AM-AMC-180 MACOM | Alldatasheet
Document overview
- Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
- PDF pages: 3
Technical content
Features
n +14 dBm Typical 1 dB Compression n 5 dB Typical Noise Figure n 1.4:1 Typical VSWR
Description
M/A-COM’s AM -180 is a feedb ack amplifier with high intercept and compression points. This amplifier is packaged in a TO -8 package. Due to the internal p ower dissipation the thermal rise should be minimized. The ground plane on the PC board should be configured to remove heat f rom under the package. AM -180 is ideally suited for use where a high intercept, high reliability amplifier is required. Cascadable Thin Film Amplifier, 10 dB Gain, 10 - 2000 MHz AM-/AMC-180 TO-8-1 C-32 Absolute Maximum Ratings 1 1. Operation of this device above any one of these parameters may cause permanent damage. Parameter Absolute Maximum Max Input Power +10 dBm Vbias +15.75 V Operating Temperature -55°C to +85°C Storage Temperature -65°C to +125°C V 3.00
Cascadable Thin Film Amplifier, 10 dB Gain, 10 - 2000 MHz AM-/AMC-180 Specifications subject to change without notice. n North America: Tel. (800) 366-2266 n Asia/Pacific: Tel.+81-44-844-8296, Fax +81-44-844-8298 n Europe: Tel. +44 (1344) 869 595, Fax+44 (1344) 300 020 Visit www.macom.com for additional data sheets and product information. V 3.00 Electrical Specifications 2,3 TA = -55°C to +85°C Case Temperature Parameter Test Conditions Frequency Units Min. Typ. Max. Gain @ +25°C 1000 MHz dB 8.7 9.7 10.7 Frequency Response — 10-2000 MHz dB — — ±1.0 Gain Variation with Temperature — 10-2000 MHz dB — — ±1.0 1 dB Compression Output Power 10-2000 MHz dBm +13 — — Noise Figure — 10-2000 MHz dB — — 7.0 Reverse Transmission — 10-2000 MHz dB — -14 -12 VSWR — 10-2000 MHz Ratio — — 2:1 Output IP2 Two-tone inputs up to 0 dBm 10-2000 MHz dBm +39 — — Output IP3 Two-tone inputs up to 0 dBm 10-2000 MHz dBm +25 — — Ibias Vbias = +15.0 VDC — mA — 45 50 Power Dissipation @ +15V Bias — mW — 680 — 2. All specifications apply when operated at +15 VDC, with 50 ohms source and load impedance. 3. Heat Sinking: Operation at case temperature above 95°C is not recommended. Heat sinking adequate to dissipate 800 mW must be provided in use. S-Parameter Data S11 S21 S12 S22 MAG ANG MAG ANG MAG ANG MAG ANG Frequency (MHz)
Cascadable Thin Film Amplifier, 10 dB Gain, 10 - 2000 MHz AM-/AMC-180 Specifications subject to change without notice. n North America: Tel. (800) 366-2266 n Asia/Pacific: Tel.+81-44-844-8296, Fax +81-44-844-8298 n Europe: Tel. +44 (1344) 869 595, Fax+44 (1344) 300 020 Visit www.macom.com for additional data sheets and product information. V 3.00 Typical Performance Curves Noise Figure
Ordering Information
Gain vs. Frequency VSWR vs. Frequency 5 10 50 100 300 500 750 100012501500175020002250 Frequency (MHz) Output Power (dBm) 5 10 50 100 300 500 750 1000 1250 1500 1750 2000 2250 Frequency (MHz) Gain (dB) 85°C 25°C -55°C 1.0 1.2 1.4 1.6 1.8 2.0 5 10 50 100 300 500 750 1000 1250 1500 1750 2000 2250 Frequency (MHz) VSWR RF IN RF OUT 4.0 5.0 6.0 7.0 5 10 50 100 300 500 750 1000 1250 1500 1750 2000 Frequency (MHz) Noise Figure (dB) +85°C +25°C 5 10 50 100 300 500 750 10001250150017502000 Frequency (MHz) Intercept (dBm) IP2 (f1+f2) IP2 (f1-f2))IP3