MMA20312BV FREESCALE | Alldatasheet
Document overview
- Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
- PDF pages: 18
Technical content
Features
- Frequency: 1800- -2200 MHz
- P1dB: 30.5 dBm @ 2140 MHz (CW Application Circuit)
- Power Gain: 26.4 dB @ 2140 MHz (CW Application Circuit)
- OIP3: 44.5 dBm @ 2140 MHz (W- -CDMA Application Circuit)
- Active Bias Control (adjustable externally)
- Single 3 to 5 Volt Supply
- Cost- -effective QFN Surface Mount Package
- In Tape and Reel. T1 Suffix = 1000 Units, 12 mm Tape Width, 7 inch Reel.
Table 1. Typical Performance(1)
- VCC1 =V CC2 =V BIAS =5V d c ,TA =2 5°C, 50 ohm system, CW
Table 2. Maximum Ratings
- For reliable operation, the junction temperature should not
Table 3. Thermal Characteristics Select Documentation/Application Notes - - AN1955. © Freescale Semiconductor, Inc., 2011.All rights reserved.
Freescale Semiconductor, Inc. Table 4. Electrical Characteristics(VCC1 =V CC2 =V BIAS = 5 Vdc, 2140 MHz, TA =2 5°C, 50 ohm system, in Freescale W- -CDMA Table 5. ESD Protection Characteristics Table 6. Moisture Sensitivity Level
- Specified data is based on performance of soldered down part in W- -CDMA application circuit.
- For reliable operation, the junction temperature should not exceed 150°C.
Figure 1. Functional Block Diagram Figure 2. Pin Connections
Freescale Semiconductor, Inc. Figure 3. MMA20312BV Test Circuit Schematic TD- -SCDMA, 5 Volt Operation Table 7. MMA20312BV Test Circuit Component Designations and Values TD- -SCDMA, 5 Volt Operation Note: Component numbers C6, C7 and C9 are labeled on board but not placed. C10, C11, C12, C14 and C15 are intentionally omitted.
Freescale Semiconductor, Inc. Figure 4. MMA20312BV TestCircuit Component Layout TD- -SCDMA, 5 Volt Operation (1) VBIAS [Board] supplies VBA1,V BA2 and VBIAS [Device]. Note: Component numbers C6*, C7* and C9* are labeled on board but not placed. Note: Component numbers C10, C11, C12, C14 and C15 are intentionally omitted.
Freescale Semiconductor, Inc. Figure 11. MMA20312BV Test Circuit Schematic W- -CDMA, 5 Volt Operation Table 8. MMA20312BV Test Circuit Component Designations and Values W- -CDMA, 5 Volt Operation Note: Component numbers C6 and C7 are labeled on board but not placed.C10, C11, C12, C14 and C15 are intentionally omitted.
Freescale Semiconductor, Inc. Figure 12. MMA20312BV Test Circuit ComponentLayout W- -CDMA, 5 Volt Operation (1) VBIAS [Board] supplies VBA1,V BA2 and VBIAS [Device]. Note: Component numbers C6* and C7* are labeled on board but not placed. Note: Component numbers C10, C11, C12, C14 and C15 are intentionally omitted.
Freescale Semiconductor, Inc. Figure 16. MMA20312BV Test Circuit Schematic IS- -95, 3.3 Volt Operation Table 9. MMA20312BV Test Circuit Component Designations and Values IS- -95, 3.3 Volt Operation Note: Component numbers C6, C7, C18 and C19 are labeled on board but not placed. C10, C11, C12, C14 and C15 are intentionally omitted.
Freescale Semiconductor, Inc. Figure 17. MMA20312BV Test Circuit ComponentLayout IS- -95, 3.3 Volt Operation (1) VBIAS [Board] supplies VBA1,V BA2 and VBIAS [Device]. Note: Component numbers C6*, C7*, C18* and C19* are labeled on board but not placed. Note: Component numbers C10, C11, C12, C14 and C15 are intentionally omitted.
Freescale Semiconductor, Inc. MMA20312BVT1 PACKAGE DIMENSIONS
Freescale Semiconductor, Inc.
Freescale Semiconductor, Inc. MMA20312BVT1
Freescale Semiconductor, Inc. PRODUCT DOCUMENTATION, SOFTWARE AND TOOLS Refer to the following documents, software and tools to aid your design process. Application Notes
- AN1955: Thermal Measurement Methodology of RF Power Amplifiers Software
- .s2p File Development Tools
- Printed Circuit Boards For Software and Tools, do a Part Number search at http://www.freescale.com, and select the Part Number link. Go to the Software & Tools tab on the parts Product Summary page to download the respective tool.
REVISION HISTORY
The following table summarizes revisions to this document. Revision Date Description 0 Aug. 2011 • Initial Release of Data Sheet 1 Dec. 2011 • Updated minimum operating voltage from 3.3 V to 3 V to reflect actual device capability, p. 1
- All references to VCTRL in the data sheet tables, test circuitschematics and component layouts is replaced with VBIAS. VBIAS is the supply voltage which sets the internal bias conditions via pins 1, 2, and 12, p. 1- -3, 5- -7, 9, 10, 12. Footnote (1) VBIAS [Board] supplies VBA1,V BA2 and VBIAS [Device] added to test circuit component layouts, p. 4, 8, 11.
Freescale Semiconductor, Inc. MMA20312BVT1 Information in this document is provided solely to enablesystem and software implementers to use Freescale Semiconductor products. There are no express or implied copyright licenses granted hereunder to design or fabricate any integrated circuits or integrated circuits based on the information in this document. Freescale Semiconductor reserves the right to make changes without further notice to any products herein. Freescale Semiconductor makes no warranty, representation or guarantee regarding the suitability of its productsfor any particular purpose, nor does Freescale Semiconductor assume any liability arising out of the application or use of any product or circuit, and specifically disclaims any and allliability, including without limitation consequential or incidental damages. Typical parameters that may be provided in Freescale Semiconductor data sheets and/or specifications can and do vary in different applications and actual performance may vary over time. All operating parameters, including Typicals, must be validated for each customer application by customers technical experts. Freescale Semiconductor does not convey any license under its patent rights nor the rights of others. Freescale Semiconductor products are not designed, intended, or authorized for use as components insystems intended for surgical implant into the body, or other applications intended to support or sustain life, or for any other application in which the failure of the Freescale Semiconductor product could create a situation where personal injury or death may occur. Should Buyer purchase or use Freescale Semiconductor products for any such unintended or unauthorized application, Buyer shall indemnify and hold Freescale Semiconductor and its officers, employees, subsidiaries, affiliates, and distributorsharmless against all claims, costs, damages, and expenses, and reasonable attorney fees arising out of, directly or indirectly, any claim of personal injury or death associated with such unintended or unauthorized use, even if such claim alleges that Freescale Semiconductor was negligent regarding the design or manufacture of the part. Freescalet and the Freescale logo are trademarks of Freescale Semiconductor, Inc. All other product or service names are the property of their respective owners. © Freescale Semiconductor, Inc. 2011. All rights reserved. How to Reach Us: Home Page: www.freescale.com Web Support: http://www.freescale.com/support USA/Europe or Locations Not Listed: Freescale Semiconductor, Inc. Technical Information Center, EL516
2100 East Elliot Road
Tempe, Arizona 85284 www.freescale.com/support Europe, Middle East, and Africa: Freescale Halbleiter Deutschland GmbH Technical Information Center Schatzbogen 7
81829 Muenchen, Germany
+44 1296 380 456 (English) +46 8 52200080 (English) +49 89 92103 559 (German) + 3 316 93 54 84 8( F r e n c h ) www.freescale.com/support Japan: Freescale Semiconductor Japan Ltd. Headquarters ARCO Tower 15F 1- -8- -1, Shimo- -Meguro, Meguro- -ku, Tokyo 153- -0064 Japan 0120 191014 or +81 3 5437 9125 support.japan@freescale.com Asia/Pacific: Freescale Semiconductor China Ltd. Exchange Building 23F No. 118 Jianguo Road Chaoyang District Beijing 100022 China +86 10 5879 8000 support.asia@freescale.com For Literature Requests Only: Freescale Semiconductor Literature Distribution Center LDCForFreescaleSemiconductor@hibbertgroup.com Document Number: MMA20312BV Rev. 1, 12/2011