MC23783 DURATOOL | Alldatasheet
Document overview
- Manufacturer or author: Provided By alldatasheet.com(free datasheet download site)
- PDF pages: 1
Technical content
Page <1> 02/02/12 V1.1 Important Notice : This data sheet and its contents (the "Information") belong to the members of the Premier Farnell group of companies (the "Group") or are licensed to it. No licence is granted for the use of it other than for information purposes in connection with the products to which it relates. No licence of any intellectual property rights is granted. The Information is subject to change without notice and replaces all data sheets previously supplied. The Information supplied is believed to be accurate but the Group assumes no responsibility for its accuracy or completeness, any error in or omission from it or for any use made of it. Users of this data sheet should check for themselves the Information and the suitability of the products for their purpose and not make any assumptions based on information included or omitted. Liability for loss or damage resulting from any reliance on the Information or use of it (including liability resulting from negligence or where the Group was aware of the possibility of such loss or damage arising) is excluded. This will not operate to limit or restrict the Group's liability for death or personal injury resulting from its negligence. DURATOOL is the registered trademark of the Group. © Premier Farnell plc 2012. Description Part Number Heel Grounder MC23783 Part Number Table www.element14.com www.farnell.com www.newark.com www.cpc.co.uk www.mcmelectronics.com Description:
- Dual Layer conductive rubber
- 18 inches conductive grounding tab, grey
- Velcro fastening system: 7 Inches Velstretch and 7 Inches hook material
- One megaohm resistor
- Tab to cup resistance >7.5 × 10E5 and <1.0 × 10E7 ohms per ESD SP9.2 Suitable for ESD footwear component to meets ANSI/ESD S20.20-2007 Table 2 Personnel Grounding Requirement Flooring / Footwear System – Method 1 <3.5 × 10E7 ohms tested per ESD STM 97.1 Floor Materials and Footwear-Resistance in Combination with a Person “Heel and Toe grounders should be worn on both feet to insure effective use.” “Compliance verification should be performed prior to each use (daily, shift change, etc.). The accumulation of insulative mate rials may increase the foot grounder system resistance. If foot grounders are worn outside the ESD protected area testing for functio nality before re-entry to the ESD protected area should be considered.”