DS657-9-3 ASTEC | Alldatasheet

Document overview

  • Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
  • PDF pages: 4

Technical content

rev 04.27.05 Americas: 1-888-41-ASTEC Europe (UK): 44 (1384) 842-211 Asia (HK): 852-2437-9662 152 Special Features Electrical Specs

  • EN61000-3-2 Harmonic Compliance
  • Active Power Factor Correction
  • Active Current Share
  • 1U high
  • FCC 47 CFR Part 15 Class A (US)
  • CISPR22 Class A
  • EN55022:1998 (Europe)
  • EN61000 Immunity Standards
  • 12V standby
  • Fan Speed Control
  • Over Current Protection (OCP)
  • Over Voltage Protection (OVP)
  • Over Temperature Protection (OTP)
  • IEC320 AC Inlet
  • On/off switch
  • I2C Communications
  • No minimum load required
  • 2250VDC Isolation
  • IEEE 802.3af Compliant Power Source
  • 1 year warranty Input Input Range 85-264VAC Frequency 47 - 63 Hz Inrush Current 17A max, 115VAC, 25°C Efficiency 80% typical at full load, 115VAC EMI Filter Class A Power Factor 0.99 typical Leakage Current 2mAmaximum @ 240 VAC Output Maximum Power 657W Hold Up Time 20ms (minimum) Over Current 110% - 130% of nominal Autorecovery Protection (OCP) Short Circuit Latch off main outputs if one Protection of the main output short circuits to common Over Voltage 107% - 117% of nominal Protection (OVP) Latch, AC recycle to reset Logic Control AC OK TTL signal HIGH DC OK TTL signal LOW ENABLE Logic LOW (<1V) capable of 2mA sink current Operating Temperature: 0°C to 50°C (50% power derating at 70°C) MTBF (MIL HDBK 217F):>100KHrs at full load, 40°C Humidity: Operating: 85% RH, non-condensing Non-operating: 95% RH, non-condensing Electromagnetic Susceptibility: Designed to meet Environmental Total Power: 657 Watts Input Voltage: 85-264 VAC # of Outputs: Two & Standby Safety UL/cUL 60950 3rd Edition TUV EN60950 3rd Edition IEC60950 3nd Edition CE Mark EN60950 3rd Edition

657 WattsDS657-9-3

Units 2111-2116, Level 21 Tower1, Metroplaza 223, HingFongRoad Kwai Fong,NewTerritories HongKong Telephone: 852-2437-9662 Facsimile: 852-2402-4426 EEUURROOPPEE Astec House,Waterfront BusinessPark Merry Hill,Dudley West Midlands,DY5 1LX, UK Telephone: 44 (1384) 842-211 Facsimile: 44(1384) 843-355 AAMMEERRIICCAASS

5810 Van Allen Way

Carlsbad,CA 92008 Telephone: 760-930-4600 Facsimile: 760-930-0698 153 www.astecpower.com DDCC OOuuttppuutt VVoollttaaggeess Notes: 1.Ripple and noise tested with 10µF capacitor in parallel with a 0.1µF capacitor,20MHz bandwidth. OOuuttppuutt VVoollttaaggee((VV)) RReegguullaattiioonn MMiinniimmuumm LLooaadd ((AA)) MMaaxxiimmuumm LLooaadd ((AA)) RRiippppllee((ppeeaakk-ppeeaakk)) VV11 +48V/+51V ±5% 0.0 10.0 500mV VV22 12V ±5% 0.0 12.0 120mV VV33 12V ±5% 0.0 0.5 120mV DDCC OOuuttppuutt VVoollttaaggeess DDSS665577-99-33 MMeecchhaanniiccaall DDrraawwiinnggss:: PPSSUU CCoonnnneeccttoorr:: FFCCII 5511772200-1100220022440022AAAA 1 2 3 4 5 6 J KNS P1 P2 P3 P4 PPiinn LLooccaattiioonn SSiiggnnaall RReeffeerreennccee P1 12V Output P2 12V Output RTN 1J 1 2 V+S e n s e 1K 1 2 V-S e n s e 1N 12V Current-Share 1S P o w e rS u p p l yP r e s e n t 2J Serial Data Line 2K Serial Clock Line 2N Address Input0 2S Address Input1 3J 1 2 VAuxOutputRTN 3K 12V INHIBIT 3N 51V INHIBIT 3S Address Input2 4J 12V Aux Output 4K DC OK 4N ACOK 4S FANFAIL/OTP 5J NOTCONNECTED 5K NOTCONNECTED 5N NOTCONNECTED 5S NOTCONNECTED 6J 5 1 V+S e n s e 6K 5 1 V-S e n s e 6N 51V Current-Share 6S NOTCONNECTED P3 51V Output RTN P4 51V Output MMaattiinngg CCoonnnneeccttoorr FFCCII 5511774400-1100220022440022AAAA DDSS665577-99-33

