. Two-Tone Power Gain versus Figure 5. Third Order Intermodulation Figure 6. Intermodulation Distortion Products Figure 7. Pulse CW Output Power versus

Figure 8. 2-Carrier N-CDMA ACPR, IM3, Figure 9. 2-Carrier N-CDMA Spectrum

1.2288 MHz

Figure 10. MTTF Factor versus Junction MTTF factor by ID2 for MTTF in a particular application.

Figure 11. Series Equivalent Source and Load Impedance

MRF5S19130HR3 MRF5S19130HSR3 NOTES

MRF5S19130HR3 MRF5S19130HSR3 RF Device Data Freescale Semiconductor NOTES

MRF5S19130HR3 MRF5S19130HSR3 NOTES

MRF5S19130HR3 MRF5S19130HSR3 RF Device Data Freescale Semiconductor PACKAGE DIMENSIONS CASE 465B-03 ISSUE B NI-880 MRF5S19130HR3 NOTES: 1. DIMENSIONING AND TOLERANCING PER ANSI Y14.5M−1994. 2. CONTROLLING DIMENSION: INCH. 3. DIMENSION H IS MEASURED 0.030 (0.762) AWAY FROM PACKAGE BODY. 4. DELETED DIM MIN MAX MIN MAX MILLIMETERSINCHES A 1.335 1.345 33.91 34.16 B 0.535 0.545 13.6 13.8 C 0.147 0.200 3.73 5.08 D 0.495 0.505 12.57 12.83 E 0.035 0.045 0.89 1.14 F 0.003 0.006 0.08 0.15 G 1.100 BSC 27.94 BSC H 0.057 0.067 1.45 1.70 K 0.170 0.210 4.32 5.33 N 0.871 0.889 19.30 22.60 Q .118 .138 3.00 3.51 R 0.515 0.525 13.10 13.30 STYLE 1: PIN 1. DRAIN 2. GATE 3. SOURCE D G K C E H F Q2X MAMbbb B MT MAMbbb B MT B B (FLANGE) SEATING PLANE MAMccc B MT MAMbbb B MT AA (FLANGE) T N (LID) M (INSULATOR) S MAMaaa B MT (INSULATOR) R MAMccc B MT (LID) S 0.515 0.525 13.10 13.30 M 0.872 0.888 22.15 22.55 aaa 0.007 REF 0.178 REF bbb 0.010 REF 0.254 REF ccc 0.015 REF 0.381 REF CASE 465C-02 ISSUE A NI-880S MRF5S19130HSR3 NOTES: 1. DIMENSIONING AND TOLERANCING PER ANSI Y14.5M−1994. 2. CONTROLLING DIMENSION: INCH. 3. DIMENSION H IS MEASURED 0.030 (0.762) AWAY FROM PACKAGE BODY. DIM MIN MAX MIN MAX MILLIMETERSINCHES A 0.905 0.915 22.99 23.24 B 0.535 0.545 13.60 13.80 C 0.147 0.200 3.73 5.08 D 0.495 0.505 12.57 12.83 E 0.035 0.045 0.89 1.14 F 0.003 0.006 0.08 0.15 H 0.057 0.067 1.45 1.70 K 0.170 0.210 4.32 5.33 N 0.871 0.889 19.30 22.60 R 0.515 0.525 13.10 13.30 STYLE 1: PIN 1. DRAIN 2. GATE 3. SOURCE SEATING PLANE D K C E H F MAMbbb B MT B B (FLANGE) MAMccc B MT MAMbbb B MT AA (FLANGE) T N (LID) M (INSULATOR) MAMccc B MT MAMaaa B MT R (LID) S (INSULATOR) S 0.515 0.525 13.10 13.30 M 0.872 0.888 22.15 22.55 bbb 0.010 REF 0.254 REF ccc 0.015 REF 0.381 REF aaa 0.007 REF 0.178 REF

MRF5S19130HR3 MRF5S19130HSR3 Information in this document is provided solely to enable system and software implementers to use Freescale Semiconductor products. There are no express or implied copyright licenses granted hereunder to design or fabricate any integrated circuits or integrated circuits based on the information in this document. Freescale Semiconductor reserves the right to make changes without further notice to any products herein. Freescale Semiconductor makes no warranty, representation or guarantee regarding the suitability of its products for any particular purpose, nor does Freescale Semiconductor assume any liability arising out of the application or use of any product or circuit, and specifically disclaims any and all liability, including without limitation consequential or incidental damages. “Typical” parameters that may be provided in Freescale Semiconductor data sheets and/or specifications can and do vary in different applications and actual performance may vary over time. All operating parameters, including “Typicals”, must be validated for each customer application by customer’s technical experts. Freescale Semiconductor does not convey any license under its patent rights nor the rights of others. Freescale Semiconductor products are not designed, intended, or authorized for use as components in systems intended for surgical implant into the body, or other applications intended to support or sustain life, or for any other application in which the failure of the Freescale Semiconductor product could create a situation where personal injury or death may occur. Should Buyer purchase or use Freescale Semiconductor products for any such unintended or unauthorized application, Buyer shall indemnify and hold Freescale Semiconductor and its officers, employees, subsidiaries, affiliates, and distributors harmless against all claims, costs, damages, and expenses, and reasonable attorney fees arising out of, directly or indirectly, any claim of personal injury or death associated with such unintended or unauthorized use, even if such claim alleges that Freescale Semiconductor was negligent regarding the design or manufacture of the part. Freescale/C0116 and the Freescale logo are trademarks of Freescale Semiconductor, Inc. All other product or service names are the property of their respective owners.  Freescale Semiconductor, Inc. 2004. All rights reserved. How to Reach Us: Home Page: www.freescale.com E-mail: support@freescale.com USA/Europe or Locations Not Listed: Freescale Semiconductor Technical Information Center, CH370 1300 N. Alma School Road Chandler, Arizona 85224 +1-800-521-6274 or +1-480-768-2130 support@freescale.com Europe, Middle East, and Africa: Freescale Halbleiter Deutschland GmbH Technical Information Center Schatzbogen 7

81829 Muenchen, Germany

+44 1296 380 456 (English) +46 8 52200080 (English) +49 89 92103 559 (German) +33 1 69 35 48 48 (French) support@freescale.com Japan: Freescale Semiconductor Japan Ltd. Headquarters ARCO Tower 15F 1-8-1, Shimo-Meguro, Meguro-ku, Tokyo 153-0064 Japan 0120 191014 or +81 3 5437 9125 support.japan@freescale.com Asia/Pacific: Freescale Semiconductor Hong Kong Ltd. Technical Information Center

2 Dai King Street

Tai Po, N.T., Hong Kong +800 2666 8080 support.asia@freescale.com For Literature Requests Only: Freescale Semiconductor Literature Distribution Center P.O. Box 5405 Denver, Colorado 80217 1-800-441-2447 or 303-675-2140 Fax: 303-675-2150 LDCForFreescaleSemiconductor@hibbertgroup.com MRF5S19130H Rev. 1, 12/2004 Document Number: