DATASHEET SEARCH SITE | WWW.ALLDATASHEET.COM
Document overview
- Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
- PDF pages: 8
Technical content
Features
- High Data Rate, 5 MHz Typical (NRZ)
- Free from Latch−up and Oscillation Throughout V oltage and Temperature Ranges
- Microprocessor Compatible Drive
- Logic Compatible Output Sinks 16 mA at 0.5 V Maximum
- Guaranteed On/Off Threshold Hysteresis
- Wide Supply V oltage Capability, Compatible with All Popular Logic Systems
- Safety and Regulatory Approvals: ♦ UL1577, 4,170 V ACRMS for 1 Minute ♦ DIN−EN/IEC60747−5−5, 850 V Peak Working Insulation V oltage
Applications
- Logic−to−Logic Isolator
- Programmable Current Level Sensor
- Line Receiver − Eliminate Noise and Transient Problems
- AC to TTL Conversion − Square Wave Shaping
- Interfaces Computers with Peripherals
- Isolated Power MOS Driver for Power Supplies SCHEMATIC (Top View) Anode Cathode NC GND VCC VO Truth Table Input Output HL LH www.onsemi.com PDIP6 CASE 646BY MARKING DIAGRAM See detailed ordering, marking and shipping information on page 5 of this data sheet.
ORDERING INFORMATION
H11N1 = Device Code V = DIN EN/IEC60747 −5−5 Option = (only appears on component = ordered with this option) X = One −Digit Year Code, e.g., “6” YY = Digit Work Week, = Ranging from “01” to “53” Q = Assembly Package Code H11N1 V X YY Q
Table 1. SAFETY AND INSULATION RATINGS As per DIN EN/IEC 60747−5−5, this optocoupler is suitable for “safe electrical insulation” only within the safety limit data. Compliance with the safety ratings shall be ensured by means of protective circuits.
1360 Vpeak
1594 Vpeak
- Safety limit values – maximum values allowed in the event of a failure.
Table 2. ABSOLUTE MAXIMUM RATINGS TA = 25°C unless otherwise specified. should not be assumed, damage may occur and reliability may be affected.
Table 3. ELECTRICAL CHARACTERISTICS TA = 25°C unless otherwise specified Table 4. TRANSFER CHARACTERISTICS TA = 25°C unless otherwise specified Table 5. SWITCHING SPEED Table 6. ISOLATION CHARACTERISTICS performance may not be indicated by the Electrical Characteristics if operated under different conditions. degradation of the LED over its lifetime. The maximum allowable LED drive current is 30 mA.
www.onsemi.com TEST CIRCUIT C RE RL 0.1/C0109F VIN 5 V VO 90% ton trtf 10% 50% toff IF
1 H11N1M
tr = tf ≤ 0.01 /C0109s Z = 50 /C0087 270 /C0087 I6 5 V VO vr Figure 7. Switching Test Circuit and Waveforms
33 Sec
Figure 8. Reflow Profile Part Number Package Packing Method H11N1M DIP 6−Pin Tube (50 Units) H11N1SM SMT 6−Pin (Lead Bend) Tube (50 Units) H11N1SR2M SMT 6−Pin (Lead Bend) Tape and Reel (1000 Units) H11N1VM DIP 6−Pin, DIN EN/IEC60747−5−5 Option Tube (50 Units) H11N1SVM SMT 6−Pin (Lead Bend), DIN EN/IEC60747−5−5 Option Tube (50 Units) H11N1SR2VM SMT 6−Pin (Lead Bend), DIN EN/IEC60747−5−5 Option Tape and Reel (1000 Units) H11N1TVM DIP 6−Pin, 0.4″ Lead Spacing, DIN EN/IEC60747−5−5 Option Tube (50 Units)
www.onsemi.com PACKAGE DIMENSIONS PDIP6 8.51x6.35, 2.54P CASE 646BX ISSUE O
www.onsemi.com PACKAGE DIMENSIONS PDIP6 8.51x6.35, 2.54P CASE 646BY ISSUE O
www.onsemi.com PACKAGE DIMENSIONS PDIP6 8.51x6.35, 2.54P CASE 646BZ ISSUE O ON Semiconductor and are trademarks of Semiconductor Components Industries, LLC dba ON Semiconductor or its subsidiaries i n the United States and/or other countries. ON Semiconductor owns the rights to a number of patents, trademarks, copyrights, trade secrets, and other intellectual property . A listing of ON Semiconductor’s product/patent ON Semiconductor makes no warranty, representation or guarantee regarding the suitability of its products for any particular purpose, nor does ON Semiconductor assume any liability arising out of the application or use of any product or circuit, and specifically disclaims any and all liability, including without limitation special, consequential or incidental damages. Buyer is responsible for its products and applications using ON Semiconductor products, including compliance with all laws, reg ulations and safety requirements or standards, regardless of any support or applications information provided by ON Semiconductor. “Typical” parameters which may be provided in ON Semiconductor data sheets and/or specifications can and do vary in different applications and actual performance may vary over time. All operating parameters, including “Typicals” must be validated for each customer application by customer’s technical experts. ON Semiconductor does not convey any license under its patent rights nor the right s of others. ON Semiconductor products are not designed, intended, or authorized for use as a critical component in life support systems or any FDA Class 3 medical devices or medical devices with a same or similar classification in a foreign jurisdiction or any devices intended for implantation in the human body. Should Buyer purchase or use ON Semiconductor products for any such unintended or unauthorized application, Buyer shall indemnify and hold ON Semiconductor and its officers, employees, subsidiaries, affiliates, and distributors harmless against all claims, costs, damages, and expenses, and reasonable attorney fees arising out of, directly or indirectly, any claim of personal injury or death associated with such unintended or unauthorized use, even if such claim alleges that ON Semiconductor was negligent regarding the design or manufacture of the part. ON Semiconductor is an Equal Opportunity/Affirmative Action Employer. This literature is subject to all applicable copyright laws and is not for resale in any manner. PUBLICATION ORDERING INFORMATION N. American Technical Support: 800−282−9855 Toll Free USA/Canada Europe, Middle East and Africa Technical Support: Phone: 421 33 790 2910 H11N1M/D LITERATURE FULFILLMENT: Literature Distribution Center for ON Semiconductor 19521 E. 32nd Pkwy, Aurora, Colorado 80011 USA Phone: 303−675−2175 or 800−344−3860 Toll Free USA/Canada Fax: 303−675−2176 or 800−344−3867 Toll Free USA/Canada Email: orderlit@onsemi.com ON Semiconductor Website: www.onsemi.com Order Literature: http://www.onsemi.com/orderlit For additional information, please contact your local Sales Representative