FSA66_06 FAIRCHILD | Alldatasheet

Document overview

  • Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
  • PDF pages: 14

Technical content

Features

■ Space-saving SOT23 or SC70 5-lead package ■ Ultra small MicroPak™ leadless package ■ Broad VCC operating range: 1.65V–5.5V ■ Rail-to-rail signal handling ■ 5Ω switch connection between two ports ■ Minimal propagation delay through the switch ■ Low ICC ■ Zero bounce in flow-through mode ■ Control input compatible with CMOS input levels ■ >250 MHz –3dB bandwidth General Description The FSA66 is a ultra high-speed (UHS) CMOS compati- ble Single-Pole/Single-Throw (SPST) analog switch. The low On Resistance (RON) of the switch allows input to be connected to output with mini mal propagation delay and without generating additional ground bounce noise. The device is organized as a 1-bit switch with a switch enable (OE) signal. When OE is HIGH, the switch is on and Port A is connected to Port B. When OE is LOW, the switch is open and a high-impedance state exists between the two ports. Ordering Information Order Number Package Number PB-Free Product Code Top Mark Package Description Packing Method FSA66M5X MA05B Yes 7Z66 5- Lead SOT23, JEDEC MO-178, 1.6mm 3k Units on Tape and Reel FSA66P5X MAA05A Yes Z66 5-Lead SC70, EIAJ SC-88a, 1.25mm Wide 3k Units on Tape and Reel FSA66L6X MAC06 Yes EE 6-Lead MicroPak, 1.0mm Wide 5k Units on Tape and Reel MicroPak™ is a trademark of Fairchild Semiconductor Corporation.

©2006 Fairchild Semiconductor Corporation 2 WWW.FAIRCHILDSEMI.COM FSA66 Low-Voltage UHS Single SPST Normally Open Analog Switch FSA66 Rev. 1.0.1 Analog Symbol Pin Descriptions Function Table Connection Diagrams Pin Names Function OE Switch Enable Input AB u s A I / O BB u s B I / O NC No Connect OE B 0 Function L High-Z State Disconnect HA 0 Connect A B GND VCC OE B GND Pin Assignments for SC70 Pin Assignments for MicroPak (Top View) (Top Through View) A B GND VCC NC OE VCC OE

©2006 Fairchild Semiconductor Corporation 3 www.fairchildsemi.com FSA66 Low-Voltage UHS Single SPST Normally Open Analog Switch FSA66 Rev. 1.0.1 Absolute Maximum Ratings The “Absolute Maximum Ratings” are those values beyond which the safety of the device cannot be guaranteed. The device should not be operated at these limits. The parametric values defined in the Electrical Characteristics tables are not guaranteed at the absolute maximum ratings. The “Recommended Operating Conditions” table defines the conditions for actual device operation. Recommended Operating Conditions(2) Notes: 1. The input and output negative voltage ratings may be exceeded if the input and output diode current ratings are observed. 2. Unused inputs must be held HIGH or LOW. They may not float. Symbol Parameter Rating VCC Supply Voltage –0.5V to +7.0V VS DC Switch Voltage –0.5V to V CC +0.5V VIN DC Input Voltage(1) –0.5V to +7.0V IIK DC Input Diode Current, VIN < 0V –50mA IOUT DC Output Sink Current 128mA ICC/IGND DC VCC/GND Current ±100mA TSTG Storage Temperature Range –65°C to +150°C TJ Junction Lead Temperature under Bias +150°C TL Junction Lead Temperature (soldering, 10 seconds) +260°C PD Power Dissipation @ 85°C SOT23-5 200mW SC70-5 150mW Symbol Parameter Rating VCC Power Supply Operating 1.65V to 5.5V VIN Control Input Voltage 0V to 5.5V VIN Switch Input Voltage 0V to V CC VOUT Switch Output Voltage 0V to V CC tr, tf Input Rise and Fall Time Control Input; VCC = 2.3V to 3.6V 0ns/V to 10ns Control Input; VCC = 4.5V to 5.5V 0ns/V to 5ns Switch I/O 0ns/V to DC TA Operating Temperature −40°C to +85°C θJA Thermal Resistance SOT23-5 300°C/W SC70-5 425°C/W

