MRF5P20180HR6 FREESCALE | Alldatasheet

Document overview

  • Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
  • PDF pages: 12

Technical content

to 1990 MHz. Suitable for TDMA, CDMA and multicarrier amplifier applications. To be used in Class AB for PCN-PCS/cellular radio and WLL applications.

  • Typical 2-carrier W-CDMA Performance: V DD = 28 Volts, IDQ = 2 x 800 mA, Pout = 38 Watts Avg., Full Frequency Band, Channel Bandwidth = Power Gain — 14 dB Drain Efficiency — 26% IM3 @ 10 MHz Offset — -37.5 dBc @ 3.84 MHz Channel Bandwidth ACPR @ 5 MHz Offset — -41 dBc @ 3.84 MHz Channel Bandwidth
  • Capable of Handling 10:1 VSWR, @ 28 Vdc, 1960 MHz, 120 Watts CW Output Power
  • Characterized with Series Equivalent Large-Signal Impedance Parameters
  • Internally Matched, Controlled Q, for Ease of Use
  • Qualified Up to a Maximum of 32 VDD Operation
  • Integrated ESD Protection
  • Lower Thermal Resistance Package
  • Low Gold Plating Thickness on Leads, 40µ″ Nominal.
  • In Tape and Reel. R6 Suffix = 150 Units per 56 mm, 13 inch Reel.

Table 1. Maximum Ratings Table 2. Thermal Characteristics Select Documentation/Application Notes - AN1955. packaging MOS devices should be observed.  Freescale Semiconductor, Inc., 2004. All rights reserved.

Table 3. ESD Protection Characteristics Table 4. Electrical Characteristics (TC = 25°C unless otherwise noted) 8.5 dB @ 0.01% Probability on CCDF.

  1. Each side of device measured separately. Part is internally matched both on input and output.
  2. Measurements made with device in push-pull configuration.

Figure 1. MRF5P20180HR6 Test Circuit Schematic Table 5. MRF5P20180HR6 Test Circuit Component Designations and Values

Figure 2. MRF5P20180HR6 Test Circuit Component Layout no impact on form, fit or function of the current product.

Figure 3. 2-Carrier W-CDMA Broadband PerformanceG ps, POWER GAIN (dB)

3.84 MHz Channel Bandwidth

Figure 4. Two-Tone Power Gain versus Figure 5. Third Order Intermodulation Figure 6. Intermodulation Distortion Products Figure 7. Pulse CW Output Power versus

Figure 8. 2-Carrier W-CDMA ACPR, IM3, Power Figure 9. MTTF Factor versus Junction Temperature MTTF factor by ID2 for MTTF in a particular application. Figure 10. CCDF W-CDMA 3GPP , Test Model 1,

64 DPCH, 67% Clipping, Single Carrier Test Signal

Figure 11. 2-Carrier W-CDMA Spectrum

3.84 MHz

3.84 MHz BW

Figure 12. Series Equivalent Source and Load Impedance gate to gate, balanced configuration. from drain to drain, balanced configuration.

NOTES: 1. INTERPRET DIMENSIONS AND TOLERANCES PER ASME Y14.5M−1994. 2. CONTROLLING DIMENSION: INCH. 3. DIMENSION H IS MEASURED 0.030 (0.762) AWAY FROM PACKAGE BODY. 4. RECOMMENDED BOLT CENTER DIMENSION OF 1.52 (38.61) BASED ON M3 SCREW. STYLE 1: PIN 1. DRAIN 2. DRAIN 3. GATE 4. GATE 5. SOURCE DIM MIN MAX MIN MAX MILLIMETERSINCHES A 1.615 1.625 41.02 41.28 B 0.395 0.405 10.03 10.29 C 0.150 0.200 3.81 5.08 D 0.455 0.465 11.56 11.81 E 0.062 0.066 1.57 1.68 F 0.004 0.007 0.10 0.18 G 1.400 BSC 35.56 BSC H 0.082 0.090 2.08 2.29 K 0.117 0.137 2.97 3.48 L 0.540 BSC 13.72 BSC N 1.218 1.242 30.94 31.55 Q 0.120 0.130 3.05 3.30 R 0.355 0.365 9.01 9.27 A G L DK4X Q2X M 1.219 1.241 30.96 31.52 S 0.365 0.375 9.27 9.53 aaa 0.013 REF 0.33 REF bbb 0.010 REF 0.25 REF ccc 0.020 REF 0.51 REF SEATING PLANE N C E M MAMaaa B MT B B (FLANGE) H F MAMccc B MT R (LID) S (INSULATOR) MAMbbb B MT A T MAMbbb B MT (INSULATOR) MAMccc B MT (LID) PIN 5 MAMbbb B MT

