DSD2410_10 CRYDOM | Alldatasheet
Document overview
- Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
- PDF pages: 5
Technical content
- Time-delay solid-state relays
- Ratings from 10A to 50A @ 240 VAC
- External time adjustment
- DC control
- Zero-crossing (resistive loads) output
- Ideal for compressor applications CE Compliant to EN60950-1 PRODUCT SELECTION Description 10 A 25 A 50 A 3.5-15 VDC Control DSD2410 DSD2425 DSD2450 3.5-15 VDC Control DLD2410 DLD2425 DLD2450 OUTPUT SPECIFICATIONS (voltage) (1)
Description
Operating Voltage (47-63Hz) [Vrms] 48-280 Transient Overvoltage [Vpk] 600 Maximum Off-State Leakage Current @ Rated Voltage [mArms] 10 Minimum Off-State dv/dt @ Maximum Rated Voltage [V/µsec] (2) 500 OUTPUT SPECIFICATIONS (current) (1) Description 10 A 25 A 50 A Maximum Load Current (3) [Arms] 10 25 50 Minimum Load Current (3) [Arms] 0.04 0.04 0.04 Maximum Surge Current (16.6ms) [Apk] 120 250 625 Maximum On-State Voltage Drop @ Rated Current [Vpk] 1.6 1.6 1.6 Thermal Resistance Junction to Case (Rjc) [°C/W] 1.48 1.02 0.63 Maximum I²t for Fusing (8.3 msec) [A²sec] 60 260 1620 Minimum Power Factor (with Maximum Load) 0.5 0.5 0.5 INPUT SPECIFICATIONS (1) Description DC Control Control Voltage Range 3.5-15 VDC Maximum Turn-On Voltage 3.5 VDC Maximum Turn-Off Voltage 1.0 VDC Typical Input Current 3.4 mA @ 5 Vdc, 11.4 mA @ 15 Vdc Nominal Input Impedance 1500 Ohm Maximum Turn-On Time [msec] (4) Adlustable, See Table Maximum Turn-Off Time [msec] 1/2 Cycle Maximum Reset Time [µsec] (5) 100 TYPICAL TURN-ON DELAY Resistor Time DSD Time DLD 0 (Short) .10 sec 1.6 sec 10K .19 sec 3.1 sec 100K .94 sec 15 sec 470K 4.0 sec 64 sec 1.0M (4) 8.3 sec 133 sec
Dielectric Strength, Input/Output/Base (50/60Hz) 4000 Vrms Minimum Insulation Resistance (@ 500 V DC) 1010 Ohm Ambient Operating Temperature Range -30 to 80°C Ambient Storage Temperature Range -40 to 125°C Weight (typical) 3.0 oz. (43g) Encapsulation Themally Conductive Epoxy Terminals Screws and saddle Clamps Furnished, Unmounted GENERAL NOTES 1) All parameters at 25°C unless otherwise specified. 2) Off-State dv/dt test method per EIA/NARM standard RS-443, paragraph 13.11.1 3) Heat sinking required, see derating curves. 4) Timing Resistor may be as high as 10M Ohm with performance dependent on resistor quality 5) Before and after time-out.
THERMAL DERATE INFORMATION AGENCY APPROVALS UL E116949 Rev. 122010
ANNEX - ENVIROMENTAL INFORMATION