HC202S WORLDSEMI | Alldatasheet
Document overview
- Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
- PDF pages: 2
Technical content
www.world-semi.com/en I.General Description: HC202S Controller can work with mini SD card. Power on the controller without SD card, after seconds it will boot automatically call the built-in 100 kinds of patterns, can be sent to DMX512 and TTL signal. With SD card state,you can use the standard DMX512 to choose the built-in patterns and speed. Controllers can work as synchronization, synchronization signal should not exceed meters, measured 100 meters. Controller can drive 2048pixels maximum. The refresh frequency is maximum frame rate (<512 pixel). The maximum distance between the controller and lighting :for TTL signal is <15 meters; for 485 signal <30 meters. For TTL signal,you can make 10strings in parallel connection; Work Voltage(V) DC12-24V Dimension(mm) L122 73* H25 Weight(kg) 0.2 k g Power consumption(W) II Support IC Support IC Detail Models TM TM1809 TM1812 TM1914 UCS UCS2903,UCS2909,UCS2912 UCS1903,UC S1909,UCS1912 WS WS2801,WS28 WS2811 INK1003 INK1003 LPD LDP6803,LDP8806,LDP1109 D705 D705 SM SM16716,SM16715 DMX512 DMX512 For other ICs,please contact our company for consulting. III C ontroller read s SD card first if no SD card it will run the built-in pattern Under SD card state,you can choose the patterns and speed according to the buttons,but the [on/off] key will be invalid. Other operations is the same with no SD card state,details are described in followings. IV Connection Ways TTL Single line and double line signal interface
www.world-semi.com/en DAT :Data CLK Clock GND Signal ground DMX512 When choosing DMX512 Models will s end DMX512 signal ,choosing other models will send difference signal; with 485 receiving plate can make the signal transmission further. DMX512 signal A DMX512signal B GND Normally,no need the wires. V Operate Notice Choose IC model First press the [ON/Off] key,then screen will show OFF and enter the edit program state. Then press the [Mode/Speed] ,after choosing the models,press the [On/off] key to exit. Control Pixels Setting: First press the [ON/Off] key,then screen will show OFF and enter the edit program state. [UP] and [DOWN] to set the pixels,press the [On/off] key to exit. Set the patterns,speed and DMX address In the normal state, namely not in the OFF state. Press the [mode/off] key ,you can see the digital begin with P S A show as cycle. P stands for patterns,S stands for speed,A stands for DMX512 address,please be attention to this: DMX address only work in the DMX512 decoding and using standard DMX512 console which is used for controlling built-in patterns; Us e the UP and DOWN buttons to increase and decrease. Notice During installation,please pay attention to the rain, the normal working voltage is DC12-24V. N etwork line one one corresponding as followings: