CEF400-112C MURATA | Alldatasheet

Document overview

  • Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
  • PDF pages: 3

Technical content

FEATURES

n 400W continuous output power n IEC EN61000-3-2 compliance n Remote sense compensation n AC Power Fail signal n DC Power Good signal n Remote Inhibit control n Droop current share n I2C interface n 5V Standby n Low profile (1U) n Integrated cooling fan n Over-voltage protection n Over-current protection n Thermal overload protection n Built-in OR-ing FET

DESCRIPTION

The CEF400-112C is a 400W active power- factor-corrected (PFC) front-end power supply for distributed power architecture (DPA) systems requiring high power density in a 1U low profile package. The built-in OR-ing FET allows the power supply to operate in active current sharing mode for redundant (N+1) operation. Additional features include I2C interface, built-in fan and a 5V standby auxiliary output. The CEF400-112 provides reliable 12V bulk power for Information Technology Equipment and Industrial Applications. OUTPUT CHARACTERISTICS Output Voltage Parameter Conditions Min. Typ. Max. Units 12V Ripple Voltage & Noise ➀ 20MHz Bandwidth 175 mV p-p Rated Output Current 33.3 A 5Vsb Voltage Set Point Accuracy 4.85 5 5.15 VDCLine and Load Regulation 4.85 5.15 Ripple Voltage & Noise ➀ 20MHz Bandwidth 50 mV p-p Rated Output Current 1.3 A GENERAL Parameter Conditions Min. Typ. Max. Units Remote Sense Sum of +ve & -ve drops 500 mV Efficiency Full load, high line 83 % Turn on Delay 2 s Transient Response 12V Ramp 1A/μs 33% step ±375 mV 5Vsb Ramp 1A/μs 33% step ±40 Current Sharing Accuracy 200-720W load 2 in parallel 45/55 % Hold-up Time, to 10.8V 400W, 120Va c line 20 ms Isolation Output to Chassis-Basic 500 VrmsInput to Chassis-Basic 1500 Temperature Coefficient Full load and 100V a c input 0.02 % / °C ➀ Ripple and noise are measured with 0.1 µF of ceramic capacitance and 10 µF of tantalum capacitance on each of the power supply outputs. The output noise requirements apply over a 0 Hz to 20 MHz bandwidth. A short coaxial cable with 50Ω scope termination is used. PROTECTION CHARACTERISTICS Parameter Output Voltage Conditions Min. Typ. Max. Units Over Voltage 12V Latching 14.065 14.5 14.935 V Over Current Auto-restart 36 38 42 A Short Circuit The 12V output shall current limit and shutdown during a shorted output condition, and shall automatically restart after the short is removed. Over Voltage 5Vsb Latching 5.6 6 V Over Current Auto-restart 1.4 2.1 2.65 A Over-temperature Unit Auto-restart Unit shall self-protect against excessive internal temperatures and automatically recover. Input Undervoltage No damage will be sustained by operation at voltages below the specified input operating voltage range. INPUT CHARACTERISTICS Parameter Conditions Min. Typ. Max. Units Input Voltage Operating Range (AC) 85 264 Va c Input Frequency 47 63 Hz Turn-on Input Voltage Ramp up 76 85 Va c Turn-off Input Voltage Ramp down 63 78 Maximum Input Current 1.75 6.5 Arms Inrush Current 20 Apk Power Factor IEC EN61000-3-2 compliant Leakage Current 264 Va c input 0.90 mA PRODUCT SPECIFICATIONS Technical enquiries email: sales@murata-ps.com, tel: +1 508 339 3000www.murata-ps.com MPS_CEF400-112C.B16 Page 1 of 3 CEF400-112C

