MP1013 ZFSWITCHES | Alldatasheet
Document overview
- Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
- PDF pages: 2
Technical content
www.cherryswitches.com Page 1 of 2, Last update 2016-01-05, Specifications subject to change without notice. Magnetic Proximity Sensors (Hall Effect) MP1013 Sensors Hall-effect position sensor with convenient snap-fit mounting
Description
The MP1 Series sensors are one-piece non-contact solid-state position sensors. The sensors operate through the use of Hall Effect technology with magnetic fields generated by permanent magnets. They provide a sinking current output. Features Typical Applications
- Solid state reliability
- Stable output over operating temperature range
- Open collector (NPN) output can be used with bipol ar or CMOS logic circuits with suitable pull-up resistor
- South pole sensitive
- Unipolar device (MP101301, MP101302)
- Latching version available (MP101303)
- RoHS compliant
- Fastener-less design
- IP67
- Door position & interlock
- Limit switch
- Flow/speed
- Home security
- Pedal switch Environmental Specifications Operating / Storage Temperature (MP101301, MP101303) -40 °C to 85 ⁰C ( -40 ⁰F to 185 ⁰F) Operating / Storage Temperature (MP101302) -40 ⁰C to 125 °C ( -40 ⁰F to 257 ⁰F) Ingress Protection IP67 Electrical Specifications Operating Supply Voltage 5 to 24 VDC Supply Current (MP101301, MP101302) 4.1 mA typ., 7.5 mA max. Supply Current (MP101303) 2.6 mA typ., 5 mA max. Output Current (Sink) (MP101301, MP101302) 25 mA max. Output Current (Sink) (MP101303) 20 mA max. Maximum Input Voltage (MP101301, MP101302) 30 VDC Maximum Input Voltage (MP101303) 28 VDC Maximum Reverse Voltage (MP101301, MP101302) 30 VDC Maximum Reverse Voltage (MP101303) None Recommended Pull -Up Resistor See chart Mechanical Specifications Housing Material Glass-reinforced nylon plastic Turn on / off (MP101301, MP101302) 245 Gauss / 60 Gauss Turn on / off (MP101303)* 60 Gauss / 60 Gauss *MP101303 is a latching sensor and releases when 60 Gauss is applied to the north pole
w.cherryswitches.com Page 2 of 2, Last update 2016-01-05, Specifications subject to change without notice. *Not commonly stocked No te: An external pull-up resistor is required, the value of which is dependent on the supply voltage. The resistor should be connected between the output and Vcc. Refer to the wiring diagram for lead colors or pin numbering as applicable. Recommended External Pull-Up Resistor Volts DC 5 9 12 15 24 Ohms 1k 1.8k 2.4k 3k 3k Open Collector Sinking Block Diagram Dimensions mm (inches) Products Part Number Leads MP101301 24 AWG x 150 mm MP101302* 24 AWG x 150 mm MP101303* 24 AWG x 150 mm