L9616_V01 STM | Alldatasheet

Document overview

  • Manufacturer or author: Provided By alldatasheet.com(free datasheet download site)
  • PDF pages: 17

Technical content

Datasheet sections

  • 1 Block diagram
  • 2 Pins description
  • 3 Electrical specifications
  • 3.1 Absolute maximum ratings
  • 3.2 Electrical characteristics
  • 3.3 Dynamic characteristics
  • 4 Functional description
  • 5 Package information
  • 5.1 SO-8 package information
  • 6 Revision history

Features

 AEC-Q100 qualified  ISO/DIS 11898 up to 1 Mbaud  Transmitter: – Generation of differential output signals – Short circuit protected from -5 V to 36 V, detection and shutdown – Slope control to reduce RFI and EMI – Two states adjustable slope control (≤1 Mbaud / ≤250 Kbaud)  Receiver: – Differential input with high interference suppression – Common mode input voltage range (V COM) from -2 V to VS+3 V  ESD protection level up to 4 kV  Package: SO-8

Description

The L9616 is a bidirectional transceiver for signal conditioning and processing in connection with a CAN controller. Data rates of up to 1 Mbaud are supported using either shielded or non-shielded pair of lines. *$3*36 Table 1. Device summary

1 Block diagram

Figure 1. Block diagram

2 Pins description

Figure 2. Pins connection diagram (top view) Table 2. Pins function

1 TXO Transmitter input

2 GND Ground

3 VS Supply voltage

4 RXO Receive output

5 RX1 Reference voltage

6 C_L Low side bus output

7 C_H High side bus output

8 ASC Adjustable slope control

3 Electrical specifications

3.1 Absolute maximum ratings

Note: All voltages, except bus voltage, are defined with respect to pin 2. Positive currents flow into the IC.

3.2 Electrical characteristics

the IC unless otherwise specified. Table 3. Absolute maximum ratings Table 4. Electrical characteristics

0.9 VS -V s V

Table 4. Electrical characteristics (continued)

3.3 Dynamic characteristics

RA = 60 Ω between C_H and C_L. Table 5. Dynamic characteristics

4 Functional description

device provides transmitting capability to the CAN controller. transients which may occur in an automotive environment. the transmitter output stages would be disabled immediately. 1 Mbaud) and low speed (≤ 250 kbaud). connecting the ASC pin to VS. Figure 3. Typical application Table 6. Functional table

Figure 4. Timing diagram

5 Package information

specifications, grade definitions and product status are available at: www.st.com. ECOPACK® is an ST trademark.

5.1 SO-8 package information

Figure 12. SO-8 package outline

Table 7. SO-8 package mechanical data

  1. Values in inches are converted from mm and rounded to 4 decimal digits.
  2. Dimension “D” does not include mold flash, protrusions or gate burrs.

Mold flash, protrusions or gate burrs shall not exceed 0.15mm in total (both side).

  1. Dimension “E1” does not include inter-lead flash or protrusions.

Inter lead flash or protrusions shall not exceed 0.25mm per side.

6 Revision history

Table 8. Document revision history 11-Jun-2008 1 Initial release. 27-Sep-2013 2 Updated disclaimer. Modified title in cover page. Added bullet “AEC-Q100 qualified” in cover page. Updated Section 5: Package information on page 14 .