North America (USA): 1-888-41-ASTEC Europe (UK): 44 (1384) 842-211 Asia (HK): 852-2437-9662 154 rev 04.27.05 12V Current-Share (In/Out Signal) Pin 1 J C-Share Pin is used when connecting units in parallel to achieve current sharing. Current share accuracy is typically 10% of full load. Pin P2 Note: Current-Share voltage is 1.5V at 100% load current (12A) 12V Remote Sense Pin 1J - 12V +Sense Pin 1K Compensates for up to 0.5V drop. Recommended shielded twisted wire pair. 12V Inhibit (In Signal) Pin 3K Pin 3J 12V O/P Enabled OUT LED: ON OFF 12V O/P Disabled 51V Inhibit (In Signal) Pin 3N Pin 3J 0V

51 O/P

OUT LED: ON OFF 51V O/P Disabled DC OK (Out Signal) Pin 4K Pin 3J 0V DC OK IN LED: ON OFF OUT LED: ON OFF DC NOT OK AC OK (Out Signal) Pin 4N Pin 3J 0V AC OK IN LED: ON OFF OUT LED: ON OFF AC NOT OK FANFAIL/OTP (OUT Signal) Pin 4S Pin 3J 0V FAN OK TEMP LED OFF ON AC OK LED: ON OFF DC OK LED: ON OFF FAN NOT OK 51V Current-Share (In/Out Signal) Pin 6N C-Share Pin is used when connecting units in parallel to achieve current sharing. Current share accuracy is typically 10% of full load. Pin P3 Note: Current-Share voltage is 2.5V at 100% load current (10A) 51V Remote Sense Pin 6J 51V +Sense Pin 6K 51V -Sense Compensates for up to 0.5V drop. Recommended shielded twisted wire pair. 1.1. 2.2. Logic Signal DS657-9-3

Astec House,Waterfront BusinessPark Merry Hill,Dudley West Midlands,DY5 1LX, UK Telephone: 44 (1384) 842-211 Facsimile: 44(1384) 843-355 AAMMEERRIICCAASS Carlsbad,CA 92008 Telephone: 760-930-4600 Facsimile: 760-930-0698 155 www.astec.com ASIA Units 2111-2116, Level 21 Tower1, Metroplaza 223, HingFongRoad Kwai Fong,NewTerritories HongKong Telephone: 852-2437-9662 Facsimile: 852-2402-4426 15.5 127.1 135.2 381.0 342.9 260.4 4.6 40.4 20.2 365.0 29.4 119.5 4S : OTF 4K : OGOOD 4N : PF 4J : Vaux 5K : NC 6K : Vo1 - S 6J : Vo1 + S 5J : NC 6N : Vo1 - CS 5N : NC 6S : NC 5S : NC 2K : SCL 1K : Vo2 - S 3K : Vo2 ENA MODEL DS657-9-3 MAXIMUM OUTPUT POWER IS 650W SERIAL NO: INPUT: 100-240VAC 50/60HZ 11.5A max ENG# DATE: 0402REV: 0A OUTPUT PIN DESIGNATION 2J : SDA 1J : Vo2 + S 3J : Vaux RTN 1N : Vo2 - CS 2N : A0 3N : Vo1 ENA OUTPUTS: Vo1 : 51V @ 10A Vo2 : 12V @ 12A Vaux : 12V @ 0.25A ASTEC ID: MADE IN PHILIPPINES CIEI# 2S : A1 1S : PS - UP 3S : A2 DS657-9-3 PSUOutline