DS1703K MAXIM | Alldatasheet
Document overview
- Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
- PDF pages: 11
Technical content
bits. To change the value of the bits, select the combo box and change it to the desired setting. configuration register reads. The bits listed without combo boxes are read only bits. a read is also done, and the form is updated. This ensures the write process was successful. Figure 8. DS1620/DS1720 Other Registers Tab Temperature Threshold (TL) registers. the button. These two registers are read only. in the Celsius box, the software will convert that to 06Eh and send the data to the part.
the part, and the part initiates a power-on reset. Figure 12. DS1626/1726 Thermometer Tab the 1SHOT bit (bit 0), and then issue a Write Config (0Ch) command.
- This page gives access to the bits in the configur ation register. The details of using this page are
described in the DS1620/DS1720 Register Tab section.
Figure 14. DS1722 Thermometer Tab the DS1722, this should be the first option select ed to ensure the part communicates properly. may be slow to respond to button presses and changes. writing the data to address 80h. different setting. The hex value of the configuration register is shown in the small text box at the top.
Figure 15. DS1722 Registers Tab and the form is updated to show the current status. sampling time available is 8s. The software will revert to this value if anything less is selected.