DATASHEET SEARCH SITE | WWW.ALLDATASHEET.COM
Document overview
- Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
- PDF pages: 9
Technical content
/C0077/C0067/C0049/C0050/C0048/C0054/C0049 SEMICONDUCTOR TECHNICAL DATA CRYSTAL OSCILLATOR
ORDERING INFORMATION
MC12061P T A = 0° to +70°C Plastic P SUFFIX PLASTIC PACKAGE CASE 648 Order this document by MC12061/D /C0067/C0114/C0121/C0115/C0116/C0097/C0108 /C0079/C0115/C0099/C0105/C0108/C0108/C0097/C0116/C0111/C0114 The MC12061 is for use with an external crystal to form a crystal controlled oscillator. In addition to the fundamental series mode crystal, two bypass capacitors are required (plus usual power supply pin bypass capacitors). Translators are provided internally for MECL and TTL outputs.
- Frequency Range = 2.0 to 20 MHz
- Temperature Range = 0 to + 70°C
- Single Supply Operation: +5.0 Vdc or –5.2 Vdc
- Three Outputs Available: 1. Complementary Sine Wave (600 mVpp typ) 2. Complementary MECL 3. Single Ended TTL
Figure 1. Block Diagram
71 V CC 4 3 2 1 41 51 6 V CC 13 12 11 V CC
Note: 0.1 µF power supply pin bypass capacitors not shown. Figure 2. Sine Wave Figure 3. MTTL Output Figure 4. MECL Output Figure 5. MECL Output
2 MOTOROLA RF/IF DEVICE DATA
ELECTRICAL CHARACTERISTICS
Under 0°C +25°C +75°C Characteristic Symbol Under Test Min Max Min Typ Max Min Max Unit Power Supply Drain Current ICC 1 – – 13 16 19 – – mAdcpp y 3.0 4.0 Input Current IinH 14 250 250 µAdc IinL 14 1.0 1.0 µAdc Differential Offset Voltage ΔV 4 to 7 2 to 3 –200 325 +200 mAdc Output Voltage Level Vout 2 3.5 3.5 Vdc Logic ‘1’ Output Voltage VOH1 (Note 1) 4.0 4.0 4.16 4.16 4.04 4.04 4.19 4.19 4.1 4.1 4.28 4.28 Vdc Logic ‘0’ Output Voltage VOL1 (Note 1) 2.98 2.98 3.43 3.43 3.0 3.0 3.44 3.44 3.02 3.02 3.47 3.47 Vdc VOL2 10 0.5 0.5 0.5 0.5 0.5 0.5 Logic ‘1’ Threshold VoltageVOHA 12 3.98 3.98 4.02 4.02 4.08 4.08 Vdc Logic ‘0’ Threshold VoltageVOLA 12 3.45 3.45 3.46 3.46 3.49 3.49 Vdc Output Short Circuit CurrentIOS 10 20 60 20 – 60 20 60 mAdc NOTE: 1. Devices will meet standard MECL logic levels using VEE = –5.2 Vdc and VCC = 0.
3MOTOROLA RF/IF DEVICE DATA ELECTRICAL CHARACTERISTICS (continued) TEST VOLTAGE/CURRENT VALUES Volts @ Test Temperature VIHmax VILmin VIHAmin VILAmax VIHT VCCL Pin Under TEST VOLTAGE APPLIED TO PINS LISTED BELOW Characteristic Symbol U nder Test VIHmax VILmin VIHAmin VILAmax VIHT VCCL Gnd Power Supply Drain Current ICC 1 – – – – – – 8 8,9 Input Current IinH 14 IinL 14 8,14 8,15 Differential Offset Voltage ΔV 4 to 7 2 to 3 5,6 Output Voltage Level Vout 2 Logic ‘1’ Output Voltage VOH1 (Note 1) VOH2 10 15 14 – – – 11,16 8,9 Logic ‘0’ Output Voltage VOL1 (Note 1) VOL2 10 11,16 8,9 8,9 Logic ‘1’ Threshold Voltage VOHA 12 Logic ‘0’ Threshold Voltage VOLA 12 Output Short Circuit Current IOS 10 15 14 – – – 11,16 8,9,10 NOTE: 1. Devices will meet standard MECL logic levels using VEE = –5.2Vdc and VCC = 0.
