AM-162 MA-COM | Alldatasheet
Document overview
- Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
- PDF pages: 3
Technical content
Features
- 1.1 dB Typical Low Noise Figure @ 50 MHz
- +15 dBm Typical High Output Power @ 50 MHz
- +32 dBm Typical Third Order Intercept @ 50 MHz
- Fully Hermetic Package (AM-162, AMS-162)
Description
M/A-COM’s AM-162 is a coupler feedback amplifier with high intercept and compression points. The use of coupler feedback minimizes noise figure and current in a high intercept amplifier. This amplifier is packaged in a TO-8-1 package, a surface mount package and a connectorized version. The ground plane on the PC board should be configured to remove heat from under the package. AM-162 are ideally suited for use where a high intercept, high reliability amplifier is required. TO-8-1 Pin No. Function Pin No. Function
1 RF OUT 3 RF IN
2 VDC 4 GND
Pin Configuration (For AMS-162) SF-1 Parameter Absolute Maximum Max. Input Power +10 dBm Vbias +15.75 V Operating Temperature -55°C to +85°C Storage Temperature -65°C to +125°C Absolute Maximum Ratings 1 1. Operation of this device above any one of these parameters may cause permanent damage. Outline Drawing: SMA Connectorized * ∗ Dimensions are inches (millimeters) ±0.015 (0.38) unless otherwise specified.
Visit www.macomtech.com for additional data sheets and product information. M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. Low Noise Amplifier, 12.5 dB Gain, 10 - 100 MHz Rev. V5 AM- / AMC- / AMS-162 ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions is considering for development. Performance is based on target specifications, simulated results, and/or prototype measurements. Commitment to develop is not guaranteed. PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology Solutions has under development. Performance is based on engineering tests. Specifications are typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available. Commitment to produce in volume is not guaranteed. Electrical Specifications: 2 TA = -55°C to +85°C Case Temperature Parameter Test Conditions Units Min. Typ. Max. Gain @+25oC dB 12.0 12.5 13.0 Frequency Response — dB — ±0.6 Gain Variation with Temperature — dB — — ±0.6 1 dB Compression Output Power dBm +13 — Noise Figure — dB 1.6 Reverse Transmission — dB — -15 -14 VSWR — Ratio 2.0:1 Output IP2 Two-Tone inputs up to 0 dBm dBm +40 — — Output IP3 Two-Tone inputs up to 0 dBm dBm +26 — — Vbias — VDC +14.5 +15.0 +15.5 Ibias Vbias = +15.0 VDC mA — 11 15 Power Dissipation @ +15 V Bias mW — 165 — Frequency
50 MHz
- All specifications apply when operated at +15 VDC, with 50 ohms source and load impedance. Frequency (MHz) S11 MAG/ANG S21 MAG/ANG S12 MAG/ANG S22 MAG/ANG 0.09/-159.2 0.09/-129.5 0.17 0.12/-117.7 0.17 0.13/-118.5 0.17 0.14/-120.3 0.16 0.14/-122.6 S-Parameter Data
Visit www.macomtech.com for additional data sheets and product information. M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. Low Noise Amplifier, 12.5 dB Gain, 10 - 100 MHz Rev. V5 AM- / AMC- / AMS-162 ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions is considering for development. Performance is based on target specifications, simulated results, and/or prototype measurements. Commitment to develop is not guaranteed. PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology Solutions has under development. Performance is based on engineering tests. Specifications are typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available. Commitment to produce in volume is not guaranteed. Typical Performance Curves
Ordering Information
AMC-162 SMA Connectorized AMS-162 PIN SF-1 The connectorized version is not RoHs compliant.