L1119 UTC | Alldatasheet
Document overview
- Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
- PDF pages: 7
Technical content
UNISONIC TECHNOLOGIES CO., LTD L1119 C M O S I C w w w . u n i s o n i c . c o m . t w 1 of 7 Copyright © 2005 Unisonic Technologies Co., Ltd QW-R502-051,B 1.5A LOW DROPOUT REGULATORS DESCRIPTION The UTC L1119 is a fast ultra low-dropout linear regulator that developed in CMOS process which allows low quiescent current operation independent of output l oad current. This CMOS process also allows the device to oper ate under extremely low dropout conditions. The UTC L1119 allows to operate from a 2.5V~7.0V input supply. Wide range of preset output vo ltage options are available and respond very fast to step changes in load which makes them suitable for low voltage microprocessor applications. FEATURES * Low ground current * Load regulation of 0.04% * Output current of 1.5A DC is guaranteed * Accurate output voltage.(± 1.5%) * Extremely low output capacitor requirements * Over temperature/ Over current protection SOT-89 SOT-223 TO-252 *Pb-free plating product number: L1119L-xx ORDERING INFORMATION Order Number Pin Assignment Normal Lead Free Plating Package 1 2 3 Packing L1119-xx-AA3-A-R L1119L-xx-AA3-A-R SOT-223 G O I Tape Reel L1119-xx-AA3-C-R L1119L-xx-AA3-C-R SOT-223 G I O Tape Reel L1119-xx-AB3-A-R L1119L-xx-AB3-A-R SOT-89 G O I Tape Reel L1119-xx-AB3-B-R L1119L-xx-AB3-B-R SOT-89 O G I Tape Reel L1119-xx-AB3-C-R L1119L-xx-AB3-C-R SOT-89 G I O Tape Reel L1119-xx-AB3-D-R L1119L-xx-AB3-D-R SOT-89 I G O Tape Reel L1119-xx-TN3-D-R L1119L-xx- TN3-D-R TO-252 I G O Tape Reel L1119-xx-TN3-D-T L1119L-xx-TN3- D-T TO-252 I G O Tube Note: Pin assignment: I: VIN O : VOUT G:GND L1119L-xx-AA3-A-R (1)Packing Type (3)Package Type (4)Output Voltage Code (5)Lead Plating (2)Pin Assignment (1) R: Tape Reel, T: Tube (2) refer to Pin Assignment (3) AA3: SOT-223, AB3: SOT-89, TN3: TO-252 (4) xx: refer to Marking Information (5) L: Lead Free Plating , Blank: Pb/Sn
UNISONIC TECHNOLOGIES CO., LTD 2 of 7 www.unisonic.com.tw QW-R502-051,B MARKING INFORMATION PACKAGE VOLTAGE CODE MARKING SOT-223 12 3 DATE CODEVOLTAGE CODE PIN CODE LEAD PLATINGL1119 SOT-89 12 3 L1119 VOLTAGE CODEDATE CODE PIN CODE LEAD PLATING TO-252 12 :1.2V 15 :1.5V 18 :1.8V 25 :2.5V 33 :3.3V 50 :5.0V 123 UTC L1119 VOLTAGE CODE DATE CODE PIN CODE LEAD PLATING
UNISONIC TECHNOLOGIES CO., LTD 3 of 7 www.unisonic.com.tw QW-R502-051,B BLOCK DIAGRAM VIN VOUT GND
UNISONIC TECHNOLOGIES CO., LTD 4 of 7 www.unisonic.com.tw QW-R502-051,B ABSOLUTE MAXIMUM RATINGS PARAMETER SYMBOL RATINGS UNIT Input Supply Voltage V IN -0.3 ~ +7.5 V Output Voltage V OUT -0.3 ~ +7.5 V Output Current I OUT Short Circuit Protected Power Dissipation P D Internally Limited Operating Junction Temperature T OPR -40 ~ +125 Ċ Storage Temperature T STG -65 ~ +150 Ċ Note Absolute maximum ratings are those values beyond which the device could be permanently damaged. Absolute maximum ratings are stress ratings only and functional device operation is not implied. RECOMMENDED OPERATING RATINGS PARAMETER SYMBOL RATINGS UNIT Input Supply Voltage V IN 2.5 ~ 7.0 V Maximum Operating Current (DC) I OPR(MAX) 1.5 A Operating Junction Temperature T J -40 ~ +125 Ċ Note: Absolute maximum ratings are those values beyond which the device could be permanently damaged. Absolute maximum ratings are stress ratings only and functional device operation is not implied. ELECTRICAL CHARACTERISTICS (TJ=25°C, VIN =VOUT+1V, IL=10mA, COUT=33µF, unless otherwise specified.) PARAMETER SYMBOL TEST CONDITIONS MIN TYP MAX UNIT IL = 150 mA 38 45 Dropout Voltage (Note) V D IL = 1.5 A 870 mV Peak Output Current I PEAK 2.0 2.5 A IL = 150 mA 4 9 Ground Pin Current I GND IL = 1.5 A 5 14 mA Output Voltage Tolerance V OUT 10 mA ≤ IL ≤ 1.5A Line Regulation ∆VOUT VOUT+1V<VIN<7.0V 0.1 % Load Regulation ∆VOUT 10 mA < IL < 1.5 A 1.5 % SHORT CIRCUIT PROTECTION Short Circuit Current I SC 4.5 A AC PARAMETERS Output Noise Density ρN(l/f) f = 120Hz 0.8 µV BW = 10Hz – 100kHz 150 Output Noise Voltage eN BW = 300Hz – 300kHz 100 µV(rms) VIN = VOUT + 1.5V COUT =100uF, VOUT = 3.3V 60 Ripple Rejection RR VIN = VOUT + 0.3V COUT =100uF, VOUT = 3.3V 40 dB OVER TEMPERATURE PROTECTION Shutdown Threshold T SHDN 165 °C Thermal Shutdown Hysteresis T HYS 10 °C Note: Dropout voltage is defined as the minimum input to out put differential voltage at which the output drops 2% below the nominal value. Dropout voltage specification applies only to output voltages of 2.5V and above. For output voltages below 2.5V, the drop-out voltage is not hing but the input to output differential, since the minimum input voltage is 2.5V.