400 Watt Open Frame Single Output

AC/DC Switching Power Supply Ḥ For full details go to www.murata-ps.com/rohs

cUL CSA C22.2 No. 60950-1 CB Certificate and report CE CE Mark - Comply with LVD Material Flammability UL 94V-0 EMISSIONS AND IMMUNITY EMI EN55022 Class B conducted Electromagnetic Susceptibility ESD IEC/EN 61000-4-2, Level 3 Electromagnetic Field IEC/EN 61000-4-3, Level 3 Electrical Fast Transients/Burst IEC/EN 61000-4-4, Level 3 Surge IEC/EN 61000-4-5, Level 3 RF Conducted Immunity IEC/EN 61000-4-6, Level 3 Magnetic Immunity IEC/EN 61000-4-8, Level 3 Voltage Dips, Interruptions IEC/EN 61000-4-11, Level 3 MECHANICAL Weight 2.0 lbs (0.91 kgs) Vibration Designed to meet IEC 68-2-6 to the levels from IEC 721-3-2 Shock Designed to meet IEC 68-2-27 Drop Designed to meet IEC 68-2-31 Tip over Designed to meet IEC 68-2-31 ENVIRONMENTAL CHARACTERISTICS Parameter Conditions Min. Typ. Max. Units Storage Temperature Range Non-condensing –40 + 85 °COperating Temperature Range w/o derating 0 50 Operating Humidity Non-condensing 10 90 %Storage Humidity 5 95 MONITORING AND CONTROL SIGNALS AC Fail TTL logic signal goes high to denote loss of AC input. Power supply will provide a minimum of 5ms from loss of AC input before this signal goes high. Additionally a minimum of 3ms of holdup will be provided between the signal going high and the output going out of regulation. The signal will not go high when loss of AC input is less than 5ms in duration. DC OK TTL logic goes high after the output is in regulation. It goes low when there is loss of regulation. Remote On/Off TTL logic input signal disables the output when held low, and enables the output when held high. Remote Sense Compensates for 0.5 V lead drop min. Will operate without remote sense connected. Unit is protected against reverse connection of the remote sense lines. Notes Specifications subject to change without notice. Specifications are at factory settings. Warranty: 1 year. 1Calculated figures exclude the integral fan. RELIABILITY MTBF Calculated1 per MIL-HDBK-217N2, GB, 25°C, Quality Level I 212khrs Calculated 1 per Telcordia SR-332, Issue 1, Method 1, Case 3, GFC, Ground fixed, Controlled, Quality Level I 293khrs Technical enquiries email: sales@murata-ps.com, tel: +1 508 339 3000www.murata-ps.com MPS_CEF400-112C.B16 Page 2 of 3 CEF400-112C AC/DC Switching Power Supply

J1 (Molex #26-62-4051, 5 Position, 3-Pin, .156" Straight Header) Mating Plug Housing Molex #09-50-8051 Mating Crimp Terminal Molex #08-52-0113 J5 (Molex #90130-3210, 10 Position C-Grid-III Receptacle, .100") Mating Plug Housing Molex #90142-0012 Mating Crimp Terminal Molex #90119-0121 J7 (Molex #87833-1231, 12 Position 2mm Milli-Grid) Mating Plug Housing Molex #51110-1260 Mating Crimp Terminal Molex #50394-8100 A B A A B B A B 4.700 .75 1.15 2.500 4.00 7.00 5.500 .75 6-32 THDS (8 'B' PLS) A B B M3 THDS (6 'A' PLS) APPLY LABEL (ITEM 580) ON COVER, ORIENT AS SHOWN C 6 A2

7 N/C

9 GND

10 GND

11 GND

12 GND

+Sense3 -Sense2 J5 Aux/Control Connector Pin # Function 1 NC AC Fail10 DC OK9 Remote On/Off8 Common7 +12V6 5VSB Return5 5VSB (Standby)4 J7 I2C Control Connector Pin # Function

1 SCL

2 SDA

Pin # Function

1 Line

2 No Pin

3 Neutral

4 No Pin

5 Ground

1.0mm STEEL PIN #1 PIN #6 PIN #5 INPUT ENDBOTTOM 1.59 PIN #6 PIN #1 PIN #7 PIN #1 J1 COM +V AIRFLOW 2X 10-32-UNF-2A OUTPUT SCREWS A TYPICAL SIDE VIEW B B .85 .25 5.850 6.250 Technical enquiries email: sales@murata-ps.com, tel: +1 508 339 3000www.murata-ps.com MPS_CEF400-112C.B16 Page 3 of 3 CEF400-112C AC/DC Switching Power Supply Murata Power Solutions, Inc. makes no representation that the use of its products in the circuits described herein, or the use of other technical information contained herein, will not infringe upon existing or future patent rights. The descriptions contained herein do not imply the granting of licenses to make, use, or sell equipment constructed in accordance therewith. Specifications are subject to change without notice. © 2008 Murata Power Solutions, Inc. USA: Mansfield (MA), Tel: (508) 339-3000, email: sales@murata-ps.com Canada: Toronto, Tel: (866) 740-1232, email: toronto@murata-ps.com UK: Milton Keynes, Tel: +44 (0)1908 615232, email: mk@murata-ps.com France: Montigny Le Bretonneux, Tel: +33 (0)1 34 60 01 01, email: france@murata-ps.com Germany: München, Tel: +49 (0)89-544334-0, email: munich@murata-ps.com Japan: Tokyo, Tel: 3-3779-1031, email: sales_tokyo@murata-ps.com Osaka, Tel: 6-6354-2025, email: sales_osaka@murata-ps.com China: Shanghai, Tel: +86 215 027 3678, email: shanghai@murata-ps.com Guangzhou, Tel: +86 208 221 8066, email: guangzhou@murata-ps.com Singapore: Parkway Centre, Tel: +65 6348 9096, email: singapore@murata-ps.com Murata Power Solutions, Inc. 11 Cabot Boulevard, Mansfield, MA 02048-1151 U.S.A. Tel: (508) 339-3000 (800) 233-2765 Fax: (508) 339-6356 www.murata-ps.com email: sales@murata-ps.com ISO 9001 REGISTERED 10/02/08