IL311 INTEGRAL | Alldatasheet

Document overview

  • Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
  • PDF pages: 2

Technical content

High Performance Voltage Comparators MAXIMUM RATINGS Symbol Parameter Value Unit VCC + VEE Total Supply Voltage 36 V VO - VEE Output to Negative Supply Voltage 40 V VEE Ground to Negative Supply Voltage 30 V VID Input Differential Voltage ± 30 V VIN Input Voltage (Note) ± 15 V - Voltage at Strobe Pin V CC to VCC - 5 V PD 1/θJA Power Dissipation and Thermal Characteristics Plastic Dual In-Line Packages Derate above TA =+25°C 625 5.0 mW mW/°C TJ(max) Operating Junction Temperature +150 °C Tstg Storage Temperature Range -60 to +150 °C Note: This rating applies for ±15 volt supplies. The positive input voltage limit is 30 volts above the negative supply. The negative input voltage limit is equal to the negative supply voltage or 30 volts below the positive supply, whichever is less. IL311

ORDERING INFORMATION

TA = -45°C to 85°C for all packages LOGIC DIAGRAM Input polarity is reversed when GND pin is used as an output. PIN ASSIGNMENT

RECOMMENDED OPERATING CONDITIONS Symbol Parameter Min Max Unit VCC + VEE Total Supply Voltage 30 V TA Operating Temperature, All Package Types - 45 +85 °C ELECTRICAL CHARACTERISTICS (VCC=+15 V, VEE= -15 V, T A =+25°C unless otherwise noted [Note 1]) Symbol Parameter Test Conditions Guaranteed Limits Unit Min Max VIO Input Offset Voltage (Note 2) RS ≤ 50 kΩ , TA = +25°C RS ≤ 50 kΩ , -45°C ≤ TA ≤ 85°C 7.5 mV IIO Input Offset Current (Note 2) TA = +25°C -45°C ≤ TA ≤ 85°C 100 nA IIB Input Bias Current TA = +25°C TA = -45°C TA = +85°C 250 375 500 nA AV Voltage Gain 150000 tDLH Propagation Delay Time 300 ns VDS Saturation Voltage TA = +25°C VID ≤ -10 mV, IO=50 mA 1.5 V VIR Input Voltage Range -14.5 13.0 V ICC Positive Supply Current +7.5 mA IEE Negative Supply Current -5.0 mA NOTES: 1. Offset voltage, offset current and bias current specifications apply for a supply voltage range from a single 5.0 volt supply up to ±15 volt supplies. 2. The offset voltages and offset currents given are the maximum values required to drive the output within a volt of either supply with a 1.0 mA load. Thus, these parameters define an error band and take into account the “worst case” effects of voltage gain and input impedance.