4 MOTOROLA RF/IF DEVICE DATA
ELECTRICAL CHARACTERISTICS (continued) TEST VOLTAGE/CURRENT VALUES Volts mA @ Test Temperature VCC VCCH IOL IOH IIL Pin Under TEST VOLTAGE APPLIED TO PINS LISTED BELOW Characteristic Symbol U nder Test VCC VCCH IOL IOH IIL Gnd Power Supply Drain Current ICC 1 1 – – – – 8 11,16 8,9 Input Current IinH 14 IinL 14 8,14 8,15 Differential Offset Voltage ΔV 4 to 7 2 to 3 Output Voltage Level Vout 2 Logic ‘1’ Output Voltage VOH1 (Note 1) VOH2 10 – – – 10 – 8,9 Logic ‘0’ Output Voltage VOL1 (Note 1) VOL2 10 11,16 8,9 8,9 Logic ‘1’ Threshold Voltage VOHA 12 Logic ‘0’ Threshold Voltage VOLA 12 Output Short Circuit Current IOS 10 – – – – – 8,9,10 NOTE: 1. Devices will meet standard MECL logic levels using VEE = –5.2Vdc and VCC = 0.
6 MOTOROLA RF/IF DEVICE DATA
outputs to levels compatible with MECL and/or TTL. an inductor to lower the frequency or a capacitor to raise it. mA to 23 mA for the MC12061. within approximately ±0.001% from unit to unit. ppm/°C for MC12061 operating at 8.0 MHz (see NO TAG). Figure 9. Frequency drift is typically less than 0.0003% pin 2 or 3 is nominally 3.5 Vdc with VCC = +5.0 Vdc. 10) will drive up to ten gates, as defined in NO TAG.
- Noise floor (200 kHz from oscillator center frequency) is
conditions and/or translator operation.
- Close-in noise (100 Hz from oscillator center frequency)
- See text under signal characteristics.
Figure 8. Frequency Variation Due to Temperature Figure 9. Driving Low Impedance Loads
8 MOTOROLA RF/IF DEVICE DATA
Figure 13. Circuit Schematic
CASE 648–08 ISSUE R NOTES: 1. DIMENSIONING AND TOLERANCING PER ANSI Y14.5M, 1982. 2. CONTROLLING DIMENSION: INCH. 3. DIMENSION L TO CENTER OF LEADS WHEN FORMED PARALLEL. 4. DIMENSION B DOES NOT INCLUDE MOLD FLASH. 5. ROUNDED CORNERS OPTIONAL. –A– B F C S H G D J L M 16 PL SEATING 916 K PLANE–T– MAM0.25 (0.010) T DIM MIN MAX MIN MAX MILLIMETERSINCHES A 0.740 0.770 18.80 19.55 B 0.250 0.270 6.35 6.85 C 0.145 0.175 3.69 4.44 D 0.015 0.021 0.39 0.53 F 0.040 0.70 1.02 1.77 G 0.100 BSC 2.54 BSC H 0.050 BSC 1.27 BSC J 0.008 0.015 0.21 0.38 K 0.110 0.130 2.80 3.30 L 0.295 0.305 7.50 7.74 M 0 10 0 10 S 0.020 0.040 0.51 1.01 /C0095 /C0095 /C0095 /C0095 OUTLINE DIMENSIONS Motorola reserves the right to make changes without further notice to any products herein. Motorola makes no warranty, representation or guarantee regarding the suitability of its products for any particular purpose, nor does Motorola assume any liability arising out of the application or use of any product or circuit, and specifically disclaims any and all liability, including without limitation consequential or incidental damages. “Typical” parameters which may be provided in Motorola data sheets and/or specifications can and do vary in different applications and actual performance may vary over time. All operating parameters, including “Typicals” must be validated for each customer application by customer’s technical experts. Motorola does not convey any license under its patent rights nor the rights of others. Motorola products are not designed, intended, or authorized for use as components in systems intended for surgical implant into the body, or other applications intended to support or sustain life, or for any other application in which the failure of the Motorola product could create a situation where personal injury or death may occur. Should Buyer purchase or use Motorola products for any such unintended or unauthorized application, Buyer shall indemnify and hold Motorola and its officers, employees, subsidiaries, affiliates, and distributors harmless against all claims, costs, damages, and expenses, and reasonable attorney fees arising out of, directly or indirectly, any claim of personal injury or death associated with such unintended or unauthorized use, even if such claim alleges that Motorola was negligent regarding the design or manufacture of the part. Motorola and are registered trademarks of Motorola, Inc. Motorola, Inc. is an Equal Opportunity/Affirmative Action Employer. Mfax is a trademark of Motorola, Inc. How to reach us: USA / EUROPE / Locations Not Listed: Motorola Literature Distribution;JAPAN : Nippon Motorola Ltd.: SPD, Strategic Planning Office, 141, P.O. Box 5405, Denver, Colorado 80217. 1–303–675–2140 or 1–800–441–2447 4–32–1 Nishi–Gotanda, Shagawa–ku, Tokyo, Japan. 03–5487–8488 Customer Focus Center: 1–800–521–6274 Motorola Fax Back System – US & Canada ONLY 1–800–774–1848 51 Ting Kok Road, Tai Po, N.T., Hong Kong. 852–26629298 – http://sps.motorola.com/mfax/ HOME PAGE : http://motorola.com/sps/ MC12061/D