©2006 Fairchild Semiconductor Corporation 4 www.fairchildsemi.com FSA66 Low-Voltage UHS Single SPST Normally Open Analog Switch FSA66 Rev. 1.0.1 Notes: 3. Measured by the voltage drop between A and B pins at the indicated current through the switch. ON resistance is determined by the lower of the voltages on the two (A or B) pins. 4. All typical values are at the specified VCC, and TA = 25°C. 5. Parameter is characterized, but not tested in production. 6. Flatness is defined as the difference between the maximum and minimum value of on resistance over the specified range of conditions. Symbol Parameter Conditions V CC (V) TA=25°C T A= -40°C to +85°C VIH HiGH-Level Input Voltage 1.65 to 1.95 ––– 0 . 7 5 VCC –– V VIL LOW-Level Input Voltage 1.65 to 1.95 VCC V IIN Control Input Leakage Cur- rent 0 ≤ V IOFF OFF Leakage Current RON Switch ON Resistance(3) VIN = 0V, IIN = 30mA 4.5 – – – – 3 7 Ω VIN = 2.4V, IIN = 15mA – – – – 5 12 VIN = 4.5V, IIN = 30mA – – – – 7 15 VIN = 0V, IIN = 24mA 3.0 – – – – 4 9 VIN = 3V, IIN = 24mA – – – – 10 20 VIN = 0V, IIN = 8mA 2.3 – – – – 5 12 VIN = 2.3V, IIN = 8mA – – – – 13 30 VIN = 0V, IIN = 4mA 1.8 – – – – 7 28 VIN = 1.8V, IIN = 4mA – – – – 25 60 Rflat On Resistance Flatness(3)(5)(6) IA = –30mA, 0 ≤ VBn ≤ VCC IA = –24mA, 0 ≤ VBn ≤ VCC IA = –8mA, 0 ≤ VB ≤ VCC IA = –4mA, 0 ≤ VBn ≤ VCC ICC Quiescent Supply Current VIN = VCC or GND IOUT = 0V 1.65 to 5.5 – – – – 0.05 10 μA

©2006 Fairchild Semiconductor Corporation 8 www.fairchildsemi.com FSA66 Low-Voltage UHS Single SPST Normally Open Analog Switch FSA66 Rev. 1.0.1 Tape Specification Tape Format for SOT23, SC70 Tape Dimensions Dimensions are in millimeters (inches) unless otherwise specified. Package Designator Tape Section Cavity Number Cavity Status Cover Tape Status M5X, P5X Leader (Start End) 125 (typ) Empty Sealed Carrier 3000 Filled Sealed Trailer (Hub End) 75 (typ) Empty Sealed Package Tape Size Dim A Dim B Dim F Dim K O Dim P1 Dim W SC70-5 8 mm 0.093 (2.35) 0.096 (2.45) 0.138 ± 0.004 (3.5 ± 0.10) 0.053 ± 0.004 (1.35 ± 0.10) 0.157 (4) 0.315 ± 0.004 (8 ± 0.1) SOT23-5 8 mm 0.130 (3.3) 0.130 (3.3) 0.138 ± 0.002 (3.5 ± 0.05) 0.055 ± 0.004 (1.4 ± 0.11) 0.157 (4) 0.315 ± 0.012 (8 ± 0.3)

©2006 Fairchild Semiconductor Corporation 9 www.fairchildsemi.com FSA66 Low-Voltage UHS Single SPST Normally Open Analog Switch FSA66 Rev. 1.0.1 Tape Specification (Continued) Tape Format Tape Dimensions Dimensions are in millimeters (inches) unless otherwise specified. Package Designator Tape Section Cavity Number Cavity Status Cover Tape Status L6X Leader (Start End) 125 (typ) Empty Sealed Carrier 5000 Filled Sealed Trailer (Hub End) 75 (typ) Empty Sealed

©2006 Fairchild Semiconductor Corporation 10 www.fairchildsemi.com FSA66 Low-Voltage UHS Single SPST Normally Open Analog Switch FSA66 Rev. 1.0.1 Reel Dimensions for Micropack 6 Dimensions are in millimeters (inches) unless otherwise specified. T a p e S i z e ABCDN W 1 W 2 W 3 8 mm 7.0 (177.8) 0.059 (1.50) 0.512 (13.00) 0.795 (20.20) 2.165 (55.00) 0.567 (14.40) W1 +0.078 / −0.039 (W1 +2.00 / −1.00)

©2006 Fairchild Semiconductor Corporation 11 www.fairchildsemi.com FSA66 Low-Voltage UHS Single SPST Normally Open Analog Switch FSA66 Rev. 1.0.1 Physical Dimensions Dimensions are in inches (millimeters) unless otherwise noted. 5-Lead SOT23, JEDEC MO-178, 1.6mm

©2006 Fairchild Semiconductor Corporation 12 www.fairchildsemi.com FSA66 Low-Voltage UHS Single SPST Normally Open Analog Switch FSA66 Rev. 1.0.1 Physical Dimensions (Continued) Dimensions are inches (millimeters) unless otherwise noted. 5-Lead SC70, EIAJ SC-88a, 1.25mm Wide

©2006 Fairchild Semiconductor Corporation 13 www.fairchildsemi.com FSA66 Low-Voltage UHS Single SPST Normally Open Analog Switch FSA66 Rev. 1.0.1 Physical Dimensions Dimensions are inches (millimeters) unless otherwise noted. Pb-Free 6-Lead MicroPak, 1.0mm Wide

©2006 Fairchild Semiconductor Corporation 14 www.fairchildsemi.com FSA66 Low-Voltage UHS Single SPST Normally Open Analog Switch FSA66 Rev. 1.0.1