Information in this document is provided solely to enable system and software implementers to use Freescale Semiconductor products. There are no express or implied copyright licenses granted hereunder to design or fabricate any integrated circuits or integrated circuits based on the information in this document. Freescale Semiconductor reserves the right to make changes without further notice to any products herein. Freescale Semiconductor makes no warranty, representation or guarantee regarding the suitability of its products for any particular purpose, nor does Freescale Semiconductor assume any liability arising out of the application or use of any product or circuit, and specifically disclaims any and all liability, including without limitation consequential or incidental damages. “Typical” parameters that may be provided in Freescale Semiconductor data sheets and/or specifications can and do vary in different applications and actual performance may vary over time. All operating parameters, including “Typicals”, must be validated for each customer application by customer’s technical experts. Freescale Semiconductor does not convey any license under its patent rights nor the rights of others. Freescale Semiconductor products are not designed, intended, or authorized for use as components in systems intended for surgical implant into the body, or other applications intended to support or sustain life, or for any other application in which the failure of the Freescale Semiconductor product could create a situation where personal injury or death may occur. Should Buyer purchase or use Freescale Semiconductor products for any such unintended or unauthorized application, Buyer shall indemnify and hold Freescale Semiconductor and its officers, employees, subsidiaries, affiliates, and distributors harmless against all claims, costs, damages, and expenses, and reasonable attorney fees arising out of, directly or indirectly, any claim of personal injury or death associated with such unintended or unauthorized use, even if such claim alleges that Freescale Semiconductor was negligent regarding the design or manufacture of the part. Freescale/C0116 and the Freescale logo are trademarks of Freescale Semiconductor, Inc. All other product or service names are the property of their respective owners.  Freescale Semiconductor, Inc. 2004. All rights reserved. How to Reach Us: Home Page: www.freescale.com E-mail: support@freescale.com USA/Europe or Locations Not Listed: Freescale Semiconductor Technical Information Center, CH370 1300 N. Alma School Road Chandler, Arizona 85224 +1-800-521-6274 or +1-480-768-2130 support@freescale.com Europe, Middle East, and Africa: Freescale Halbleiter Deutschland GmbH Technical Information Center Schatzbogen 7

81829 Muenchen, Germany

+44 1296 380 456 (English) +46 8 52200080 (English) +49 89 92103 559 (German) +33 1 69 35 48 48 (French) support@freescale.com Japan: Freescale Semiconductor Japan Ltd. Headquarters ARCO Tower 15F 1-8-1, Shimo-Meguro, Meguro-ku, Tokyo 153-0064 Japan 0120 191014 or +81 3 5437 9125 support.japan@freescale.com Asia/Pacific: Freescale Semiconductor Hong Kong Ltd. Technical Information Center

2 Dai King Street

Tai Po, N.T., Hong Kong +800 2666 8080 support.asia@freescale.com For Literature Requests Only: Freescale Semiconductor Literature Distribution Center P.O. Box 5405 Denver, Colorado 80217 1-800-441-2447 or 303-675-2140 Fax: 303-675-2150 LDCForFreescaleSemiconductor@hibbertgroup.com MRF5P20180HR6 Rev. 0, 12/2004