AM-AMC-182 MACOM | Alldatasheet
Document overview
- Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
- PDF pages: 3
Technical content
Features
n 28.5 dB Typical Gain n 2.7 dB Typical Low Noise
Description
M/A-COM’s AM -182 is a high gain feedback amplifier with high intercept and compression points. This amplifier is packaged in a TO-8 package. Due to the internal power dissipation the thermal rise should be minimized. The ground plane on the PC board should be configured to r e- move heat from under the package. AM -182 is ideally suited for use where a high intercept, high reliability amplifier is required. Cascadable Thin Film Amplifier, 28 dB Gain, 5 - 1000 MHz AM-/AMC-182 TO-8-1 C-32 Absolute Maximum Ratings 1 1. Operation of this device above any one of these parameters may cause permanent damage. Parameter Absolute Maximum Max Input Power +13 dBm Vbias +15.75 V Operating Temperature -55°C to +85°C Storage Temperature -65°C to +125°C V 3.00
Cascadable Thin Film Amplifier, 28 dB Gain, 5 - 1000 MHz AM-/AMC-182 Specifications subject to change without notice. n North America: Tel. (800) 366-2266 n Asia/Pacific: Tel.+81-44-844-8296, Fax +81-44-844-8298 n Europe: Tel. +44 (1344) 869 595, Fax+44 (1344) 300 020 Visit www.macom.com for additional data sheets and product information. V 3.00 Electrical Specifications 2,3 TA = -55°C to +85°C Case Temperature Parameter Test Conditions Frequency Units Min. Typ. Max. Gain @ +25°C 300 MHz dB 27.2 28.2 29.2 Frequency Response — 5 - 1000 MHz dB — — ±1.2 Gain Variation with Temperature — 5 - 1000 MHz dB — — ±1.2 1 dB Compression Output Power 5 - 1000 MHz dBm +9 — — Noise Figure — 5 - 1000 MHz dB — — 4.5 Reverse Transmission — 5 - 1000 MHz dB — -36 -32 VSWR — 5 - 1000 MHz Ratio — — 2.0:1 Output IP2 Two-tone inputs up to 0 dBm 5 - 1000 MHz dBm +28 — — Output IP3 Two-tone inputs up to 0 dBm 5 - 1000 MHz dBm +18 — — Ibias Vbias = +15.0 VDC — mA — 44 50 Power Dissipation @ +15V Bias — mW — 660 — 2. All specifications apply when operated at +15 VDC, with 50 ohms source and load impedance. 3. Heat Sinking: Operation at case temperature above 95°C is not recommended. Heat sinking adequate to dissipate 800 mW must be provided in use.
Cascadable Thin Film Amplifier, 28 dB Gain, 5 - 1000 MHz AM-/AMC-182 Specifications subject to change without notice. n North America: Tel. (800) 366-2266 n Asia/Pacific: Tel.+81-44-844-8296, Fax +81-44-844-8298 n Europe: Tel. +44 (1344) 869 595, Fax+44 (1344) 300 020 Visit www.macom.com for additional data sheets and product information. V 3.00 Typical Performance Curves Noise Figure
Ordering Information
Gain vs. Frequency VSWR vs. Frequency 5 10 20 100 200 500 700 950 1000 1050 Frequency (MHz) Output Power (dBm) 5 10 20 100 200 500 700 950 1000 1050 Frequency (MHz) Gain (dB) +85°C +25°C -55°C 1.0 1.4 1.8 2.2 5 10 20 100 200 500 700 950 1000 1050 Frequency (MHz) VSWR RF IN RF OUT 2.0 2.5 3.0 3.5 5 10 20 100 200 500 700 950 1000 1050 Frequency (MHz) Noise Figure (dB) +85°C +25°C 5 10 20 100 200 500 700 950 1000 1050 Frequency (MHz) Intercept (dBm) IP2 (f1+f2) IP3 IP2 (f1-f2)