C10A50Z4 ANAREN | Alldatasheet
Document overview
- Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
- PDF pages: 2
Technical content
Place Manufacturing. USA/Canada: Toll Free: Europe : (315) 432-8909 (800) 544-2414 +44 2392-232392 Model C10 A50Z4 Features:
- 10 Watts
- Lowest Cost
- RoHS Compliant
- Alumina Ceramic
- Non-Nichrome Resistive Element
- Low VSWR
- 100% Tested Surface Mount Termination
10 Watts, 50 ΩΩ ΩΩ
Description
The C10A50Z4 is high performance RoHS compliant Alu mina (Al 2O3) surface mount termination intended as a lower cost alternative to Aluminum Nitride (AlN) and Beryllium Oxide (BeO). T he termination is well suited to all cellular frequency bands such as ; AMPS, GSM, DCS, PCS, PHS and UMTS. The high power handling makes th e part ideal for terminating 90 degree hybrid directional couplers, and for use in isolators. General Specifications Resistive Element Thick film Substrate Alumina Ceramic Terminal Finish Matte Tin over Nickel Operating Temperature -55 to +125 °C (see chart) Tolerance is ±0.010”, unless otherwise specified. Designed to meet of exceed applicable portions of MIL-E-5400. All dimensions in inches. Electrical Specifications Resistance Value: 50 ohms, ± 2% Power: 10 Watts Frequency Range: DC – 3.0 GHz Specification based on unit properly installed using suggested mounting instructions and a 50 ohm nominal impedance. Specifications subject to change without notice Outline Drawing All dimensions in inches. 07/26/2006 Rev. B
USA/Canada: Toll Free: Europe: (315) 432-8909 (800) 544-2414 +44 2392-232392 Available on Tape and Reel For Pick and Place Manufacturing. Model C10A50Z4 Typical Performance: Power De-rating: Tape & Reel: Mounting Footprint and Procedure: 50 ohm line 0.092 [2.34] 0.025 [0.63] 0.035 [0.89] 0.060 [1.52] Ø0.031 [Ø0.79] 0.250 [6.35] Ø0.101 [Ø2.57] 2x 4-40 Screw Hole Dimension given in inches [millimeters] For best thermal performance the PCB should be soldered to the heat sink. 1. Drill thermal vias through PCB and fill with sold er. 2. To ensure good thermal connectivity to heat sink, which is critical for proper operation drill and tap heatsink and mount PCB to heat sink using screws. SOLDER PASTE HEATSINK SOLDER FILLED VIA SCREW (2 PLS.) MOUNTING PROCEDURE PC BOARD