EPA054-35

EPA054-25 PCA | Alldatasheet

Document overview

• Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
• PDF pages: 1

Technical content

TAP DELAYS TOTAL DELAYS PART ±5% or ±2 nS† ±5% or ±2 nS† NUMBER 5, 10, 15, 20 25 EPA054-25 6, 12, 18, 24 30 EPA054-30 7, 14, 21, 28 35 EPA054-35 8, 16, 24, 32 40 EPA054-40 9, 18, 27, 36 45 EPA054-45 10, 20, 30, 40 50 EPA054-50 12, 24, 36, 48 60 EPA054-60 15, 30, 45, 60 75 EPA054-75 20, 40, 60, 80 100 EPA054-100 25, 50, 75, 100 125 EPA054-125 30, 60, 90, 120 150 EPA054-150 35, 70, 105, 140 175 EPA054-175 40, 80, 120, 160 200 EPA054-200 45, 90, 135, 180 225 EPA054-225 50, 100, 150, 200 250 EPA054-250 60, 120, 180, 240 300 EPA054-300 70, 140, 210, 280 350 EPA054-350 TAP DELAYS TOTAL DELAYS PART ±5% or ±2 nS† ±5% or ±2 nS† NUMBER 80, 160, 240, 320 400 EPA054-400 84, 168, 252, 336 420 EPA054-420 88, 176, 264, 352 440 EPA054-440 90, 180, 270, 360 450 EPA054-450 94, 188, 282, 376 470 EPA054-470 100, 200, 300, 400 500 EPA054-500 110, 220, 330, 440 550 EPA054-550 120, 240, 360, 480 600 EPA054-600 130, 260, 390, 520 650 EPA054-650 140, 280, 420, 560 700 EPA054-700 150, 300, 450, 600 750 EPA054-750 160, 320, 480, 640 800 EPA054-800 170, 340, 510, 680 850 EPA054-850 180, 360, 540, 720 900 EPA054-900 190, 380, 570, 760 950 EPA054-950 200, 400, 600, 800 1000 EPA054-1000 †Whichever is greater. Delay times referenced from input to leading edges at 25°C, 5.0V, with no load.

16 Pin DIP 5 Tap TTL Compatible Active Delay Lines

EIN Pulse Input Voltage 3.2 Volts PW Pulse Width % of Total Delay 110 % TRI Pulse Rise Time (0.75 - 2.4 Volts) 2.0 nS PRR Pulse Repetition Rate @ Td ≤ 200 nS 1.0 MHz Pulse Repetition Rate @ Td > 200 nS 100 KHz VCC Supply Voltage 5.0 Volts Input Pulse Test Conditions @ 25° C Unit VOH High-Level Output VoltageV CC = min. VIL= max. IOH = max 2.7 V VOL Low-Level Output VoltageV CC = min. VIH = min. IOL= max 0.5 V VIK Input Clamp Voltage V CC = min. II= IIK -1.2 V IIH High-Level Input CurrentV CC = max. VIN= 2.7V 50 µA V CC = max. VIN = 5.25V 1.0 mA IIL Low-Level Input Current V CC = max. VIN = 0.5V -2 mA IOS Short Circuit Output CurrentV CC = max. VOUT = 0. -40 -100 mA (One output at a time) ICCH High-Level Supply CurrentV CC = max. VIN = OPEN 75 mA ICCL Low-Level Supply CurrentV CC = max. VIN= 0 75 mA TRO Output Rise Time Td ≤ 500 nS (0.75 to 2.4 Volts) 4 nS Td > 500 nS 5 nS NH Fanout High-Level OutputV CC = max. VOH = 2.7V 20 TTL LOAD NL Fanout Low-Level Output V CC = max. VOL = 0.5V 10 TTL LOAD Parameter Test Conditions Min Max Unit VCC Supply Voltage 4.75 5.25 V VIH High-Level Input Voltage 2.0 V VIL Low-Level Input Voltage 0.8 V IIK Input Clamp Current -18 mA IOH High-Level Output Current -1.0 mA IOL Low-Level Output Current 20 mA PW * Pulse Width of Total Delay 40 % d* Duty Cycle 40 % TA Operating Free-Air Temperature -55 +125 °C Recommended Operating Conditions Min Max Unit *These two values are inter-dependent. Schematic DSA054 Rev. A 2/5/96 QAF-CSO1 Rev. B 8/25/94 Unless Otherwise Noted Dimensions in Inches Tolerances: Fractional = ± 1/32 16799 SCHOENBORN ST. NORTH HILLS, CA 91343 TEL: (818) 892-0761 FAX: (818) 894-5791 E L E C T R O N I C S I N C . 14 4 12 6 10 OUTPUT GROUND INPUT

16 VCC

.365 Max. .88 Max. PCA EPA054-25 Date Code .250 Max. .020 Typ. White Dot Pin#1 .300 .200 .280 Max. .010 Typ. .150 Typ. .020 .040