CL9P5LQ CLAIREX | Alldatasheet
Document overview
- Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
- PDF pages: 1
Technical content
Clairex Technologies, Inc. 1301 East Plano Parkway Plano, Texas 75074-8524 Phone: 972-265-4900 Fax: 972-265-4949 www.clairex.com CL9P5LQ Epoxy-encapsulated Photoconductors (Replaces the CL9P5L) Clairex Technologies, Inc. November, 2003
features
- thicker ceramic substrate
- low cost epoxy encapsulation
description
The CL9P5LQ consists of CdS base material deposited on a ceramic substrate and epoxy encapsulated. The CL9P5LQ is electrically equivalent to, and replaces, the CL9P5L and CL905L. For applications assistance, call Clairex. absolute maximum ratings (TA = 25°C unless otherwise stated) notes: 1. 0.06” (1.5mm) from the case for 5 seconds maximum. 2. The CL9P5LQ has a 0.079” thick subs trate and 1.0” minimum length leads. The CL9P5L had a 0.055” thick substrate and 1.4” minimum length leads. Clairex reserves the right to make changes at any time to improve design and to provide the best possible product. electrical characteristics (TA = 25°C unless otherwise noted) Part Number Material Type RON(1)(2) Ω(typ) ROFF(3) Ω (min.) Vmeas(4) Volts V(max) Volts CL9P5LQ CdS,CdSe 10K 670K 100 notes: 1. On-resistance (RON) is measured at 2 ft-c after light stabilization at 30 ft-c for 16 hours minimum just prior to test. RON tolerance is ±33% at 2 ft-c. 2. Light source for all R ON measurements is an unfiltered tungsten source operating at a color temperature of 2854K. 3. Off-resistance (R OFF) is measured under dark conditions, 5 seconds after RON test. A dark condition is reached when the value of ROFF can not be increased by further irradiation shielding. 4. Measurement voltage (Vmeas) is the steady-state bias applied to the device for measurement of RON and ROFF. ALL DIMENSIONS ARE IN INCHES Pattern shown is typical and may vary from part to part. Revised 3/15/06