UNISONIC TECHNOLOGIES CO., LTD 5 of 7 www.unisonic.com.tw QW-R502-051,B TYPICAL CHARACTERISTICS (VIN=VOUT+1V, VOUT=2.5V, COUT=33µF, IOUT =10mA, CIN=68µF, Ta=25°C.) -40 -20 0 20 40 60 80 100 120 140 0.05 0.1 0.15 0.2 0.25 Temperature (¥) Drop-Out (V) IL=100mA IL=800mA Drop-Out Voltage vs Temperature (I L) -40 -20 0 20 40 60 80 100 120 140 0.15 0.175 0.2 0.225 Temperature (¥) Drop-Out (V) VOUT=3.3V Drop-Out Voltage vs Temperature (V OUT) 0.125 VOUT=2.5V VOUT=5V IOUT=800mA ¶VOUT vs Temperature 0.00 Delta VOUT (%) -0.10 -0.20 -0.30 -0.40 -0.50 -0.60 -0.70 -0.80 -0.90 -75 -50 -25 0 25 50 75 100 125 Temperature (¥) 0.010 Frequency (Hz) Noise (DŽV/ Hz ) Noise Density 1.000 0.100 100 1000 10000010000 VIN=3.5V, VOUT=2.5V, IL=10mA VIN (V) VOUT (V) Input Voltage vs Output Voltage 2.5 0.5 1.5 1234 IL=100mA IL=800mA
UNISONIC TECHNOLOGIES CO., LTD 6 of 7 www.unisonic.com.tw QW-R502-051,B TYPICAL CHARACTERISTICS(Cont.) 100 0.01 Frequency (Hz) Noise (DŽV/ Hz) Output Noise Density 0.1 1000 10000 100000 VOUT=2.5V COUT=33DŽF COUT=68DŽF 100 0.01 Noise (DŽV/ Hz) Output Noise Density 0.1 1000 10000 100000 VOUT=5V COUT=33DŽF COUT=68DŽF Frequency (Hz) -10 Frequency (Hz) Ripple Rejection vs Frequency 1M100K10K1K100 COUT=100DŽF IL=10mA COUT=100DŽF IL=800mA COUT=68DŽF IL=10mA Ripple Rejection (dB) Load Transient Response 3.2 20DŽs/DIV 3.3 3.4 3.5 3.6 IOUT (A) V OUT (V) Line Transient Response 5.4 10DŽs/DIV 3.2 3.3 3.4 VIN (V) V OUT (V) 4.4 Line Transient Response 5.3 10DŽs/DIV 3.2 3.3 3.5 VIN (V) VOUT (V) 4.3
UNISONIC TECHNOLOGIES CO., LTD 7 of 7 www.unisonic.com.tw QW-R502-051,B TYPICAL CHARACTERISTICS(Cont.) Line Transient Response 3.2 10DŽs/DIV 3.25 3.3 3.35 VIN (V) V OUT (V) 3.15 5.3 4.3 Line Transient Response 10DŽs/DIV 3.25 3.3 3.35 VIN (V) V OUT (V) 5.3 4.3 3.45 3.4 IOUT=1.5A IOUT=1.5A UTC assumes no responsibility for equipment failures that result from using products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or other parameters) listed in products specifications of any and all UTC products described or contained herein. UTC products are not designed for use in life support appliances, devices or systems where malfunction of these products can be reasonably expected to result in personal injury. Reproduction in whole or in part is prohibited without the prior written consent of the copyright owner. The information presented in this document does not form part of any quotation or contract, is believed to be accurate and reliable and may be changed without notice.